From a20b1b791e42d84dedd5854b60abb841ec1a7585 Mon Sep 17 00:00:00 2001 From: Lee Jones Date: Wed, 15 May 2013 10:51:44 +0100 Subject: usb: musb: ux500: move the MUSB HDRC configuration into the driver The MUSB HDRC configuration never changes between each of the ux500 supported platforms, so there's little point passing it though platform data. If we set it in the driver instead, we can make good use of it when booting with either ATAGs or Device Tree. Cc: linux-usb@vger.kernel.org Acked-by: Felipe Balbi Acked-by: Fabio Baltieri Signed-off-by: Lee Jones Signed-off-by: Linus Walleij diff --git a/arch/arm/mach-ux500/usb.c b/arch/arm/mach-ux500/usb.c index a21c2e1..49d6e57 100644 --- a/arch/arm/mach-ux500/usb.c +++ b/arch/arm/mach-ux500/usb.c @@ -76,16 +76,8 @@ static struct ux500_musb_board_data musb_board_data = { static u64 ux500_musb_dmamask = DMA_BIT_MASK(32); -static struct musb_hdrc_config musb_hdrc_config = { - .multipoint = true, - .dyn_fifo = true, - .num_eps = 16, - .ram_bits = 16, -}; - static struct musb_hdrc_platform_data musb_platform_data = { .mode = MUSB_OTG, - .config = &musb_hdrc_config, .board_data = &musb_board_data, }; diff --git a/drivers/usb/musb/ux500.c b/drivers/usb/musb/ux500.c index 2c80004..371776f 100644 --- a/drivers/usb/musb/ux500.c +++ b/drivers/usb/musb/ux500.c @@ -30,6 +30,13 @@ #include "musb_core.h" +static struct musb_hdrc_config ux500_musb_hdrc_config = { + .multipoint = true, + .dyn_fifo = true, + .num_eps = 16, + .ram_bits = 16, +}; + struct ux500_glue { struct device *dev; struct platform_device *musb; @@ -229,6 +236,7 @@ static int ux500_probe(struct platform_device *pdev) glue->clk = clk; pdata->platform_ops = &ux500_ops; + pdata->config = &ux500_musb_hdrc_config; platform_set_drvdata(pdev, glue); -- cgit v0.10.2