From 269e4a4122685d0739f0e8e53b440111bf8a03f9 Mon Sep 17 00:00:00 2001 From: Mika Westerberg Date: Wed, 4 Sep 2013 13:37:43 +0300 Subject: spi/pxa2xx: check status register as well to determine if the device is off The current interrupt handler calls pm_runtime_suspended() to check if the device is suspended or not. However, runtime PM status of the device is only set to suspended once all PM runtime suspend hooks have executed. In case of Intel Lynxpoint we have the device bound to the ACPI power domain and its runtime suspend hook will put the device to D3hot (or D3cold if possible). This means that the device is powered off before its state is set to runtime suspended. While in this state the device might get an interrupt that is meant for another device (as the interrupt line is shared), and because the device is powered off accessing its registers will return 0xffffffff that the driver misinterprets as an invalid state. When this happens user will see messages like below on the console: pxa2xx-spi INT33C0:00: bad message state in interrupt handler Fix this by checking the status register for ~0 and returning IRQ_NONE in that case. Signed-off-by: Mika Westerberg Signed-off-by: Mark Brown diff --git a/drivers/spi/spi-pxa2xx.c b/drivers/spi/spi-pxa2xx.c index 2eb06ee..c1a5067 100644 --- a/drivers/spi/spi-pxa2xx.c +++ b/drivers/spi/spi-pxa2xx.c @@ -546,8 +546,17 @@ static irqreturn_t ssp_int(int irq, void *dev_id) if (pm_runtime_suspended(&drv_data->pdev->dev)) return IRQ_NONE; - sccr1_reg = read_SSCR1(reg); + /* + * If the device is not yet in RPM suspended state and we get an + * interrupt that is meant for another device, check if status bits + * are all set to one. That means that the device is already + * powered off. + */ status = read_SSSR(reg); + if (status == ~0) + return IRQ_NONE; + + sccr1_reg = read_SSCR1(reg); /* Ignore possible writes if we don't need to write */ if (!(sccr1_reg & SSCR1_TIE)) -- cgit v0.10.2 From 9b4003a687abcf2fe25ba9073dd07345e4529183 Mon Sep 17 00:00:00 2001 From: Axel Lin Date: Tue, 10 Sep 2013 10:19:29 +0800 Subject: spi: clps711x: Don't call kfree() after spi_master_put/spi_unregister_master Calling kfree() to clean up the memory obtained from spi_alloc_master() is wrong as this is done in spi_master_release() when spi_master->dev's refcount reaches zero. Signed-off-by: Axel Lin Signed-off-by: Mark Brown diff --git a/drivers/spi/spi-clps711x.c b/drivers/spi/spi-clps711x.c index 5655acf..b597a92 100644 --- a/drivers/spi/spi-clps711x.c +++ b/drivers/spi/spi-clps711x.c @@ -247,7 +247,6 @@ err_out: gpio_free(hw->chipselect[i]); spi_master_put(master); - kfree(master); return ret; } @@ -263,7 +262,6 @@ static int spi_clps711x_remove(struct platform_device *pdev) gpio_free(hw->chipselect[i]); spi_unregister_master(master); - kfree(master); return 0; } -- cgit v0.10.2 From eadf69cf5e1cdd042fb7b7beeffa538a935373cd Mon Sep 17 00:00:00 2001 From: Wei Yongjun Date: Wed, 11 Sep 2013 19:15:39 +0800 Subject: spi: mpc512x: fix error return code in mpc512x_psc_spi_do_probe() Fix to return a negative error code from the error handling case instead of 0, as done elsewhere in this function. Signed-off-by: Wei Yongjun Signed-off-by: Mark Brown diff --git a/drivers/spi/spi-mpc512x-psc.c b/drivers/spi/spi-mpc512x-psc.c index dbc5e99..6adf4e3 100644 --- a/drivers/spi/spi-mpc512x-psc.c +++ b/drivers/spi/spi-mpc512x-psc.c @@ -522,8 +522,10 @@ static int mpc512x_psc_spi_do_probe(struct device *dev, u32 regaddr, psc_num = master->bus_num; snprintf(clk_name, sizeof(clk_name), "psc%d_mclk", psc_num); clk = devm_clk_get(dev, clk_name); - if (IS_ERR(clk)) + if (IS_ERR(clk)) { + ret = PTR_ERR(clk); goto free_irq; + } ret = clk_prepare_enable(clk); if (ret) goto free_irq; -- cgit v0.10.2 From 272bfbd54f29b9361b09dbd6b25ccbd1a30163f1 Mon Sep 17 00:00:00 2001 From: Wei Yongjun Date: Wed, 11 Sep 2013 19:15:08 +0800 Subject: spi: fix return value check in dspi_probe() In case of error, the function devm_ioremap_resource() returns ERR_PTR() and never returns NULL. The NULL test in the return value check should be replaced with IS_ERR(). Signed-off-by: Wei Yongjun Signed-off-by: Mark Brown diff --git a/drivers/spi/spi-fsl-dspi.c b/drivers/spi/spi-fsl-dspi.c index 6cd07d1..4e44575 100644 --- a/drivers/spi/spi-fsl-dspi.c +++ b/drivers/spi/spi-fsl-dspi.c @@ -476,15 +476,9 @@ static int dspi_probe(struct platform_device *pdev) master->bus_num = bus_num; res = platform_get_resource(pdev, IORESOURCE_MEM, 0); - if (!res) { - dev_err(&pdev->dev, "can't get platform resource\n"); - ret = -EINVAL; - goto out_master_put; - } - dspi->base = devm_ioremap_resource(&pdev->dev, res); - if (!dspi->base) { - ret = -EINVAL; + if (IS_ERR(dspi->base)) { + ret = PTR_ERR(dspi->base); goto out_master_put; } -- cgit v0.10.2 From 0158026ccced1ae312233a6a46dc0b6edce3fb6c Mon Sep 17 00:00:00 2001 From: Wei Yongjun Date: Fri, 27 Sep 2013 16:21:30 +0800 Subject: spi/clps711x: drop clk_put for devm_clk_get in spi_clps711x_probe() devm_clk_get() is used so there is no reason to explicitly call clk_put() in probe or remove functions. Signed-off-by: Wei Yongjun Signed-off-by: Mark Brown diff --git a/drivers/spi/spi-clps711x.c b/drivers/spi/spi-clps711x.c index b597a92..6416798 100644 --- a/drivers/spi/spi-clps711x.c +++ b/drivers/spi/spi-clps711x.c @@ -226,7 +226,6 @@ static int spi_clps711x_probe(struct platform_device *pdev) dev_name(&pdev->dev), hw); if (ret) { dev_err(&pdev->dev, "Can't request IRQ\n"); - clk_put(hw->spi_clk); goto clk_out; } -- cgit v0.10.2 From 3e2bd64d243ff0f3dc08c49ff218fed42ee9d981 Mon Sep 17 00:00:00 2001 From: Mark Brown Date: Fri, 27 Sep 2013 11:52:35 +0100 Subject: spi/s3c64xx: Ensure runtime PM is enabled prior to registration Otherwise we may try to start transfers immediately and then fail to runtime resume the device causing us not to have clocks enabled. Signed-off-by: Mark Brown Reviewed-by: Sylwester Nawrocki Conflicts: drivers/spi/spi-s3c64xx.c diff --git a/drivers/spi/spi-s3c64xx.c b/drivers/spi/spi-s3c64xx.c index 512b889..a80376d 100644 --- a/drivers/spi/spi-s3c64xx.c +++ b/drivers/spi/spi-s3c64xx.c @@ -1428,6 +1428,8 @@ static int s3c64xx_spi_probe(struct platform_device *pdev) S3C64XX_SPI_INT_TX_OVERRUN_EN | S3C64XX_SPI_INT_TX_UNDERRUN_EN, sdd->regs + S3C64XX_SPI_INT_EN); + pm_runtime_enable(&pdev->dev); + if (spi_register_master(master)) { dev_err(&pdev->dev, "cannot register SPI master\n"); ret = -EBUSY; @@ -1440,8 +1442,6 @@ static int s3c64xx_spi_probe(struct platform_device *pdev) mem_res, sdd->rx_dma.dmach, sdd->tx_dma.dmach); - pm_runtime_enable(&pdev->dev); - return 0; err3: -- cgit v0.10.2 From 268d76430d1b68c340687357ffd18b4b12d02269 Mon Sep 17 00:00:00 2001 From: Kuninori Morimoto Date: Thu, 3 Oct 2013 02:15:50 -0700 Subject: spi/hspi: fixup Runtime PM enable timing 3e00a09d2fbd64f0ad98e7c8c29dbf9e038fc746 (spi/hspi: Convert to core runtime PM) enabled master->auto_runtime_pm. Then, pm_runtime_enable() is required *before* spi_register_master() calling. This patch fixed it up. Kernel will hang up with "spi_master spi0: Failed to power device: -13" message without this patch. Signed-off-by: Kuninori Morimoto Signed-off-by: Mark Brown diff --git a/drivers/spi/spi-sh-hspi.c b/drivers/spi/spi-sh-hspi.c index 0b68cb5..e488a90 100644 --- a/drivers/spi/spi-sh-hspi.c +++ b/drivers/spi/spi-sh-hspi.c @@ -296,6 +296,8 @@ static int hspi_probe(struct platform_device *pdev) goto error1; } + pm_runtime_enable(&pdev->dev); + master->num_chipselect = 1; master->bus_num = pdev->id; master->setup = hspi_setup; @@ -309,8 +311,6 @@ static int hspi_probe(struct platform_device *pdev) goto error1; } - pm_runtime_enable(&pdev->dev); - return 0; error1: -- cgit v0.10.2 From de8cc234a517b61c9a8450a34408dbae53aa171f Mon Sep 17 00:00:00 2001 From: Sachin Kamat Date: Tue, 10 Sep 2013 17:06:26 +0530 Subject: spi: atmel: Fix incorrect error path 'irq' was not released when clk_prepare_enable failed. Fix it. Signed-off-by: Sachin Kamat Acked-by: Nicolas Ferre Signed-off-by: Mark Brown diff --git a/drivers/spi/spi-atmel.c b/drivers/spi/spi-atmel.c index fd7cc56..d4ac60b 100644 --- a/drivers/spi/spi-atmel.c +++ b/drivers/spi/spi-atmel.c @@ -1583,7 +1583,7 @@ static int atmel_spi_probe(struct platform_device *pdev) /* Initialize the hardware */ ret = clk_prepare_enable(clk); if (ret) - goto out_unmap_regs; + goto out_free_irq; spi_writel(as, CR, SPI_BIT(SWRST)); spi_writel(as, CR, SPI_BIT(SWRST)); /* AT91SAM9263 Rev B workaround */ if (as->caps.has_wdrbt) { @@ -1614,6 +1614,7 @@ out_free_dma: spi_writel(as, CR, SPI_BIT(SWRST)); spi_writel(as, CR, SPI_BIT(SWRST)); /* AT91SAM9263 Rev B workaround */ clk_disable_unprepare(clk); +out_free_irq: free_irq(irq, master); out_unmap_regs: iounmap(as->regs); -- cgit v0.10.2