diff options
Diffstat (limited to 'Documentation/devicetree/bindings/display/ssd1307fb.txt')
-rw-r--r-- | Documentation/devicetree/bindings/display/ssd1307fb.txt | 49 |
1 files changed, 49 insertions, 0 deletions
diff --git a/Documentation/devicetree/bindings/display/ssd1307fb.txt b/Documentation/devicetree/bindings/display/ssd1307fb.txt new file mode 100644 index 0000000..d1be78d --- /dev/null +++ b/Documentation/devicetree/bindings/display/ssd1307fb.txt @@ -0,0 +1,49 @@ +* Solomon SSD1307 Framebuffer Driver + +Required properties: + - compatible: Should be "solomon,<chip>fb-<bus>". The only supported bus for + now is i2c, and the supported chips are ssd1305, ssd1306 and ssd1307. + - reg: Should contain address of the controller on the I2C bus. Most likely + 0x3c or 0x3d + - pwm: Should contain the pwm to use according to the OF device tree PWM + specification [0]. Only required for the ssd1307. + - reset-gpios: Should contain the GPIO used to reset the OLED display + - solomon,height: Height in pixel of the screen driven by the controller + - solomon,width: Width in pixel of the screen driven by the controller + - solomon,page-offset: Offset of pages (band of 8 pixels) that the screen is + mapped to. + +Optional properties: + - reset-active-low: Is the reset gpio is active on physical low? + - solomon,segment-no-remap: Display needs normal (non-inverted) data column + to segment mapping + - solomon,com-seq: Display uses sequential COM pin configuration + - solomon,com-lrremap: Display uses left-right COM pin remap + - solomon,com-invdir: Display uses inverted COM pin scan direction + - solomon,com-offset: Number of the COM pin wired to the first display line + - solomon,prechargep1: Length of deselect period (phase 1) in clock cycles. + - solomon,prechargep2: Length of precharge period (phase 2) in clock cycles. + This needs to be the higher, the higher the capacitance + of the OLED's pixels is + +[0]: Documentation/devicetree/bindings/pwm/pwm.txt + +Examples: +ssd1307: oled@3c { + compatible = "solomon,ssd1307fb-i2c"; + reg = <0x3c>; + pwms = <&pwm 4 3000>; + reset-gpios = <&gpio2 7>; + reset-active-low; +}; + +ssd1306: oled@3c { + compatible = "solomon,ssd1306fb-i2c"; + reg = <0x3c>; + pwms = <&pwm 4 3000>; + reset-gpios = <&gpio2 7>; + reset-active-low; + solomon,com-lrremap; + solomon,com-invdir; + solomon,com-offset = <32>; +}; |