diff options
Diffstat (limited to 'Documentation/networking')
-rw-r--r-- | Documentation/networking/batman-adv.txt | 11 |
1 files changed, 6 insertions, 5 deletions
diff --git a/Documentation/networking/batman-adv.txt b/Documentation/networking/batman-adv.txt index 18afcd8..713f7c0 100644 --- a/Documentation/networking/batman-adv.txt +++ b/Documentation/networking/batman-adv.txt @@ -1,4 +1,4 @@ -[state: 27-01-2011] +[state: 17-04-2011] BATMAN-ADV ---------- @@ -19,6 +19,7 @@ duce the overhead to a minimum. It does not depend on any (other) network driver, and can be used on wifi as well as ethernet lan, vpn, etc ... (anything with ethernet-style layer 2). + CONFIGURATION ------------- @@ -160,13 +161,13 @@ face. Each entry can/has to have the following values: -> "TQ mac value" - src mac's link quality towards mac address of a neighbor originator's interface which is being used for routing --> "HNA mac" - HNA announced by source mac +-> "TT mac" - TT announced by source mac -> "PRIMARY" - this is a primary interface -> "SEC mac" - secondary mac address of source (requires preceding PRIMARY) The TQ value has a range from 4 to 255 with 255 being the best. -The HNA entries are showing which hosts are connected to the mesh +The TT entries are showing which hosts are connected to the mesh via bat0 or being bridged into the mesh network. The PRIMARY/SEC values are only applied on primary interfaces @@ -199,7 +200,7 @@ abled during run time. Following log_levels are defined: 0 - All debug output disabled 1 - Enable messages related to routing / flooding / broadcasting -2 - Enable route or hna added / changed / deleted +2 - Enable route or tt entry added / changed / deleted 3 - Enable all messages The debug output can be changed at runtime using the file @@ -207,7 +208,7 @@ The debug output can be changed at runtime using the file # echo 2 > /sys/class/net/bat0/mesh/log_level -will enable debug messages for when routes or HNAs change. +will enable debug messages for when routes or TTs change. BATCTL |