From c240f29e75e686baa5b5ddc801e70022dd6bf358 Mon Sep 17 00:00:00 2001
From: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Date: Fri, 11 Dec 2015 18:13:12 +0000
Subject: arm64: dts: set the default i2c pin drive strength to 16mA

2mA drive strength is not enough when we connect multiple i2c devices
on the bus with different pull up resistors.

This issue was detected when multiple i2c devices connected on the other side
of level shifters on Linaro sensor board. Maxing up to 16mA made i2c much stable.

Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Signed-off-by: Andy Gross <andy.gross@linaro.org>

diff --git a/arch/arm64/boot/dts/qcom/msm8916-pins.dtsi b/arch/arm64/boot/dts/qcom/msm8916-pins.dtsi
index d656e89..955c6f1 100644
--- a/arch/arm64/boot/dts/qcom/msm8916-pins.dtsi
+++ b/arch/arm64/boot/dts/qcom/msm8916-pins.dtsi
@@ -277,7 +277,7 @@
 		};
 		pinconf {
 			pins = "gpio6", "gpio7";
-			drive-strength = <2>;
+			drive-strength = <16>;
 			bias-disable = <0>;
 		};
 	};
@@ -301,7 +301,7 @@
 		};
 		pinconf {
 			pins = "gpio14", "gpio15";
-			drive-strength = <2>;
+			drive-strength = <16>;
 			bias-disable = <0>;
 		};
 	};
@@ -325,7 +325,7 @@
 		};
 		pinconf {
 			pins = "gpio22", "gpio23";
-			drive-strength = <2>;
+			drive-strength = <16>;
 			bias-disable = <0>;
 		};
 	};
-- 
cgit v0.10.2