From 93a35141826a67b781cd3a4179577eed188cc321 Mon Sep 17 00:00:00 2001
From: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Date: Thu, 28 Jan 2016 17:43:30 +0000
Subject: arm64: dts: qcom: add correct drive strenght on cs pins

2mA drive strenght is not enough to drive chipselect low on hardware
configurations with level shifters, 16mA should give good range to
allow such configurations to work.

This issue was noticed while testing spi on db410c with sensor board.

Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Signed-off-by: Andy Gross <andy.gross@linaro.org>

diff --git a/arch/arm64/boot/dts/qcom/msm8916-pins.dtsi b/arch/arm64/boot/dts/qcom/msm8916-pins.dtsi
index 3bd917e..c17cd8b 100644
--- a/arch/arm64/boot/dts/qcom/msm8916-pins.dtsi
+++ b/arch/arm64/boot/dts/qcom/msm8916-pins.dtsi
@@ -82,7 +82,7 @@
 		};
 		pinconf_cs {
 			pins = "gpio2";
-			drive-strength = <2>;
+			drive-strength = <16>;
 			bias-disable;
 			output-high;
 		};
@@ -116,7 +116,7 @@
 		};
 		pinconf_cs {
 			pins = "gpio6";
-			drive-strength = <2>;
+			drive-strength = <16>;
 			bias-disable;
 			output-high;
 		};
@@ -150,7 +150,7 @@
 		};
 		pinconf_cs {
 			pins = "gpio10";
-			drive-strength = <2>;
+			drive-strength = <16>;
 			bias-disable;
 			output-high;
 		};
@@ -184,7 +184,7 @@
 		};
 		pinconf_cs {
 			pins = "gpio14";
-			drive-strength = <2>;
+			drive-strength = <16>;
 			bias-disable;
 			output-high;
 		};
@@ -218,7 +218,7 @@
 		};
 		pinconf_cs {
 			pins = "gpio18";
-			drive-strength = <2>;
+			drive-strength = <16>;
 			bias-disable;
 			output-high;
 		};
@@ -252,7 +252,7 @@
 		};
 		pinconf_cs {
 			pins = "gpio22";
-			drive-strength = <2>;
+			drive-strength = <16>;
 			bias-disable;
 			output-high;
 		};
-- 
cgit v0.10.2