From 73afa6c4208257ea1733a03918fea731a18131e7 Mon Sep 17 00:00:00 2001 From: John Crispin Date: Thu, 5 Nov 2015 03:59:58 +0100 Subject: MIPS: ralink: Add tty detection MT7688 has several uarts that can be used for console. There are several boards in the wild, that use ttyS1 or ttyS2. This patch applies a simply autodetection routine to figure out which ttyS the bootloader used as console. The uarts come up in 6 bit mode by default. The bootloader will have set 8 bit mode on the console. Find that 8bit tty and use it. Signed-off-by: John Crispin Cc: linux-mips@linux-mips.org Patchwork: https://patchwork.linux-mips.org/patch/11459/ Signed-off-by: Ralf Baechle diff --git a/arch/mips/ralink/early_printk.c b/arch/mips/ralink/early_printk.c index 255d695..3c59ffe 100644 --- a/arch/mips/ralink/early_printk.c +++ b/arch/mips/ralink/early_printk.c @@ -25,11 +25,13 @@ #define MT7628_CHIP_NAME1 0x20203832 #define UART_REG_TX 0x04 +#define UART_REG_LCR 0x0c #define UART_REG_LSR 0x14 #define UART_REG_LSR_RT2880 0x1c static __iomem void *uart_membase = (__iomem void *) KSEG1ADDR(EARLY_UART_BASE); static __iomem void *chipid_membase = (__iomem void *) KSEG1ADDR(CHIPID_BASE); +static int init_complete; static inline void uart_w32(u32 val, unsigned reg) { @@ -47,8 +49,32 @@ static inline int soc_is_mt7628(void) (__raw_readl(chipid_membase) == MT7628_CHIP_NAME1); } +static void find_uart_base(void) +{ + int i; + + if (!soc_is_mt7628()) + return; + + for (i = 0; i < 3; i++) { + u32 reg = uart_r32(UART_REG_LCR + (0x100 * i)); + + if (!reg) + continue; + + uart_membase = (__iomem void *) KSEG1ADDR(EARLY_UART_BASE + + (0x100 * i)); + break; + } +} + void prom_putchar(unsigned char ch) { + if (!init_complete) { + find_uart_base(); + init_complete = 1; + } + if (IS_ENABLED(CONFIG_SOC_MT7621) || soc_is_mt7628()) { uart_w32(ch, UART_TX); while ((uart_r32(UART_REG_LSR) & UART_LSR_THRE) == 0) -- cgit v0.10.2