From beb9d007a846e661cfaa7719cab6b004b3380418 Mon Sep 17 00:00:00 2001 From: Antonio Borneo Date: Sun, 29 Jun 2014 14:13:48 +0800 Subject: HID: cp2112: fix gpio value in gpio_direction_output CP2112 does not offer an atomic method to set both gpio direction and value. Also it does not permit to set gpio value before putting gpio in output. In fact, accordingly to Silicon Labs AN495, Rev. 0.2, cpt. 4.4, the HID report to set gpio values "does not affect any pins that are not configured as outputs". This is confirmed on evaluation board CP2112-EK. With current driver, after execute: echo in > /sys/class/gpio/gpio248/direction echo low > /sys/class/gpio/gpio248/direction gpio output is still high. Only after a following echo low > /sys/class/gpio/gpio248/direction gpio output gets low. Fix driver by changing order of operations; first set direction then set value. The drawback of this new sequence is that we can have a pulse on gpio pin when direction is changed from input to output-low, but this cannot be avoided on current CP2112. Signed-off-by: Antonio Borneo Reviewed-by: Benjamin Tissoires Signed-off-by: Jiri Kosina diff --git a/drivers/hid/hid-cp2112.c b/drivers/hid/hid-cp2112.c index 56be85a..3952d90 100644 --- a/drivers/hid/hid-cp2112.c +++ b/drivers/hid/hid-cp2112.c @@ -240,8 +240,6 @@ static int cp2112_gpio_direction_output(struct gpio_chip *chip, u8 buf[5]; int ret; - cp2112_gpio_set(chip, offset, value); - ret = hid_hw_raw_request(hdev, CP2112_GPIO_CONFIG, buf, sizeof(buf), HID_FEATURE_REPORT, HID_REQ_GET_REPORT); @@ -260,6 +258,12 @@ static int cp2112_gpio_direction_output(struct gpio_chip *chip, return ret; } + /* + * Set gpio value when output direction is already set, + * as specified in AN495, Rev. 0.2, cpt. 4.4 + */ + cp2112_gpio_set(chip, offset, value); + return 0; } -- cgit v0.10.2