From 9cb0a36e0e894d7c6de9a21ed23256cf61a44878 Mon Sep 17 00:00:00 2001 From: Nicolas Ferre Date: Thu, 4 Dec 2014 14:59:24 +0100 Subject: rtc: at91/Kconfig: remove useless options As we removed all the !DT boards during 3.19 cycle, we can now remove these options. Reported-by: Paul Bolle Signed-off-by: Nicolas Ferre diff --git a/drivers/rtc/Kconfig b/drivers/rtc/Kconfig index f15cddf..f211dfb 100644 --- a/drivers/rtc/Kconfig +++ b/drivers/rtc/Kconfig @@ -1141,34 +1141,6 @@ config RTC_DRV_AT91SAM9 probably want to use the real RTC block instead of the "RTT as an RTC" driver. -config RTC_DRV_AT91SAM9_RTT - int - range 0 1 - default 0 - depends on RTC_DRV_AT91SAM9 - help - This option is only relevant for legacy board support and - won't be used when booting a DT board. - - More than one RTT module is available. You can choose which - one will be used as an RTC. The default of zero is normally - OK to use, though some systems use that for non-RTC purposes. - -config RTC_DRV_AT91SAM9_GPBR - int - range 0 3 - default 0 - prompt "Backup Register Number" - depends on RTC_DRV_AT91SAM9 - help - This option is only relevant for legacy board support and - won't be used when booting a DT board. - - The RTC driver needs to use one of the General Purpose Backup - Registers (GPBRs) as well as the RTT. You can choose which one - will be used. The default of zero is normally OK to use, but - on some systems other software needs to use that register. - config RTC_DRV_AU1XXX tristate "Au1xxx Counter0 RTC support" depends on MIPS_ALCHEMY -- cgit v0.10.2