From f9a9111b540fd67db5dab332f4b83d86c90e27b1 Mon Sep 17 00:00:00 2001 From: Christian Melki Date: Mon, 30 Apr 2012 11:21:26 +0200 Subject: 8250.c: less than 2400 baud fix. We noticed that we were loosing data at speed less than 2400 baud. It turned out our (TI16750 compatible) uart with 64 byte outgoing fifo was truncated to 16 byte (bit 5 sets fifo len) when modifying the fcr reg. The input code still fills the buffer with 64 bytes if I remember correctly and thus data is lost. Our fix was to remove whiping of the fcr content and just add the TRIGGER_1 which we want for latency. I can't see why this would not work on less than 2400 always, for all uarts ... Otherwise one would have to make sure the filling of the fifo re-checks the current state of available fifo size (urrk). Signed-off-by: Christian Melki Cc: stable Signed-off-by: Greg Kroah-Hartman diff --git a/drivers/tty/serial/8250/8250.c b/drivers/tty/serial/8250/8250.c index 182efcc9..c9ac4ea 100644 --- a/drivers/tty/serial/8250/8250.c +++ b/drivers/tty/serial/8250/8250.c @@ -2259,10 +2259,11 @@ serial8250_do_set_termios(struct uart_port *port, struct ktermios *termios, quot++; if (up->capabilities & UART_CAP_FIFO && port->fifosize > 1) { - if (baud < 2400) - fcr = UART_FCR_ENABLE_FIFO | UART_FCR_TRIGGER_1; - else - fcr = uart_config[port->type].fcr; + fcr = uart_config[port->type].fcr; + if (baud < 2400) { + fcr &= ~UART_FCR_TRIGGER_MASK; + fcr |= UART_FCR_TRIGGER_1; + } } /* -- cgit v0.10.2