From 3893b27345ac0ff13c1b9ec20ad50966b810997e Mon Sep 17 00:00:00 2001 From: Sergei Shtylyov Date: Sun, 31 Mar 2013 09:54:20 +0000 Subject: sh_eth: workaround for spurious ECI interrupt At least on Renesas R8A7778, EESR.ECI interrupt seems to fire regardless of its mask in EESIPR register. I can 100% reproduce it with the following scenario: target is booted with 'ip=on' option, and so IP-Config opens SoC Ether device but doesn't get a proper reply and then succeeds with on-board SMC chip; then I login and try to bring up the SoC Ether device with 'ifconfig', and I get an ECI interrupt once request_irq() is called by sh_eth_open() (while interrupt mask in EESIPR register is all 0), if that interrupt is accompanied by a pending EESR.FRC (frame receive completion) interrupt, I get kernel oops in sh_eth_rx() because sh_eth_ring_init() hasn't been called yet! The solution I worked out is the following: in sh_eth_interrupt(), mask the interrupt status from EESR register with the interrupt mask from EESIPR register in order not to handle the disabled interrupts -- but forcing EESIPR.M_ECI bit in this mask set because we always need to fully handle EESR.ECI interrupt in sh_eth_error() in order to quench it (as it doesn't get cleared by just writing 1 to the this bit as all the other interrupts). While at it, remove unneeded initializer for 'intr_status' variable and give it *unsigned long* type, matching the type of sh_eth_read()'s result; fix comment. Signed-off-by: Sergei Shtylyov Reviewed-by: Max Filippov Signed-off-by: David S. Miller diff --git a/drivers/net/ethernet/renesas/sh_eth.c b/drivers/net/ethernet/renesas/sh_eth.c index 1ca8b2b..44f7904 100644 --- a/drivers/net/ethernet/renesas/sh_eth.c +++ b/drivers/net/ethernet/renesas/sh_eth.c @@ -1324,12 +1324,18 @@ static irqreturn_t sh_eth_interrupt(int irq, void *netdev) struct sh_eth_private *mdp = netdev_priv(ndev); struct sh_eth_cpu_data *cd = mdp->cd; irqreturn_t ret = IRQ_NONE; - u32 intr_status = 0; + unsigned long intr_status; spin_lock(&mdp->lock); - /* Get interrpt stat */ + /* Get interrupt status */ intr_status = sh_eth_read(ndev, EESR); + /* Mask it with the interrupt mask, forcing ECI interrupt to be always + * enabled since it's the one that comes thru regardless of the mask, + * and we need to fully handle it in sh_eth_error() in order to quench + * it as it doesn't get cleared by just writing 1 to the ECI bit... + */ + intr_status &= sh_eth_read(ndev, EESIPR) | DMAC_M_ECI; /* Clear interrupt */ if (intr_status & (EESR_FRC | EESR_RMAF | EESR_RRF | EESR_RTLF | EESR_RTSF | EESR_PRE | EESR_CERF | -- cgit v0.10.2