From c91799c50a14137ecee6d60d2f1d9ab8bc895e52 Mon Sep 17 00:00:00 2001 From: Alexander Aring Date: Fri, 27 Feb 2015 09:58:30 +0100 Subject: at86rf230: add warning if edge-triggered irq While testing I experience a deadlock while using the at86rf233 on a raspberry pi. The reason was an edge triggered gpio irq because the irq triggered while irq was disabled. This issue doesn't happend on a level triggered irq because the irq will hit after calling enable_irq. This patch adds a warning that it's not recommended to use a edge-triggered irq type. Also change the examples to high-level irqtype. Signed-off-by: Alexander Aring Signed-off-by: Marcel Holtmann diff --git a/Documentation/devicetree/bindings/net/ieee802154/at86rf230.txt b/Documentation/devicetree/bindings/net/ieee802154/at86rf230.txt index 1ae5100..168f1be 100644 --- a/Documentation/devicetree/bindings/net/ieee802154/at86rf230.txt +++ b/Documentation/devicetree/bindings/net/ieee802154/at86rf230.txt @@ -6,7 +6,8 @@ Required properties: - spi-max-frequency: maximal bus speed, should be set to 7500000 depends sync or async operation mode - reg: the chipselect index - - interrupts: the interrupt generated by the device + - interrupts: the interrupt generated by the device. Non high-level + can occur deadlocks while handling isr. Optional properties: - reset-gpio: GPIO spec for the rstn pin @@ -20,7 +21,7 @@ Example: compatible = "atmel,at86rf231"; spi-max-frequency = <7500000>; reg = <0>; - interrupts = <19 1>; + interrupts = <19 4>; interrupt-parent = <&gpio3>; xtal-trim = /bits/ 8 <0x06>; }; diff --git a/drivers/net/ieee802154/at86rf230.c b/drivers/net/ieee802154/at86rf230.c index c7a30ce..1d438bc 100644 --- a/drivers/net/ieee802154/at86rf230.c +++ b/drivers/net/ieee802154/at86rf230.c @@ -1321,6 +1321,10 @@ static int at86rf230_hw_init(struct at86rf230_local *lp, u8 xtal_trim) return rc; irq_type = irq_get_trigger_type(lp->spi->irq); + if (irq_type == IRQ_TYPE_EDGE_RISING || + irq_type == IRQ_TYPE_EDGE_FALLING) + dev_warn(&lp->spi->dev, + "Using edge triggered irq's are not recommended!\n"); if (irq_type == IRQ_TYPE_EDGE_FALLING || irq_type == IRQ_TYPE_LEVEL_LOW) irq_pol = IRQ_ACTIVE_LOW; -- cgit v0.10.2