From 3f5e2e2a7db13dda7b656bbddda10b9cd0d2c871 Mon Sep 17 00:00:00 2001 From: Fabio Estevam Date: Fri, 3 May 2013 15:07:58 -0300 Subject: README: mx28_common: Do not hardcode the SSP port MX28 can boot from SSP0 or SSP1, so it is better not to hardcode the SSP port in the instructions. Signed-off-by: Fabio Estevam diff --git a/doc/README.mx28_common b/doc/README.mx28_common index ac82419..bba2440 100644 --- a/doc/README.mx28_common +++ b/doc/README.mx28_common @@ -100,9 +100,7 @@ discussed in the following chapters. ----------------------------------------------------------- To boot a MX28 based board from SD, set the boot mode DIP switches according -to i.MX28 manual chapter 12.2.1 (Table 12-2), PORT=SSP0, SD/MMC master on -SSP0, 3.3V. - +to i.MX28 manual chapter 12.2.1 (Table 12-2). An SD card the i.MX28 CPU can use to boot U-Boot must contain a DOS partition table, which in turn carries a partition of special type and which contains a -- cgit v0.10.2