From 29905a451b7ecf86785a4404e926fb14a8daced3 Mon Sep 17 00:00:00 2001 From: Stefan Roese Date: Mon, 29 Jun 2015 14:58:08 +0200 Subject: mmc: sdhci: Use timer based timeout detection in sdhci_send_command() The loop counter based timeout detection does not work on the Armada 38x based board (DB-88F6820-GP). At least with dcache enabled a timeout is detected. Without dcache enabled, the timeout does not occur. Increasing the loop counter solves this issue. But a better solution is to use a timer based timeout detection instead. This patch now implements this timer based detection. Signed-off-by: Stefan Roese Cc: Pantelis Antoniou Cc: Luka Perkov diff --git a/drivers/mmc/sdhci.c b/drivers/mmc/sdhci.c index 75556a3..f72536b 100644 --- a/drivers/mmc/sdhci.c +++ b/drivers/mmc/sdhci.c @@ -133,8 +133,8 @@ static int sdhci_send_command(struct mmc *mmc, struct mmc_cmd *cmd, int trans_bytes = 0, is_aligned = 1; u32 mask, flags, mode; unsigned int time = 0, start_addr = 0; - unsigned int retry = 10000; int mmc_dev = mmc->block_dev.dev; + unsigned start = get_timer(0); /* Timeout unit - ms */ static unsigned int cmd_timeout = CONFIG_SDHCI_CMD_DEFAULT_TIMEOUT; @@ -222,15 +222,15 @@ static int sdhci_send_command(struct mmc *mmc, struct mmc_cmd *cmd, flush_cache(start_addr, trans_bytes); #endif sdhci_writew(host, SDHCI_MAKE_CMD(cmd->cmdidx, flags), SDHCI_COMMAND); + start = get_timer(0); do { stat = sdhci_readl(host, SDHCI_INT_STATUS); if (stat & SDHCI_INT_ERROR) break; - if (--retry == 0) - break; - } while ((stat & mask) != mask); + } while (((stat & mask) != mask) && + (get_timer(start) < CONFIG_SDHCI_CMD_DEFAULT_TIMEOUT)); - if (retry == 0) { + if (get_timer(start) >= CONFIG_SDHCI_CMD_DEFAULT_TIMEOUT) { if (host->quirks & SDHCI_QUIRK_BROKEN_R1B) return 0; else { -- cgit v0.10.2