From 1262a85fe36936f404dc2deccc3ebaacebb612c5 Mon Sep 17 00:00:00 2001 From: Hans de Goede Date: Sat, 13 Dec 2014 14:12:06 +0100 Subject: sunxi: axp221: Make dcdc1 voltage configurable The dcdc1 voltage is typically used as generic 3.3V IO voltage for things like GPIO-s, sdcard interfaces, etc. On most boards this is undervolted to 3.0V to safe battery, but not on all, make it configurable so that we can use the same settings as the original firmware on all boards. Signed-off-by: Hans de Goede Acked-by: Ian Campbell diff --git a/board/sunxi/board.c b/board/sunxi/board.c index b5dfe95..e2ebf83 100644 --- a/board/sunxi/board.c +++ b/board/sunxi/board.c @@ -175,7 +175,7 @@ void sunxi_board_init(void) #endif #ifdef CONFIG_AXP221_POWER power_failed = axp221_init(); - power_failed |= axp221_set_dcdc1(3000); + power_failed |= axp221_set_dcdc1(CONFIG_AXP221_DCDC1_VOLT); power_failed |= axp221_set_dcdc2(1200); power_failed |= axp221_set_dcdc3(1200); power_failed |= axp221_set_dcdc4(1200); diff --git a/configs/Mele_M9_defconfig b/configs/Mele_M9_defconfig index 445cc57..e5ab0ec 100644 --- a/configs/Mele_M9_defconfig +++ b/configs/Mele_M9_defconfig @@ -7,6 +7,8 @@ CONFIG_FDTFILE="sun6i-a31-m9.dtb" +S:CONFIG_TARGET_MELE_M9=y +S:CONFIG_DRAM_CLK=312 +S:CONFIG_DRAM_ZQ=120 +# The Mele M9 uses 3.3V for general IO ++S:CONFIG_AXP221_DCDC1_VOLT=3300 # Ethernet phy power +S:CONFIG_AXP221_DLDO1_VOLT=3300 # USB hub power diff --git a/drivers/power/Kconfig b/drivers/power/Kconfig index af66887..e132759 100644 --- a/drivers/power/Kconfig +++ b/drivers/power/Kconfig @@ -6,6 +6,16 @@ config AXP221_POWER Say y here to enable support for the axp221 / axp223 pmic found on most sun6i (A31) / sun8i (A23) boards. +config AXP221_DCDC1_VOLT + int "axp221 dcdc1 voltage" + depends on AXP221_POWER + default 3000 + ---help--- + Set the voltage (mV) to program the axp221 dcdc1 at, set to 0 to + disable dcdc1. This is typically used as generic 3.3V IO voltage for + things like GPIO-s, sdcard interfaces, etc. On most boards this is + undervolted to 3.0V to safe battery. + config AXP221_DLDO1_VOLT int "axp221 dldo1 voltage" depends on AXP221_POWER -- cgit v0.10.2