diff options
Diffstat (limited to 'Documentation/devicetree/bindings/tdm/pq-mds-t1.txt')
-rw-r--r-- | Documentation/devicetree/bindings/tdm/pq-mds-t1.txt | 63 |
1 files changed, 63 insertions, 0 deletions
diff --git a/Documentation/devicetree/bindings/tdm/pq-mds-t1.txt b/Documentation/devicetree/bindings/tdm/pq-mds-t1.txt new file mode 100644 index 0000000..d5a9240 --- /dev/null +++ b/Documentation/devicetree/bindings/tdm/pq-mds-t1.txt @@ -0,0 +1,63 @@ +===================================================================== +FSL PQ_MDS_T1 Device Tree Binding +Copyright (C) 2012 Freescale Semiconductor Inc. + +===================================================================== +Introduction + +The PQ-MDS-T1 - A board card with the T1/E1/DS3/T3/SLIC-SLAC module + which serves as a platform for S/W and H/W development + around the host device, it is connected by PMC sockets. + +1.TDM PHY + Function : DS26528 T1/E1/J1 transceiver + +Properties + - compatible + Usage: required + Value type: <string> + Definition: Should be "fsl,pq-mds-t1". + - reg + Usage: required + Value type: <prop-encoded-array> + Definition: The first reg specifier describes the the address, + and the second describes the length. + - line-rate + Usage: required + Value type: <string> + Definition: It descrbets the line rate "e1" or "t1". "e1" is 2.048MHz + "t1" is 1.544MHz. + - fsl,trans-mode + Usage: required + Value type: <string> + Definition: TDM controller transfer mode setting + Normal operation: set fsl,trans-mode = "normal". In this mode, + controller sends and receives data normally. + Loopback operation: set fsl,trans-mode = "internal-loopback". + In this mode, the data is sent via tsa tx pin and + received from tsa rx pin. +Example + + ds26528: tdm-phy@0 { + compatible = "dallas,ds26528"; + reg = <0 0x2000>; + line-rate = "e1"; + fsl,trans-mode = "normal"; + }; + +2.PQ-MDS-T1 PLD + Function: Board identification, control and clock/signal routing + +Properties + - fsl,card-support + Usage: required + Value type: <u32> + Definition: This property use phandle to describe which it serves as, + ds26528 or zarlink. + +Example + pld-reg@2000 { + compatible = "fsl,pq-mds-t1-pld"; + reg = <0x2000 0x1000>; + fsl,card-support = <&ds26528>; + } |