summaryrefslogtreecommitdiff
path: root/drivers/mfd/rts5249.c
AgeCommit message (Collapse)Author
2013-10-23mfd: rtsx: Modify rts5249_optimize_phyWei WANG
In some platforms, specially Thinkpad series, rts5249 won't be initialized properly. So we need adjust some phy parameters to improve the compatibility issue. It is a little different between simulation and real chip. We have no idea about which configuration is better before tape-out. We set default settings according to simulation, but need to tune these parameters after getting the real chip. I can't explain every change in detail here. The below information is just a rough description: PHY_REG_REV: Disable internal clkreq_tx, enable rx_pwst PHY_BPCR: No change, just turn the magic number to macro definitions PHY_PCR: Change OOBS sensitivity, from 60mV to 90mV PHY_RCR2: Control charge-pump current automatically PHY_FLD4: Use TX cmu reference clock PHY_RDR: Change RXDSEL from 30nF to 1.9nF PHY_RCR1: Change the duration between adp_st and asserting cp_en from 0.32 us to 0.64us PHY_FLD3: Adjust internal timers PHY_TUNE: Fine tune the regulator12 output voltage Signed-off-by: Wei WANG <wei_wang@realsil.com.cn> Signed-off-by: Lee Jones <lee.jones@linaro.org>
2013-08-30mfd: mmc: rtsx: Change default tx phaseWei WANG
The default phase can meet most cards' requirement, but it is not the optimal one. In some extreme situation, the rx phase point produced by the following tuning process will drift quite a distance. Before tuning UHS card, this patch will set a more proper initial tx phase point, which is calculated from statistic data, and can achieve a much better tx signal quality. Signed-off-by: Wei WANG <wei_wang@realsil.com.cn> Acked-by: Lee Jones <lee.jones@linaro.org> Acked-by: Chris Ball <cjb@laptop.org> Signed-off-by: Samuel Ortiz <sameo@linux.intel.com>
2013-08-20mfd: rtsx: Copyright modificationsWei WANG
Update copyright date, remove author address and add Roger Tseng. Signed-off-by: Wei WANG <wei_wang@realsil.com.cn> Signed-off-by: Samuel Ortiz <sameo@linux.intel.com>
2013-08-20mfd: rtsx: Configure to enter a deeper power-saving mode in S3Wei WANG
Set a bit to enable rts5227 and rts5249 to enter a deeper internal power-saving mode in S3, and recover it after resuming. Signed-off-by: Wei WANG <wei_wang@realsil.com.cn> Signed-off-by: Samuel Ortiz <sameo@linux.intel.com>
2013-08-20mfd: rtsx: Move some actions from rtsx_pci_init_hw to individual extra_init_hwWei WANG
These actions are individual for each reader model, so should be put in extra_init_hw instead of rtsx_pci_init_hw. Signed-off-by: Wei WANG <wei_wang@realsil.com.cn> Signed-off-by: Samuel Ortiz <sameo@linux.intel.com>
2013-08-20mfd: rtsx: Add shutdown callback in rtsx_pci_driverWei WANG
Some actions to clear power state should be handled in .shutdown callback in rtsx_pci_driver. This patch adopts the following measures to catch this goal: 1. Add a function rtsx_pci_power_off to abstract the common ops in .shutdown and .suspend 2. Add pcr->ops->force_power_down to fulfill the individual action for each reader model Signed-off-by: Wei WANG <wei_wang@realsil.com.cn> Signed-off-by: Samuel Ortiz <sameo@linux.intel.com>
2013-08-20mfd: rtsx: Read vendor setting from config spaceWei WANG
Normally OEMs will set vendor setting to the config space of Realtek card reader in BIOS stage. This patch reads the setting at the first, and configure the internal registers according to it, to improve card reader's compatibility condition. Signed-off-by: Wei WANG <wei_wang@realsil.com.cn> Signed-off-by: Samuel Ortiz <sameo@linux.intel.com>
2013-04-19mfd: rtsx: Support RTS5249Wei WANG
RTS5249 supports SD UHS-II interface. In order to support SD UHS-IIļ¼Œthe definitions of some internal registers of RTS5249 have to be modified and are different from its predecessors. So we need this patch to ensure RTS5249 can work, even SD/MMC stack doesn't support UHS-II interface. Signed-off-by: Wei WANG <wei_wang@realsil.com.cn> Signed-off-by: Samuel Ortiz <sameo@linux.intel.com>