| Age | Commit message (Collapse) | Author |
|---|
|
|
|
|
|
This patch explicitly initializes McBSP Transmit Configuration
Control Register (XCCR) and Receive Configuration Control
Register (RCCR) to their reset values. Reset values are 26 ns
of DX delay and Transmit DMA disabled for XCCR register;
receive full cycle mode enabled and Receive DMA disabled for
RCCR register.
This patch requires a counterpart in OMAP McBSP driver before
to apply it. The required changes in McBSP were sent and approved
in linux-omap mailing list and patch is going upstream
(commit 3127f8f8595a064b3f1a1837fea2177902589ac3 from linux-omap-2.6
tree).
Signed-off-by: Misael Lopez Cruz <x0052729@ti.com>
[ jarkko.nikula@nokia.com: Commit id for counterpart patch corrected ]
Signed-off-by: Jarkko Nikula <jarkko.nikula@nokia.com>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
|
|
The WM8753 driver multiplexes the DAI structures it exposes to the
outside world, leaving them uninitialised until the codec probes. Since
the DAI name is used during the registration and setup process provide a
dummy name.
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
|
|
Add another MacBook Pro 4,1 SSID (106b:3800). It seems that latter revisions,
(at least mine), have different IDs to earlier revisions.
Signed-off-by: Luke Yelavich <themuso@ubuntu.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
sound/pci/hda/patch_conexant.c:352: warning: 'conexant_add_jack' defined but not used
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Added the matching model=laptop for HP DV6700 laptop.
Signed-off-by: Joerg Schirottke <master@kanotix.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
The reference NID for the analog outputs of STAC/IDT codecs is set
to a fixed number 0x02. But this isn't always correct and in many
codecs it points to a non-existing NID.
This patch fixes the initialization of the PCM reference NID taken
from the actually probed DAC list.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
|
|
|
|
Some revisions of the 92hd8xxx codec's not supporting port power
downs in which the using of it causes capture and also randomly
playback streams to not function at all. Thus by disabling it by
default and adding a option to enable it manually will fix all issue
on current and future revisions.
Signed-off-by: Matthew Ranostay <mranostay@embeddedalley.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Port 0xe power mapping was incorrect set to 0x80 changed to the correct
value 0x40.
Signed-off-by: Matthew Ranostay <mranostay@embeddedalley.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Added model=hp-dv5 for HP dv4 (103c:30f7).
Reference: kernel bug #12440
http://bugzilla.kernel.org/show_bug.cgi?id=12440
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
On the 92hd8xxx codecs port 0xe needs the connection selected to be the
last DAC in the list.
Signed-off-by: Matthew Ranostay <mranostay@embeddedalley.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
The Freescale MPC8610 driver was defining two SOC card (snd_soc_card)
structures, partially initializing each one, but registering only one of
them with ASoC.
Signed-off-by: Timur Tabi <timur@freescale.com>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
|
|
|
|
Mention in the Kconfig help text that the HDAV1.3 code is rather
experimental.
Signed-off-by: Clemens Ladisch <clemens@ladisch.de>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Add a missing newline.
Signed-off-by: Clemens Ladisch <clemens@ladisch.de>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
This hardware has a better chance of working correctly if we don't
forget to enable it.
Signed-off-by: Clemens Ladisch <clemens@ladisch.de>
Cc: <stable@kernel.org>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
|
|
Fixed invalid power mappings for ports 0xd and 0xe on 93hd83xxx codecs.
They were shifted right one too many bits.
Signed-off-by: Matthew Ranostay <mranostay@embeddedalley.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
|
|
|
|
<mach/hardware.h> doesn't exist on AVR32 and therefore this driver won't
build on that arch. AFAICT this driver doesn't actually use the content
of that header so easiest just to remove it.
Signed-off-by: Ben Nizette <bn@niasdigital.com>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
|
|
Add the 82801H variants 1071:8227 and 8086:2503 to use ALC883_MITAC
Reference: Ubuntu bug 210865
https://bugs.launchpad.net/bugs/210865
Signed-off-by: Luke Yelavich <themuso@ubuntu.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Signed-off-by: Stephen Rothwell <sfr@canb.auug.org.au>
Acked-by: Takashi Iwai <tiwai@suse.de>
Acked-by: Geoff Levand <geoffrey.levand@am.sony.com>
Signed-off-by: Benjamin Herrenschmidt <benh@kernel.crashing.org>
|
|
The codec-parsing of STAC925x was utterly broken due to its unique
design unlike other STAC codecs. It has a volume control only in NID
0x0e (similar as STAC9200), but the parser assumes that the amp is
available on each DAC widget.
The patch fixes the whole wrong stories: fix the initial volume,
assign the fixed "Master" volume, and avoid to create wrong volume
controls.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
|
|
The value set in the commit 2465fb6605b4f8f3964b132017bf4078d1265fe9
is actually wrong. The value range is from 0 to 0x1f while the patch
sets to 0x7f. Let's fix it.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
|
|
|
|
|
|
Modify the check for the mux type to also handle the
snd_soc_dapm_value_mux type in a same way as the snd_soc_dapm_mux.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@nokia.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
On the Asus Xonar D2 and D2X models, the SPI chip select signal for the
fourth DAC shares its pin with the serial clock for the EEPROM that
contains the PCI subdevice ID values. It appears that when DAC
registers are written and some other unknown conditions occur (probably
noise on the EEPROM's chip select line), the EEPROM gets overwritten
with garbage, which makes it impossible to properly detect the card
later.
Therefore, we better avoid DAC register writes and make sure that the
driver works with the DAC's registers' default values. Consequently,
the sample format is now I2S instead of left-justified (no user-visible
change), and the DAC's volume/mute registers cannot be used anymore
(volume changes are now done by the software volume plugin).
Signed-off-by: Clemens Ladisch <clemens@ladisch.de>
Cc: <stable@kernel.org>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Fix HP dv5 (103c:3603) built-in mic input.
Reference: kernel bug 12440
http://bugzilla.kernel.org/show_bug.cgi?id=12440
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Cc: stable@kernel.org
|
|
The selector widget 0x0e isn't initialized properly in the whole probe
process, thus it can be a wrong value depending on the BIOS setup.
This patch adds the init verb to set it to the max & unmuted.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
The Logitech QuickCam Pro 9000 does not appear to any product identification
strings in its USB device descriptor. Therefore it receives a device name of
"USB Device 0x46d:0x990". Th e attached patch below adds a USB quirk to
provide a more friendly name.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Fix the bug introduced in commit c15c5060fc32d7de7cde76aa61e98bae1334d82e:
sound/pci/hda/patch_sigmatel.c: In function ‘patch_stac92hd83xxx’:
sound/pci/hda/patch_sigmatel.c:4765: warning: assignment from incompatible pointer type
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Have the Samsung Q45 (144d:c510) select ALC262_HIPPO by default
Reference: Ubuntu bug 200210
http://launchpad.net/bugs/200210
Signed-off-by: Luke Yelavich <themuso@ubuntu.com>
Cc: stable@kernel.org
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Resetting HP pinctl at the unplugged state may cause a sort of regression
on some devices because of their wrong pin configuration.
A simple workaround is to disable the pin reset. This is ugly and may be
not good from the power-saving POV (if any), but damn simple.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Cc: stable@kernel.org
|
|
Added amp nid for stac92hd8xxx families of codecs so the input amp
mixer is created.
Signed-off-by: Matthew Ranostay <mranostay@embeddedalley.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
CF-74 does the headphone/speaker switching on hardware, thus the driver
shouldn't do any software-toggling of pins. Otherwise it results in a
silent headphone output.
This patch simply resets the hp_detect flag to fix the problem.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
|
|
Replaced the old schedule_work() with queue_delayed_work() where
overlooked in the previous patches.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Add the model=hp-m4 quirk for another HP dv5 (103c:3603)
Reference: kernel bug#12440
http://bugzilla.kernel.org/show_bug.cgi?id=12440
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Cc: stable@kernel.org
|
|
Added the new id for NVidia MCP HDMI (10de:0007).
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
Fix a typo in stac92hd83xxx_cfg_tbl[]. The actual number is identical
thus there is no behavior change.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
|
|
git://git.kernel.org/pub/scm/linux/kernel/git/geert/linux-m68k
* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/geert/linux-m68k: (30 commits)
m68k: Fix --build-id breakage for sun3
m68k: Wire up sys_restart_syscall
fbdev: Kill Atari vblank cursor blinking
m68k: zorro - Use %pR to print resources
m68k: dio - Kill resource_size_t format warnings
m68k: dmasound - Kill warn_unused_result warnings
m68k: zorro - Kill warn_unused_result warnings
m68k: dio - Kill warn_unused_result warnings
m68k: atafb - Kill warn_unused_result warnings
m68k: amiserial - Kill warn_unused_result warnings
m68k: ser_a2232 - Kill warn_unused_result warnings
m68k: vme_scc - Kill warn_unused_result warnings
m68k: sun3 core - Kill warn_unused_result warnings
m68k: mvme147 core - Kill warn_unused_result warnings
m68k: mac core - Kill warn_unused_result warnings
m68k: hp300 core - Kill warn_unused_result warnings
m68k: atari core - Kill warn_unused_result warnings
m68k: apollo core - Kill warn_unused_result warnings
m68k: amiga core - Kill warn_unused_result warnings
m68k: Kill several external declarations in source files
...
|
|
warning: ignoring return value of 'request_irq', declared with attribute
warn_unused_result
Signed-off-by: Geert Uytterhoeven <geert@linux-m68k.org>
|
|
|
