1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
|
=====================================================================
FSL PQ_MDS_T1 Device Tree Binding
Copyright (C) 2012 Freescale Semiconductor Inc.
=====================================================================
Introduction
The PQ-MDS-T1 - A board card with the T1/E1/DS3/T3/SLIC-SLAC module
which serves as a platform for S/W and H/W development
around the host device, it is connected by PMC sockets.
1.TDM PHY
Function : DS26528 T1/E1/J1 transceiver
Properties
- compatible
Usage: required
Value type: <string>
Definition: Should be "fsl,pq-mds-t1".
- reg
Usage: required
Value type: <prop-encoded-array>
Definition: The first reg specifier describes the the address,
and the second describes the length.
- line-rate
Usage: required
Value type: <string>
Definition: It descrbets the line rate "e1" or "t1". "e1" is 2.048MHz
"t1" is 1.544MHz.
- fsl,trans-mode
Usage: required
Value type: <string>
Definition: TDM controller transfer mode setting
Normal operation: set fsl,trans-mode = "normal". In this mode,
controller sends and receives data normally.
Loopback operation: set fsl,trans-mode = "internal-loopback".
In this mode, the data is sent via tsa tx pin and
received from tsa rx pin.
Example
ds26528: tdm-phy@0 {
compatible = "dallas,ds26528";
reg = <0 0x2000>;
line-rate = "e1";
fsl,trans-mode = "normal";
};
2.PQ-MDS-T1 PLD
Function: Board identification, control and clock/signal routing
Properties
- fsl,card-support
Usage: required
Value type: <u32>
Definition: This property use phandle to describe which it serves as,
ds26528 or zarlink.
Example
pld-reg@2000 {
compatible = "fsl,pq-mds-t1-pld";
reg = <0x2000 0x1000>;
fsl,card-support = <&ds26528>;
}
|
