summaryrefslogtreecommitdiff
AgeCommit message (Expand)Author
2014-12-11dts: ls1021a: add the RCPM node and change FPGA's compatibleChenhui Zhao
2014-12-11arm:dts:ls1021aqds: reduce the frequency for dspi flashChao Fu
2014-12-11PCI: Layerscape: Fix PCIe link stateMinghuan Lian
2014-12-11esdhc: mmc: Add LS1021A SD support.Qiu Wujie
2014-12-11esdhc: defconfig: Add LS1021A SD support.Qiu Wujie
2014-12-11tty: of-serial: fixup info uninitialized bugJingchang Lu
2014-12-11i2c: pca954x: put the mux to disconnected state after resumeJisheng Zhang
2014-12-11arm: pm: add deep sleep support for LS1Chenhui Zhao
2014-12-11fsl: fsm: use same interface to support T104x and LS1021AChenhui Zhao
2014-12-11ARM:LS1021aQDS: add CPU hotplug platform supportZhang Zhuoyu
2014-12-11ARM: 7861/1: cacheflush: consolidate single-CPU ARMv7 cache disabling codeNicolas Pitre
2014-12-11ARM: 7885/1: Save/Restore 64-bit TTBR registers on LPAE suspend/resumeMahesh Sivasubramanian
2014-12-11ARM: 8053/1: kernel: sleep: restore HYP mode configuration in cpu_resumeLorenzo Pieralisi
2014-12-11spi:Kconfig:Add DSPI in LS1021 supportChao Fu
2014-12-11arm:dtsi:ls1021a:Add the DSPI transfer mode property in DSPI nodeChao Fu
2014-12-11ASFIPSEC: Porting ASF to LS1.Nikhil Agarwal
2014-12-11audio: dts: Add dts nodes on LS1021AQDS/TWRAlison Wang
2014-12-11cpufreq: qoriq: Make the driver usable on all QorIQ platformsTang Yuantian
2014-12-11clock: redefine variable clocks_per_pll as a struct memberTang Yuantian
2014-12-11dts: ls1021a: updated the soc nodeTang Yuantian
2014-12-11dts: ls1021a: updated the clockgen nodeTang Yuantian
2014-12-11qe-tdm: modify qe-tdm for both arm and powerpcZhao Qiang
2014-12-11ls1021aqds: add qe node to ls1021aqds dtsZhao Qiang
2014-12-11ls102xa: audio: Workaround for SAI data transfer endian issueAlison Wang
2014-12-11can: flexcan: Add support for non RX-FIFO mode and conditional ERRATA ERR0058...Bhupesh Sharma
2014-12-11ls1021a/dts: Add device nodes for FlexCAN IP instancesBhupesh Sharma
2014-12-11net: can: Remodel FlexCAN register read/write APIs for BE instancesBhupesh Sharma
2014-12-11can: flexcan: Add ls1021a flexcan device entryBhupesh Sharma
2014-12-11[fsl-only] can: flexcan: Remove can_change_mtu calls as this is not supported...Bhupesh Sharma
2014-12-11can: flexcan: increase FLEXCAN_MCR_MAXMB() macro to 7 bitsMarc Kleine-Budde
2014-12-11can: flexcan: put TX mailbox into TX_INACTIVE mode after tx-completeMarc Kleine-Budde
2014-12-11can: flexcan: implement workaround for errata ERR005829David Jander
2014-12-11can: flexcan: correctly initialize mailboxesBhupesh Sharma
2014-12-11can: flexcan: mark TX mailbox as TX_INACTIVEMarc Kleine-Budde
2014-12-11can: flexcan: avoid calling usleep_range from interrupt contextDavid Jander
2014-12-11can: flexcan: handle state passive -> warning transitionSebastian Andrzej Siewior
2014-12-11can: flexcan: Disable error interrupt when bus error reporting is disabledAlexander Stein
2014-12-11can: flexcan: add vf610 support for FlexCANStefan Agner
2014-12-11can: flexcan: flexcan_get_berr_counter(): switch on clocks before accessing e...Stefan Agner
2014-12-11can: Unify MTU settings for CAN interfacesOliver Hartkopp
2014-12-11can: flexcan: make use of platform_get_device_id()Marc Kleine-Budde
2014-12-11can: flexcan: Remove #ifdef CONFIG_PM_SLEEPMarc Kleine-Budde
2014-12-11can: flexcan: factor out soft reset into seperate funtionMarc Kleine-Budde
2014-12-11can: flexcan: fix transition from and to freeze mode in chip_{,un}freezeMarc Kleine-Budde
2014-12-11drivers/usb : Remove compilation error for usb EHCI gadgetNikhil Badola
2014-12-11drivers/usb : Port USB EHCI Gadget driver for LS102XANikhil Badola
2014-12-11drivers: usb: fsl: Set USB_EN bit to select ULPI phyNikhil Badola
2014-12-11drivers/usb : Set DMA_MASK of usb platform deviceNikhil Badola
2014-12-11drivers/usb : Port USB EHCI host driver for LS102xANikhil Badola
2014-12-11drivers: usb: fsl: Remove compilation error from usb driverNikhil Badola
generated by cgit v0.10.2 at 2024-11-12 19:39:51 (GMT)