summaryrefslogtreecommitdiff
AgeCommit message (Expand)Author
2014-12-11dts: ls1021a: updated the clockgen nodeTang Yuantian
2014-12-11qe-tdm: modify qe-tdm for both arm and powerpcZhao Qiang
2014-12-11ls1021aqds: add qe node to ls1021aqds dtsZhao Qiang
2014-12-11ls102xa: audio: Workaround for SAI data transfer endian issueAlison Wang
2014-12-11can: flexcan: Add support for non RX-FIFO mode and conditional ERRATA ERR0058...Bhupesh Sharma
2014-12-11ls1021a/dts: Add device nodes for FlexCAN IP instancesBhupesh Sharma
2014-12-11net: can: Remodel FlexCAN register read/write APIs for BE instancesBhupesh Sharma
2014-12-11can: flexcan: Add ls1021a flexcan device entryBhupesh Sharma
2014-12-11[fsl-only] can: flexcan: Remove can_change_mtu calls as this is not supported...Bhupesh Sharma
2014-12-11can: flexcan: increase FLEXCAN_MCR_MAXMB() macro to 7 bitsMarc Kleine-Budde
2014-12-11can: flexcan: put TX mailbox into TX_INACTIVE mode after tx-completeMarc Kleine-Budde
2014-12-11can: flexcan: implement workaround for errata ERR005829David Jander
2014-12-11can: flexcan: correctly initialize mailboxesBhupesh Sharma
2014-12-11can: flexcan: mark TX mailbox as TX_INACTIVEMarc Kleine-Budde
2014-12-11can: flexcan: avoid calling usleep_range from interrupt contextDavid Jander
2014-12-11can: flexcan: handle state passive -> warning transitionSebastian Andrzej Siewior
2014-12-11can: flexcan: Disable error interrupt when bus error reporting is disabledAlexander Stein
2014-12-11can: flexcan: add vf610 support for FlexCANStefan Agner
2014-12-11can: flexcan: flexcan_get_berr_counter(): switch on clocks before accessing e...Stefan Agner
2014-12-11can: Unify MTU settings for CAN interfacesOliver Hartkopp
2014-12-11can: flexcan: make use of platform_get_device_id()Marc Kleine-Budde
2014-12-11can: flexcan: Remove #ifdef CONFIG_PM_SLEEPMarc Kleine-Budde
2014-12-11can: flexcan: factor out soft reset into seperate funtionMarc Kleine-Budde
2014-12-11can: flexcan: fix transition from and to freeze mode in chip_{,un}freezeMarc Kleine-Budde
2014-12-11drivers/usb : Remove compilation error for usb EHCI gadgetNikhil Badola
2014-12-11drivers/usb : Port USB EHCI Gadget driver for LS102XANikhil Badola
2014-12-11drivers: usb: fsl: Set USB_EN bit to select ULPI phyNikhil Badola
2014-12-11drivers/usb : Set DMA_MASK of usb platform deviceNikhil Badola
2014-12-11drivers/usb : Port USB EHCI host driver for LS102xANikhil Badola
2014-12-11drivers: usb: fsl: Remove compilation error from usb driverNikhil Badola
2014-12-11drivers: usb :fsl: Remove USB Errata checking codeNikhil Badola
2014-12-11Enable IFC for ls1021Jaiprakash Singh
2014-12-11arm/dts/ls1021a: Add GPIO controller nodesShaveta Leekha
2014-12-11gpio: enable GPIO support in ls1021a_defconfigShaveta Leekha
2014-12-11gpio: add GPIO support for layerscape architecturesShaveta Leekha
2014-12-11drivers/gpio: Port gpio driver to ls1021a-qds platformShaveta Leekha
2014-12-11arm:dts:ls1021a-twr:correct qspi flash informationChao Fu
2014-12-11arm:dts:ls1021a-qds:correct qspi flash informationChao Fu
2014-12-11arm:dts:ls1021a:add qspi-memory address and correct qspi compatibleChao Fu
2014-12-11crypto: caam - Dynamic allocation of addresses for various memory blocks in C...Nitesh Narayan Lal
2014-12-11gianfar: Add dma transfer endian property supportJingchang Lu
2014-12-11ls1021a: Enable GIANFAR for LS1Claudiu Manoil
2014-12-11gianfar: Remove tx snooping support from LS1Claudiu Manoil
2014-12-11gianfar: Consider dts property endianess on handlingJingchang Lu
2014-12-11gianfar: Make FCB access endian safeClaudiu Manoil
2014-12-11gianfar: Make BDs access endian safeClaudiu Manoil
2014-12-11fb: dcu: add Power Management support.Xiubo Li
2014-12-11pwm: ftm: add Power Management support for FTM pwm.Xiubo Li
2014-12-11pwm: ftm: add regmap rbtree type cache support.Xiubo Li
2014-12-11ARM: ls1021a: add gating clocks to IP blocks.Xiubo Li