summaryrefslogtreecommitdiff
AgeCommit message (Expand)Author
2012-08-20mac80211: mesh: don't use global channel typeJohannes Berg
2012-08-20mac80211: simplify buffers in aes_128_cmac_vectorJohannes Berg
2012-08-20mac80211_hwsim: add support for P2P DeviceJohannes Berg
2012-08-20mac80211: add IEEE80211_HW_P2P_DEV_ADDR_FOR_INTFJohannes Berg
2012-08-20mac80211: support P2P Device abstractionJohannes Berg
2012-08-20cfg80211: add P2P Device abstractionJohannes Berg
2012-08-20mac80211: make ieee80211_beacon_connection_loss_work staticJohannes Berg
2012-08-20mac80211: check size of channel switch IE when parsingJohannes Berg
2012-08-20mac80211: fix CSA handling timerJohannes Berg
2012-08-20mac80211: clean up CSA handling codeJohannes Berg
2012-08-20mac80211: remove unneeded 'bssid' variableJohannes Berg
2012-08-20mac80211: support A-MPDU status reportingJohannes Berg
2012-08-20wireless: add radiotap A-MPDU status fieldJohannes Berg
2012-08-20mac80211: add supported rates change notification in IBSSAntonio Quartulli
2012-08-20mac80211: clean up mpath_move_to_queue()Thomas Pedersen
2012-08-20mac80211: use skb_queue_walk() in mesh_path_assign_nexthopThomas Pedersen
2012-08-20mac80211: avoid using synchronize_rcu in ieee80211_set_probe_respEyal Shapira
2012-08-13p54: fix powerpc gcc warningsChristian Lamparter
2012-08-13mac80211: fix unnecessary beacon update after peering status changeMarco Porsch
2012-08-10brcmsmac: document firmware dependenciesJeff Mahoney
2012-08-10ath9k: tune rc_stats to display only valid ratesRajkumar Manoharan
2012-08-10ath9k: Trim rate tableSujith Manoharan
2012-08-10ath9k: Remove MIMO-PS specific codeSujith Manoharan
2012-08-10ath9k: Cleanup TX status APISujith Manoharan
2012-08-10ath9k: Bail out properly before calculating rate indexSujith Manoharan
2012-08-10ath9k: Fix RTS/CTS rate selectionSujith Manoharan
2012-08-10ath9k: Do not set IEEE80211_TX_RC_USE_SHORT_PREAMBLESujith Manoharan
2012-08-10ath9k: Unify valid rate calculation routinesSujith Manoharan
2012-08-10ath9k: Remove ath_rc_set_valid_rate_idxSujith Manoharan
2012-08-10ath9k: Change rateset calculationSujith Manoharan
2012-08-10ath9k: Cleanup index retrieval routinesSujith Manoharan
2012-08-10ath9k: Cleanup ath_rc_setvalid_htratesSujith Manoharan
2012-08-10ath9k: Cleanup ath_rc_setvalid_ratesSujith Manoharan
2012-08-10ath9k: Cleanup RC init APISujith Manoharan
2012-08-10ath9k: Simplify rate table initializationSujith Manoharan
2012-08-10mwifiex: use GFP_ATOMIC under spin lockDan Carpenter
2012-08-10mwifiex: notify cfg80211 about MIC failuresAmitkumar Karwar
2012-08-10mwifiex: fix 'smatch' warning in preparing key_material cmdBing Zhao
2012-08-10ssb: check for flash presentenceRafał Miłecki
2012-08-10b43legacy: fix logic in GPIO initRafał Miłecki
2012-08-10b43: N-PHY: fix 0x2057 radio calib copy/paste mistakeRafał Miłecki
2012-08-10bcma: add (mostly) NAND definesRafał Miłecki
2012-08-10mwifiex: fix powerpc64-linux- compilation warningsBing Zhao
2012-08-10iwlegacy: clean up suspend/resumeJohannes Berg
2012-08-10mwifiex: fix code mis-alignment after the if statementFengguang Wu
2012-08-10ath5k: Put power_level where it belongs and rename itNick Kossifidis
2012-08-10ath5k: Preserve tx power level requested from above on phy_initNick Kossifidis
2012-08-10ath5k: Fix range scaling when setting rate power tableNick Kossifidis
2012-08-10ath5k: Use correct value for min_pwr and cur_pwrNick Kossifidis
2012-08-10bcma: make some functions staticHauke Mehrtens
generated by cgit v0.10.2 at 2024-10-23 13:18:35 (GMT)