summaryrefslogtreecommitdiff
diff options
context:
space:
mode:
-rw-r--r--drivers/misc/ti-st/st_kim.c37
1 files changed, 36 insertions, 1 deletions
diff --git a/drivers/misc/ti-st/st_kim.c b/drivers/misc/ti-st/st_kim.c
index 9ff942a..83269f1 100644
--- a/drivers/misc/ti-st/st_kim.c
+++ b/drivers/misc/ti-st/st_kim.c
@@ -468,6 +468,11 @@ long st_kim_start(void *kim_data)
if (pdata->chip_enable)
pdata->chip_enable(kim_gdata);
+ /* Configure BT nShutdown to HIGH state */
+ gpio_set_value(kim_gdata->nshutdown, GPIO_LOW);
+ mdelay(5); /* FIXME: a proper toggle */
+ gpio_set_value(kim_gdata->nshutdown, GPIO_HIGH);
+ mdelay(100);
/* re-initialize the completion */
INIT_COMPLETION(kim_gdata->ldisc_installed);
/* send notification to UIM */
@@ -509,7 +514,8 @@ long st_kim_start(void *kim_data)
* (b) upon failure to either install ldisc or download firmware.
* The function is responsible to (a) notify UIM about un-installation,
* (b) flush UART if the ldisc was installed.
- * (c) invoke platform's chip disabling routine.
+ * (c) reset BT_EN - pull down nshutdown at the end.
+ * (d) invoke platform's chip disabling routine.
*/
long st_kim_stop(void *kim_data)
{
@@ -541,6 +547,13 @@ long st_kim_stop(void *kim_data)
err = -ETIMEDOUT;
}
+ /* By default configure BT nShutdown to LOW state */
+ gpio_set_value(kim_gdata->nshutdown, GPIO_LOW);
+ mdelay(1);
+ gpio_set_value(kim_gdata->nshutdown, GPIO_HIGH);
+ mdelay(1);
+ gpio_set_value(kim_gdata->nshutdown, GPIO_LOW);
+
/* platform specific disable */
if (pdata->chip_disable)
pdata->chip_disable(kim_gdata);
@@ -733,6 +746,20 @@ static int kim_probe(struct platform_device *pdev)
/* refer to itself */
kim_gdata->core_data->kim_data = kim_gdata;
+ /* Claim the chip enable nShutdown gpio from the system */
+ kim_gdata->nshutdown = pdata->nshutdown_gpio;
+ err = gpio_request(kim_gdata->nshutdown, "kim");
+ if (unlikely(err)) {
+ pr_err(" gpio %ld request failed ", kim_gdata->nshutdown);
+ return err;
+ }
+
+ /* Configure nShutdown GPIO as output=0 */
+ err = gpio_direction_output(kim_gdata->nshutdown, 0);
+ if (unlikely(err)) {
+ pr_err(" unable to configure gpio %ld", kim_gdata->nshutdown);
+ return err;
+ }
/* get reference of pdev for request_firmware
*/
kim_gdata->kim_pdev = pdev;
@@ -779,10 +806,18 @@ err_core_init:
static int kim_remove(struct platform_device *pdev)
{
+ /* free the GPIOs requested */
+ struct ti_st_plat_data *pdata = pdev->dev.platform_data;
struct kim_data_s *kim_gdata;
kim_gdata = dev_get_drvdata(&pdev->dev);
+ /* Free the Bluetooth/FM/GPIO
+ * nShutdown gpio from the system
+ */
+ gpio_free(pdata->nshutdown_gpio);
+ pr_info("nshutdown GPIO Freed");
+
debugfs_remove_recursive(kim_debugfs_dir);
sysfs_remove_group(&pdev->dev.kobj, &uim_attr_grp);
pr_info("sysfs entries removed");