diff options
-rw-r--r-- | Documentation/devicetree/bindings/mtd/gpmc-nor.txt | 98 | ||||
-rw-r--r-- | arch/arm/mach-omap2/gpmc.c | 115 |
2 files changed, 213 insertions, 0 deletions
diff --git a/Documentation/devicetree/bindings/mtd/gpmc-nor.txt b/Documentation/devicetree/bindings/mtd/gpmc-nor.txt new file mode 100644 index 0000000..420b3ab --- /dev/null +++ b/Documentation/devicetree/bindings/mtd/gpmc-nor.txt @@ -0,0 +1,98 @@ +Device tree bindings for NOR flash connect to TI GPMC + +NOR flash connected to the TI GPMC (found on OMAP boards) are represented as +child nodes of the GPMC controller with a name of "nor". + +All timing relevant properties as well as generic GPMC child properties are +explained in a separate documents. Please refer to +Documentation/devicetree/bindings/bus/ti-gpmc.txt + +Required properties: +- bank-width: Width of NOR flash in bytes. GPMC supports 8-bit and + 16-bit devices and so must be either 1 or 2 bytes. +- compatible: Documentation/devicetree/bindings/mtd/mtd-physmap.txt +- gpmc,cs-on-ns: Chip-select assertion time +- gpmc,cs-rd-off-ns: Chip-select de-assertion time for reads +- gpmc,cs-wr-off-ns: Chip-select de-assertion time for writes +- gpmc,oe-on-ns: Output-enable assertion time +- gpmc,oe-off-ns: Output-enable de-assertion time +- gpmc,we-on-ns Write-enable assertion time +- gpmc,we-off-ns: Write-enable de-assertion time +- gpmc,access-ns: Start cycle to first data capture (read access) +- gpmc,rd-cycle-ns: Total read cycle time +- gpmc,wr-cycle-ns: Total write cycle time +- linux,mtd-name: Documentation/devicetree/bindings/mtd/mtd-physmap.txt +- reg: Chip-select, base address (relative to chip-select) + and size of NOR flash. Note that base address will be + typically 0 as this is the start of the chip-select. + +Optional properties: +- gpmc,XXX Additional GPMC timings and settings parameters. See + Documentation/devicetree/bindings/bus/ti-gpmc.txt + +Optional properties for partiton table parsing: +- #address-cells: should be set to 1 +- #size-cells: should be set to 1 + +Example: + +gpmc: gpmc@6e000000 { + compatible = "ti,omap3430-gpmc", "simple-bus"; + ti,hwmods = "gpmc"; + reg = <0x6e000000 0x1000>; + interrupts = <20>; + gpmc,num-cs = <8>; + gpmc,num-waitpins = <4>; + #address-cells = <2>; + #size-cells = <1>; + + ranges = <0 0 0x10000000 0x08000000>; + + nor@0,0 { + compatible = "cfi-flash"; + linux,mtd-name= "intel,pf48f6000m0y1be"; + #address-cells = <1>; + #size-cells = <1>; + reg = <0 0 0x08000000>; + bank-width = <2>; + + gpmc,mux-add-data; + gpmc,cs-on-ns = <0>; + gpmc,cs-rd-off-ns = <186>; + gpmc,cs-wr-off-ns = <186>; + gpmc,adv-on-ns = <12>; + gpmc,adv-rd-off-ns = <48>; + gpmc,adv-wr-off-ns = <48>; + gpmc,oe-on-ns = <54>; + gpmc,oe-off-ns = <168>; + gpmc,we-on-ns = <54>; + gpmc,we-off-ns = <168>; + gpmc,rd-cycle-ns = <186>; + gpmc,wr-cycle-ns = <186>; + gpmc,access-ns = <114>; + gpmc,page-burst-access-ns = <6>; + gpmc,bus-turnaround-ns = <12>; + gpmc,cycle2cycle-delay-ns = <18>; + gpmc,wr-data-mux-bus-ns = <90>; + gpmc,wr-access-ns = <186>; + gpmc,cycle2cycle-samecsen; + gpmc,cycle2cycle-diffcsen; + + partition@0 { + label = "bootloader-nor"; + reg = <0 0x40000>; + }; + partition@0x40000 { + label = "params-nor"; + reg = <0x40000 0x40000>; + }; + partition@0x80000 { + label = "kernel-nor"; + reg = <0x80000 0x200000>; + }; + partition@0x280000 { + label = "filesystem-nor"; + reg = <0x240000 0x7d80000>; + }; + }; +}; diff --git a/arch/arm/mach-omap2/gpmc.c b/arch/arm/mach-omap2/gpmc.c index ab658eb..c7bf6dd 100644 --- a/arch/arm/mach-omap2/gpmc.c +++ b/arch/arm/mach-omap2/gpmc.c @@ -26,6 +26,7 @@ #include <linux/interrupt.h> #include <linux/platform_device.h> #include <linux/of.h> +#include <linux/of_address.h> #include <linux/of_mtd.h> #include <linux/of_device.h> #include <linux/mtd/nand.h> @@ -499,6 +500,37 @@ static int gpmc_cs_delete_mem(int cs) return r; } +/** + * gpmc_cs_remap - remaps a chip-select physical base address + * @cs: chip-select to remap + * @base: physical base address to re-map chip-select to + * + * Re-maps a chip-select to a new physical base address specified by + * "base". Returns 0 on success and appropriate negative error code + * on failure. + */ +static int gpmc_cs_remap(int cs, u32 base) +{ + int ret; + u32 old_base, size; + + if (cs > GPMC_CS_NUM) + return -ENODEV; + gpmc_cs_get_memconf(cs, &old_base, &size); + if (base == old_base) + return 0; + gpmc_cs_disable_mem(cs); + ret = gpmc_cs_delete_mem(cs); + if (ret < 0) + return ret; + ret = gpmc_cs_insert_mem(cs, base, size); + if (ret < 0) + return ret; + gpmc_cs_enable_mem(cs, base, size); + + return 0; +} + int gpmc_cs_request(int cs, unsigned long size, unsigned long *base) { struct resource *res = &gpmc_cs_mem[cs]; @@ -1386,6 +1418,80 @@ static int gpmc_probe_onenand_child(struct platform_device *pdev, } #endif +/** + * gpmc_probe_nor_child - configures the gpmc for a nor device + * @pdev: pointer to gpmc platform device + * @child: pointer to device-tree node for nor device + * + * Allocates and configures a GPMC chip-select for a NOR flash device. + * Returns 0 on success and appropriate negative error code on failure. + */ +static int gpmc_probe_nor_child(struct platform_device *pdev, + struct device_node *child) +{ + struct gpmc_settings gpmc_s; + struct gpmc_timings gpmc_t; + struct resource res; + unsigned long base; + int ret, cs; + + if (of_property_read_u32(child, "reg", &cs) < 0) { + dev_err(&pdev->dev, "%s has no 'reg' property\n", + child->full_name); + return -ENODEV; + } + + if (of_address_to_resource(child, 0, &res) < 0) { + dev_err(&pdev->dev, "%s has malformed 'reg' property\n", + child->full_name); + return -ENODEV; + } + + ret = gpmc_cs_request(cs, resource_size(&res), &base); + if (ret < 0) { + dev_err(&pdev->dev, "cannot request GPMC CS %d\n", cs); + return ret; + } + + /* + * FIXME: gpmc_cs_request() will map the CS to an arbitary + * location in the gpmc address space. When booting with + * device-tree we want the NOR flash to be mapped to the + * location specified in the device-tree blob. So remap the + * CS to this location. Once DT migration is complete should + * just make gpmc_cs_request() map a specific address. + */ + ret = gpmc_cs_remap(cs, res.start); + if (ret < 0) { + dev_err(&pdev->dev, "cannot remap GPMC CS %d to 0x%x\n", + cs, res.start); + goto err; + } + + gpmc_read_settings_dt(child, &gpmc_s); + + ret = of_property_read_u32(child, "bank-width", &gpmc_s.device_width); + if (ret < 0) + goto err; + + ret = gpmc_cs_program_settings(cs, &gpmc_s); + if (ret < 0) + goto err; + + gpmc_read_timings_dt(child, &gpmc_t); + gpmc_cs_set_timings(cs, &gpmc_t); + + if (of_platform_device_create(child, NULL, &pdev->dev)) + return 0; + + dev_err(&pdev->dev, "failed to create gpmc child %s\n", child->name); + +err: + gpmc_cs_free(cs); + + return ret; +} + static int gpmc_probe_dt(struct platform_device *pdev) { int ret; @@ -1418,6 +1524,15 @@ static int gpmc_probe_dt(struct platform_device *pdev) return ret; } } + + for_each_node_by_name(child, "nor") { + ret = gpmc_probe_nor_child(pdev, child); + if (ret < 0) { + of_node_put(child); + return ret; + } + } + return 0; } #else |