diff options
Diffstat (limited to 'drivers/net/ethernet/broadcom/tg3.c')
-rw-r--r-- | drivers/net/ethernet/broadcom/tg3.c | 117 |
1 files changed, 111 insertions, 6 deletions
diff --git a/drivers/net/ethernet/broadcom/tg3.c b/drivers/net/ethernet/broadcom/tg3.c index d9e81d6..b1b3bc0 100644 --- a/drivers/net/ethernet/broadcom/tg3.c +++ b/drivers/net/ethernet/broadcom/tg3.c @@ -44,6 +44,7 @@ #include <linux/prefetch.h> #include <linux/dma-mapping.h> #include <linux/firmware.h> +#include <linux/ssb/ssb_driver_gige.h> #include <linux/hwmon.h> #include <linux/hwmon-sysfs.h> @@ -263,6 +264,7 @@ static DEFINE_PCI_DEVICE_TABLE(tg3_pci_tbl) = { TG3_DRV_DATA_FLAG_5705_10_100}, {PCI_DEVICE(PCI_VENDOR_ID_BROADCOM, PCI_DEVICE_ID_TIGON3_5721)}, {PCI_DEVICE(PCI_VENDOR_ID_BROADCOM, PCI_DEVICE_ID_TIGON3_5722)}, + {PCI_DEVICE(PCI_VENDOR_ID_BROADCOM, PCI_DEVICE_ID_TIGON3_5750)}, {PCI_DEVICE(PCI_VENDOR_ID_BROADCOM, PCI_DEVICE_ID_TIGON3_5751)}, {PCI_DEVICE(PCI_VENDOR_ID_BROADCOM, PCI_DEVICE_ID_TIGON3_5751M)}, {PCI_DEVICE(PCI_VENDOR_ID_BROADCOM, PCI_DEVICE_ID_TIGON3_5751F), @@ -573,7 +575,9 @@ static void _tw32_flush(struct tg3 *tp, u32 off, u32 val, u32 usec_wait) static inline void tw32_mailbox_flush(struct tg3 *tp, u32 off, u32 val) { tp->write32_mbox(tp, off, val); - if (!tg3_flag(tp, MBOX_WRITE_REORDER) && !tg3_flag(tp, ICH_WORKAROUND)) + if (tg3_flag(tp, FLUSH_POSTED_WRITES) || + (!tg3_flag(tp, MBOX_WRITE_REORDER) && + !tg3_flag(tp, ICH_WORKAROUND))) tp->read32_mbox(tp, off); } @@ -583,7 +587,8 @@ static void tg3_write32_tx_mbox(struct tg3 *tp, u32 off, u32 val) writel(val, mbox); if (tg3_flag(tp, TXD_MBOX_HWBUG)) writel(val, mbox); - if (tg3_flag(tp, MBOX_WRITE_REORDER)) + if (tg3_flag(tp, MBOX_WRITE_REORDER) || + tg3_flag(tp, FLUSH_POSTED_WRITES)) readl(mbox); } @@ -1793,6 +1798,11 @@ static int tg3_poll_fw(struct tg3 *tp) int i; u32 val; + if (tg3_flag(tp, IS_SSB_CORE)) { + /* We don't use firmware. */ + return 0; + } + if (GET_ASIC_REV(tp->pci_chip_rev_id) == ASIC_REV_5906) { /* Wait up to 20ms for init done. */ for (i = 0; i < 200; i++) { @@ -3465,6 +3475,13 @@ static int tg3_halt_cpu(struct tg3 *tp, u32 offset) tw32_f(offset + CPU_MODE, CPU_MODE_HALT); udelay(10); } else { + /* + * There is only an Rx CPU for the 5750 derivative in the + * BCM4785. + */ + if (tg3_flag(tp, IS_SSB_CORE)) + return 0; + for (i = 0; i < 10000; i++) { tw32(offset + CPU_STATE, 0xffffffff); tw32(offset + CPU_MODE, CPU_MODE_HALT); @@ -3932,8 +3949,9 @@ static int tg3_power_down_prepare(struct tg3 *tp) tg3_frob_aux_power(tp, true); /* Workaround for unstable PLL clock */ - if ((GET_CHIP_REV(tp->pci_chip_rev_id) == CHIPREV_5750_AX) || - (GET_CHIP_REV(tp->pci_chip_rev_id) == CHIPREV_5750_BX)) { + if ((!tg3_flag(tp, IS_SSB_CORE)) && + ((GET_CHIP_REV(tp->pci_chip_rev_id) == CHIPREV_5750_AX) || + (GET_CHIP_REV(tp->pci_chip_rev_id) == CHIPREV_5750_BX))) { u32 val = tr32(0x7d00); val &= ~((1 << 16) | (1 << 4) | (1 << 2) | (1 << 1) | 1); @@ -4454,6 +4472,15 @@ relink: if (current_link_up == 0 || (tp->phy_flags & TG3_PHYFLG_IS_LOW_POWER)) { tg3_phy_copper_begin(tp); + if (tg3_flag(tp, ROBOSWITCH)) { + current_link_up = 1; + /* FIXME: when BCM5325 switch is used use 100 MBit/s */ + current_speed = SPEED_1000; + current_duplex = DUPLEX_FULL; + tp->link_config.active_speed = current_speed; + tp->link_config.active_duplex = current_duplex; + } + tg3_readphy(tp, MII_BMSR, &bmsr); if ((!tg3_readphy(tp, MII_BMSR, &bmsr) && (bmsr & BMSR_LSTATUS)) || (tp->mac_mode & MAC_MODE_PORT_INT_LPBACK)) @@ -4472,6 +4499,26 @@ relink: else tp->mac_mode |= MAC_MODE_PORT_MODE_GMII; + /* In order for the 5750 core in BCM4785 chip to work properly + * in RGMII mode, the Led Control Register must be set up. + */ + if (tg3_flag(tp, RGMII_MODE)) { + u32 led_ctrl = tr32(MAC_LED_CTRL); + led_ctrl &= ~(LED_CTRL_1000MBPS_ON | LED_CTRL_100MBPS_ON); + + if (tp->link_config.active_speed == SPEED_10) + led_ctrl |= LED_CTRL_LNKLED_OVERRIDE; + else if (tp->link_config.active_speed == SPEED_100) + led_ctrl |= (LED_CTRL_LNKLED_OVERRIDE | + LED_CTRL_100MBPS_ON); + else if (tp->link_config.active_speed == SPEED_1000) + led_ctrl |= (LED_CTRL_LNKLED_OVERRIDE | + LED_CTRL_1000MBPS_ON); + + tw32(MAC_LED_CTRL, led_ctrl); + udelay(40); + } + tp->mac_mode &= ~MAC_MODE_HALF_DUPLEX; if (tp->link_config.active_duplex == DUPLEX_HALF) tp->mac_mode |= MAC_MODE_HALF_DUPLEX; @@ -8449,6 +8496,16 @@ static int tg3_chip_reset(struct tg3 *tp) tw32(0x5000, 0x400); } + if (tg3_flag(tp, IS_SSB_CORE)) { + /* + * BCM4785: In order to avoid repercussions from using + * potentially defective internal ROM, stop the Rx RISC CPU, + * which is not required. + */ + tg3_stop_fw(tp); + tg3_halt_cpu(tp, RX_CPU_BASE); + } + tw32(GRC_MODE, tp->grc_mode); if (tp->pci_chip_rev_id == CHIPREV_ID_5705_A0) { @@ -10107,6 +10164,11 @@ static void tg3_timer(unsigned long __opaque) tg3_flag(tp, 57765_CLASS)) tg3_chk_missed_msi(tp); + if (tg3_flag(tp, FLUSH_POSTED_WRITES)) { + /* BCM4785: Flush posted writes from GbE to host memory. */ + tr32(HOSTCC_MODE); + } + if (!tg3_flag(tp, TAGGED_STATUS)) { /* All of this garbage is because when using non-tagged * IRQ status the mailbox/status_block protocol the chip @@ -13879,6 +13941,14 @@ static void tg3_get_5720_nvram_info(struct tg3 *tp) /* Chips other than 5700/5701 use the NVRAM for fetching info. */ static void tg3_nvram_init(struct tg3 *tp) { + if (tg3_flag(tp, IS_SSB_CORE)) { + /* No NVRAM and EEPROM on the SSB Broadcom GigE core. */ + tg3_flag_clear(tp, NVRAM); + tg3_flag_clear(tp, NVRAM_BUFFERED); + tg3_flag_set(tp, NO_NVRAM); + return; + } + tw32_f(GRC_EEPROM_ADDR, (EEPROM_ADDR_FSM_RESET | (EEPROM_DEFAULT_CLOCK_PERIOD << @@ -14405,10 +14475,19 @@ static int tg3_phy_probe(struct tg3 *tp) * subsys device table. */ p = tg3_lookup_by_subsys(tp); - if (!p) + if (p) { + tp->phy_id = p->phy_id; + } else if (!tg3_flag(tp, IS_SSB_CORE)) { + /* For now we saw the IDs 0xbc050cd0, + * 0xbc050f80 and 0xbc050c30 on devices + * connected to an BCM4785 and there are + * probably more. Just assume that the phy is + * supported when it is connected to a SSB core + * for now. + */ return -ENODEV; + } - tp->phy_id = p->phy_id; if (!tp->phy_id || tp->phy_id == TG3_PHY_ID_BCM8002) tp->phy_flags |= TG3_PHYFLG_PHY_SERDES; @@ -15484,6 +15563,11 @@ static int tg3_get_invariants(struct tg3 *tp, const struct pci_device_id *ent) TG3_CPMU_STATUS_FSHFT_5719; } + if (tg3_flag(tp, FLUSH_POSTED_WRITES)) { + tp->write32_tx_mbox = tg3_write_flush_reg32; + tp->write32_rx_mbox = tg3_write_flush_reg32; + } + /* Get eeprom hw config before calling tg3_set_power_state(). * In particular, the TG3_FLAG_IS_NIC flag must be * determined before calling tg3_set_power_state() so that @@ -15820,12 +15904,19 @@ static int tg3_get_device_address(struct tg3 *tp) struct net_device *dev = tp->dev; u32 hi, lo, mac_offset; int addr_ok = 0; + int err; #ifdef CONFIG_SPARC if (!tg3_get_macaddr_sparc(tp)) return 0; #endif + if (tg3_flag(tp, IS_SSB_CORE)) { + err = ssb_gige_get_macaddr(tp->pdev, &dev->dev_addr[0]); + if (!err && is_valid_ether_addr(&dev->dev_addr[0])) + return 0; + } + mac_offset = 0x7c; if (GET_ASIC_REV(tp->pci_chip_rev_id) == ASIC_REV_5704 || tg3_flag(tp, 5780_CLASS)) { @@ -16185,6 +16276,8 @@ static int tg3_test_dma(struct tg3 *tp) tp->dma_rwctrl |= 0x001b000f; } } + if (tg3_flag(tp, ONE_DMA_AT_ONCE)) + tp->dma_rwctrl |= DMA_RWCTRL_ONE_DMA; if (GET_ASIC_REV(tp->pci_chip_rev_id) == ASIC_REV_5703 || GET_ASIC_REV(tp->pci_chip_rev_id) == ASIC_REV_5704) @@ -16530,6 +16623,18 @@ static int tg3_init_one(struct pci_dev *pdev, else tp->msg_enable = TG3_DEF_MSG_ENABLE; + if (pdev_is_ssb_gige_core(pdev)) { + tg3_flag_set(tp, IS_SSB_CORE); + if (ssb_gige_must_flush_posted_writes(pdev)) + tg3_flag_set(tp, FLUSH_POSTED_WRITES); + if (ssb_gige_one_dma_at_once(pdev)) + tg3_flag_set(tp, ONE_DMA_AT_ONCE); + if (ssb_gige_have_roboswitch(pdev)) + tg3_flag_set(tp, ROBOSWITCH); + if (ssb_gige_is_rgmii(pdev)) + tg3_flag_set(tp, RGMII_MODE); + } + /* The word/byte swap controls here control register access byte * swapping. DMA data byte swapping is controlled in the GRC_MODE * setting below. |