drivers/perf: arm-pmu: Handle per-interrupt affinity mask

On a big-little system, PMUs can be wired to CPUs using per CPU
interrups (PPI). In this case, it is important to make sure that
the enable/disable do happen on the right set of CPUs.

So instead of relying on the interrupt-affinity property, we can
use the actual percpu affinity that DT exposes as part of the
interrupt specifier. The DT binding is also updated to reflect
the fact that the interrupt-affinity property shouldn't be used
in that case.

Acked-by: Rob Herring <robh@kernel.org>
Tested-by: Caesar Wang <wxt@rock-chips.com>
Signed-off-by: Marc Zyngier <marc.zyngier@arm.com>
Signed-off-by: Will Deacon <will.deacon@arm.com>
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>

1 files changed, 3 insertions, 1 deletions

diff --git a/Documentation/devicetree/bindings/arm/pmu.txt b/Documentation/devicetree/bindings/arm/pmu.txt
index 74d5417..61c8b46 100644
--- a/Documentation/devicetree/bindings/arm/pmu.txt
+++ b/Documentation/devicetree/bindings/arm/pmu.txt
@@ -39,7 +39,9 @@ Optional properties:
                        When using a PPI, specifies a list of phandles to CPU
 		       nodes corresponding to the set of CPUs which have
 		       a PMU of this type signalling the PPI listed in the
-		       interrupts property.
+		       interrupts property, unless this is already specified
+		       by the PPI interrupt specifier itself (in which case
+		       the interrupt-affinity property shouldn't be present).
 
                        This property should be present when there is more than
 		       a single SPI.