ARM: ux500: add misc sensors to the device trees

This adds the STMicroelectonics MEMS sensor devices to the Ux500
family device trees:

- Accelerometer
- Magnetometer
- Gyroscope
- Pressure (barometer)

Cc: Lee Jones <lee.jones@linaro.org>
Cc: Denis CIOCCA <denis.ciocca@st.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

1 files changed, 0 insertions, 24 deletions

diff --git a/arch/arm/boot/dts/ste-hrefv60plus.dtsi b/arch/arm/boot/dts/ste-hrefv60plus.dtsi
index c234106..bcc1f0c 100644
--- a/arch/arm/boot/dts/ste-hrefv60plus.dtsi
+++ b/arch/arm/boot/dts/ste-hrefv60plus.dtsi
@@ -35,8 +35,6 @@
 			 */
 			pinctrl-names = "default";
 			pinctrl-0 = <&ipgpio_hrefv60_mode>,
-				  <&accel_hrefv60_mode>,
-				  <&magneto_hrefv60_mode>,
 				  <&etm_hrefv60_mode>,
 				  <&nahj_hrefv60_mode>,
 				  <&nfc_hrefv60_mode>,
@@ -83,28 +81,6 @@
 					};
 				};
 			};
-			accelerometer {
-				accel_hrefv60_mode: accel_hrefv60 {
-					/* Accelerometer interrupt lines 1 & 2 */
-					hrefv60_cfg1 {
-						ste,pins = "GPIO82_C1", "GPIO83_D3";
-						ste,config = <&gpio_in_pu>;
-					};
-				};
-			};
-			magnetometer {
-				magneto_hrefv60_mode: magneto_hrefv60 {
-					/* Magnetometer uses GPIO 31 and 32, pull these up/down respectively */
-					hrefv60_cfg1 {
-						ste,pins = "GPIO31_V3";
-						ste,config = <&gpio_in_pu>;
-					};
-					hrefv60_cfg2 {
-						ste,pins = "GPIO32_V2";
-						ste,config = <&gpio_in_pd>;
-					};
-				};
-			};
 			etm {
 				/*
 				 * Drive D19-D23 for the ETM PTM trace interface low,