tile: fast-path unaligned memory access for tilegx

This change enables unaligned userspace memory access via a kernel
fast path on tilegx.  The kernel tracks user PC/instruction pairs
per-thread using a direct-mapped cache in userspace.  The cache
maps those PC/instruction pairs to JIT'ed instruction sequences that
load or store using byte-wide load store intructions and then
synthesize 2-, 4- or 8-byte load or store results.  Once an
instruction has been seen to generate an unaligned access once,
subsequent hits on that instruction typically require overhead
of only around 50 cycles if cache and TLB is hot.

We support the prctl() PR_GET_UNALIGN / PR_SET_UNALIGN sys call to
enable or disable unaligned fixups on a per-process basis.

To do this we pull some of the tilepro unaligned support out of the
single_step.c file; tilepro uses instruction disassembly for both
single-step and unaligned access support.  Since tilegx actually has
hardware singlestep support, though, it's cleaner to keep the tilegx
unaligned access code in a separate file.  While we're at it,
properly rename the tilepro-specific types, etc., to have tilepro
suffixes instead of generic tile suffixes.

Signed-off-by: Chris Metcalf <cmetcalf@tilera.com>

1 files changed, 41 insertions, 0 deletions

diff --git a/arch/tile/mm/fault.c b/arch/tile/mm/fault.c
index 6152819..7863298 100644
--- a/arch/tile/mm/fault.c
+++ b/arch/tile/mm/fault.c
@@ -722,8 +722,49 @@ void do_page_fault(struct pt_regs *regs, int fault_num,
 {
 	int is_page_fault;
 
+#ifdef __tilegx__
+	/*
+	 * We don't need early do_page_fault_ics() support, since unlike
+	 * Pro we don't need to worry about unlocking the atomic locks.
+	 * There is only one current case in GX where we touch any memory
+	 * under ICS other than our own kernel stack, and we handle that
+	 * here.  (If we crash due to trying to touch our own stack,
+	 * we're in too much trouble for C code to help out anyway.)
+	 */
+	if (write & ~1) {
+		unsigned long pc = write & ~1;
+		if (pc >= (unsigned long) __start_unalign_asm_code &&
+		    pc < (unsigned long) __end_unalign_asm_code) {
+			struct thread_info *ti = current_thread_info();
+			/*
+			 * Our EX_CONTEXT is still what it was from the
+			 * initial unalign exception, but now we've faulted
+			 * on the JIT page.  We would like to complete the
+			 * page fault however is appropriate, and then retry
+			 * the instruction that caused the unalign exception.
+			 * Our state has been "corrupted" by setting the low
+			 * bit in "sp", and stashing r0..r3 in the
+			 * thread_info area, so we revert all of that, then
+			 * continue as if this were a normal page fault.
+			 */
+			regs->sp &= ~1UL;
+			regs->regs[0] = ti->unalign_jit_tmp[0];
+			regs->regs[1] = ti->unalign_jit_tmp[1];
+			regs->regs[2] = ti->unalign_jit_tmp[2];
+			regs->regs[3] = ti->unalign_jit_tmp[3];
+			write &= 1;
+		} else {
+			pr_alert("%s/%d: ICS set at page fault at %#lx: %#lx\n",
+				 current->comm, current->pid, pc, address);
+			show_regs(regs);
+			do_group_exit(SIGKILL);
+			return;
+		}
+	}
+#else
 	/* This case should have been handled by do_page_fault_ics(). */
 	BUG_ON(write & ~1);
+#endif
 
 #if CHIP_HAS_TILE_DMA()
 	/*