Merge tag 'drm-intel-fixes-2013-11-07' of git://people.freedesktop.org/~danvet/drm-intel into drm-next

Bit a bit -fixes pull request in the merge window than usual dua to two
feauture-y things:
- Display CRCs are now enabled on all platforms, including the odd DP case
  on gm45/vlv. Since this is a testing-only feature it should ever hurt,
  but I figured it'll help with regression-testing -fixes. So I left it
  in and didn't postpone it to 3.14.
- Display power well refactoring from Imre. Would have caused major pain
  conflict with the bdw stage 1 patches if I'd postpone this to -next.
  It's only an relatively small interface rework, so shouldn't cause pain.
  It's also been in my tree since almost 3 weeks already.

That accounts for about two thirds of the pull, otherwise just bugfixes:
- vlv backlight fix from Jesse/Jani
- vlv vblank timestamp fix from Jesse
- improved edp detection through vbt from Ville (fixes a vlv issue)
- eDP vdd fix from Paulo
- fixes for dvo lvds on i830M
- a few smaller things all over

Note: This contains a backmerge of v3.12. Since the -internal branch
always applied on top of -nightly I need that unified base to merge bdw
patches. So you'll get a conflict with radeon connector props when pulling
this (and nouveau/master will also conflict a bit when Ben doesn't
rebase). The backmerge itself only had conflicts in drm/i915.

There's also a tiny conflict between Jani's backlight fix and your sysfs
lifetime fix in drm-next.

* tag 'drm-intel-fixes-2013-11-07' of git://people.freedesktop.org/~danvet/drm-intel: (940 commits)
  drm/i915/vlv: use per-pipe backlight controls v2
  drm/i915: make backlight functions take a connector
  drm/i915: move opregion asle request handling to a work queue
  drm/i915/vlv: use PIPE_START_VBLANK interrupts on VLV
  drm/i915: Make intel_dp_is_edp() less specific
  drm/i915: Give names to the VBT child device type bits
  drm/i915/vlv: enable HDA display audio for Valleyview2
  drm/i915/dvo: call ->mode_set callback only when the port is running
  drm/i915: avoid unclaimed registers when capturing the error state
  drm/i915: Enable DP port CRC for the "auto" source on g4x/vlv
  drm/i915: scramble reset support for DP port CRC on vlv
  drm/i915: scramble reset support for DP port CRC on g4x
  drm/i916: add "auto" pipe CRC source
  ...

Conflicts:
	MAINTAINERS
	drivers/gpu/drm/i915/intel_panel.c
	drivers/gpu/drm/nouveau/core/subdev/mc/base.c
	drivers/gpu/drm/radeon/atombios_encoders.c
	drivers/gpu/drm/radeon/radeon_connectors.c

1 files changed, 3 insertions, 2 deletions

diff --git a/drivers/gpio/gpio-lynxpoint.c b/drivers/gpio/gpio-lynxpoint.c
index 2d9ca60..41b5913 100644
--- a/drivers/gpio/gpio-lynxpoint.c
+++ b/drivers/gpio/gpio-lynxpoint.c
@@ -248,14 +248,15 @@ static void lp_gpio_irq_handler(unsigned irq, struct irq_desc *desc)
 	struct lp_gpio *lg = irq_data_get_irq_handler_data(data);
 	struct irq_chip *chip = irq_data_get_irq_chip(data);
 	u32 base, pin, mask;
-	unsigned long reg, pending;
+	unsigned long reg, ena, pending;
 	unsigned virq;
 
 	/* check from GPIO controller which pin triggered the interrupt */
 	for (base = 0; base < lg->chip.ngpio; base += 32) {
 		reg = lp_gpio_reg(&lg->chip, base, LP_INT_STAT);
+		ena = lp_gpio_reg(&lg->chip, base, LP_INT_ENABLE);
 
-		while ((pending = inl(reg))) {
+		while ((pending = (inl(reg) & inl(ena)))) {
 			pin = __ffs(pending);
 			mask = BIT(pin);
 			/* Clear before handling so we don't lose an edge */