drm/tilcdc: Remove obsolete crtc helper functions

Remove obsolete crtc helper functions. These are not needed when
atomic modeset is used.

Note that the drm_crtc_helper_funcs mode_fixup() is still needed. The
crtc's check() callback can not do its job here.

The plane's check() callback needs to set drm_crtc_state's
->mode_changed to true if the pixel format for the framebuffer
changes. Because of this drm_mode_config_funcs atomic_check() callback
needs to call drm_atomic_helper_check_modeset() once more after it has
called drm_atomic_helper_check_planes(). If the fixing of the
adjusted_mode would be done in drm_crtc_helper_funcs atomic_check()
callback, it would get over written by the extra
drm_atomic_helper_check_modeset() call.

Signed-off-by: Jyri Sarha <jsarha@ti.com>

1 files changed, 0 insertions, 208 deletions

diff --git a/drivers/gpu/drm/tilcdc/tilcdc_crtc.c b/drivers/gpu/drm/tilcdc/tilcdc_crtc.c
index 9a21a7f..d150b3e 100644
--- a/drivers/gpu/drm/tilcdc/tilcdc_crtc.c
+++ b/drivers/gpu/drm/tilcdc/tilcdc_crtc.c
@@ -501,209 +501,6 @@ static int tilcdc_crtc_atomic_check(struct drm_crtc *crtc,
 	return 0;
 }
 
-static int tilcdc_crtc_mode_set(struct drm_crtc *crtc,
-		struct drm_display_mode *mode,
-		struct drm_display_mode *adjusted_mode,
-		int x, int y,
-		struct drm_framebuffer *old_fb)
-{
-	struct tilcdc_crtc *tilcdc_crtc = to_tilcdc_crtc(crtc);
-	struct drm_device *dev = crtc->dev;
-	struct tilcdc_drm_private *priv = dev->dev_private;
-	const struct tilcdc_panel_info *info = tilcdc_crtc->info;
-	uint32_t reg, hbp, hfp, hsw, vbp, vfp, vsw;
-	int ret;
-
-	ret = tilcdc_crtc_mode_valid(crtc, mode);
-	if (WARN_ON(ret))
-		return ret;
-
-	if (WARN_ON(!info))
-		return -EINVAL;
-
-	ret = tilcdc_verify_fb(crtc, crtc->primary->fb);
-	if (ret)
-		return ret;
-
-	pm_runtime_get_sync(dev->dev);
-
-	/* Configure the Burst Size and fifo threshold of DMA: */
-	reg = tilcdc_read(dev, LCDC_DMA_CTRL_REG) & ~0x00000770;
-	switch (info->dma_burst_sz) {
-	case 1:
-		reg |= LCDC_DMA_BURST_SIZE(LCDC_DMA_BURST_1);
-		break;
-	case 2:
-		reg |= LCDC_DMA_BURST_SIZE(LCDC_DMA_BURST_2);
-		break;
-	case 4:
-		reg |= LCDC_DMA_BURST_SIZE(LCDC_DMA_BURST_4);
-		break;
-	case 8:
-		reg |= LCDC_DMA_BURST_SIZE(LCDC_DMA_BURST_8);
-		break;
-	case 16:
-		reg |= LCDC_DMA_BURST_SIZE(LCDC_DMA_BURST_16);
-		break;
-	default:
-		return -EINVAL;
-	}
-	reg |= (info->fifo_th << 8);
-	tilcdc_write(dev, LCDC_DMA_CTRL_REG, reg);
-
-	/* Configure timings: */
-	hbp = mode->htotal - mode->hsync_end;
-	hfp = mode->hsync_start - mode->hdisplay;
-	hsw = mode->hsync_end - mode->hsync_start;
-	vbp = mode->vtotal - mode->vsync_end;
-	vfp = mode->vsync_start - mode->vdisplay;
-	vsw = mode->vsync_end - mode->vsync_start;
-
-	DBG("%dx%d, hbp=%u, hfp=%u, hsw=%u, vbp=%u, vfp=%u, vsw=%u",
-			mode->hdisplay, mode->vdisplay, hbp, hfp, hsw, vbp, vfp, vsw);
-
-	/* Configure the AC Bias Period and Number of Transitions per Interrupt: */
-	reg = tilcdc_read(dev, LCDC_RASTER_TIMING_2_REG) & ~0x000fff00;
-	reg |= LCDC_AC_BIAS_FREQUENCY(info->ac_bias) |
-		LCDC_AC_BIAS_TRANSITIONS_PER_INT(info->ac_bias_intrpt);
-
-	/*
-	 * subtract one from hfp, hbp, hsw because the hardware uses
-	 * a value of 0 as 1
-	 */
-	if (priv->rev == 2) {
-		/* clear bits we're going to set */
-		reg &= ~0x78000033;
-		reg |= ((hfp-1) & 0x300) >> 8;
-		reg |= ((hbp-1) & 0x300) >> 4;
-		reg |= ((hsw-1) & 0x3c0) << 21;
-	}
-	tilcdc_write(dev, LCDC_RASTER_TIMING_2_REG, reg);
-
-	reg = (((mode->hdisplay >> 4) - 1) << 4) |
-		(((hbp-1) & 0xff) << 24) |
-		(((hfp-1) & 0xff) << 16) |
-		(((hsw-1) & 0x3f) << 10);
-	if (priv->rev == 2)
-		reg |= (((mode->hdisplay >> 4) - 1) & 0x40) >> 3;
-	tilcdc_write(dev, LCDC_RASTER_TIMING_0_REG, reg);
-
-	reg = ((mode->vdisplay - 1) & 0x3ff) |
-		((vbp & 0xff) << 24) |
-		((vfp & 0xff) << 16) |
-		(((vsw-1) & 0x3f) << 10);
-	tilcdc_write(dev, LCDC_RASTER_TIMING_1_REG, reg);
-
-	/*
-	 * be sure to set Bit 10 for the V2 LCDC controller,
-	 * otherwise limited to 1024 pixels width, stopping
-	 * 1920x1080 being suppoted.
-	 */
-	if (priv->rev == 2) {
-		if ((mode->vdisplay - 1) & 0x400) {
-			tilcdc_set(dev, LCDC_RASTER_TIMING_2_REG,
-				LCDC_LPP_B10);
-		} else {
-			tilcdc_clear(dev, LCDC_RASTER_TIMING_2_REG,
-				LCDC_LPP_B10);
-		}
-	}
-
-	/* Configure display type: */
-	reg = tilcdc_read(dev, LCDC_RASTER_CTRL_REG) &
-		~(LCDC_TFT_MODE | LCDC_MONO_8BIT_MODE | LCDC_MONOCHROME_MODE |
-			LCDC_V2_TFT_24BPP_MODE | LCDC_V2_TFT_24BPP_UNPACK | 0x000ff000);
-	reg |= LCDC_TFT_MODE; /* no monochrome/passive support */
-	if (info->tft_alt_mode)
-		reg |= LCDC_TFT_ALT_ENABLE;
-	if (priv->rev == 2) {
-		unsigned int depth, bpp;
-
-		drm_fb_get_bpp_depth(crtc->primary->fb->pixel_format, &depth, &bpp);
-		switch (bpp) {
-		case 16:
-			break;
-		case 32:
-			reg |= LCDC_V2_TFT_24BPP_UNPACK;
-			/* fallthrough */
-		case 24:
-			reg |= LCDC_V2_TFT_24BPP_MODE;
-			break;
-		default:
-			dev_err(dev->dev, "invalid pixel format\n");
-			return -EINVAL;
-		}
-	}
-	reg |= info->fdd < 12;
-	tilcdc_write(dev, LCDC_RASTER_CTRL_REG, reg);
-
-	if (info->invert_pxl_clk)
-		tilcdc_set(dev, LCDC_RASTER_TIMING_2_REG, LCDC_INVERT_PIXEL_CLOCK);
-	else
-		tilcdc_clear(dev, LCDC_RASTER_TIMING_2_REG, LCDC_INVERT_PIXEL_CLOCK);
-
-	if (info->sync_ctrl)
-		tilcdc_set(dev, LCDC_RASTER_TIMING_2_REG, LCDC_SYNC_CTRL);
-	else
-		tilcdc_clear(dev, LCDC_RASTER_TIMING_2_REG, LCDC_SYNC_CTRL);
-
-	if (info->sync_edge)
-		tilcdc_set(dev, LCDC_RASTER_TIMING_2_REG, LCDC_SYNC_EDGE);
-	else
-		tilcdc_clear(dev, LCDC_RASTER_TIMING_2_REG, LCDC_SYNC_EDGE);
-
-	/*
-	 * use value from adjusted_mode here as this might have been
-	 * changed as part of the fixup for slave encoders to solve the
-	 * issue where tilcdc timings are not VESA compliant
-	 */
-	if (adjusted_mode->flags & DRM_MODE_FLAG_NHSYNC)
-		tilcdc_set(dev, LCDC_RASTER_TIMING_2_REG, LCDC_INVERT_HSYNC);
-	else
-		tilcdc_clear(dev, LCDC_RASTER_TIMING_2_REG, LCDC_INVERT_HSYNC);
-
-	if (mode->flags & DRM_MODE_FLAG_NVSYNC)
-		tilcdc_set(dev, LCDC_RASTER_TIMING_2_REG, LCDC_INVERT_VSYNC);
-	else
-		tilcdc_clear(dev, LCDC_RASTER_TIMING_2_REG, LCDC_INVERT_VSYNC);
-
-	if (info->raster_order)
-		tilcdc_set(dev, LCDC_RASTER_CTRL_REG, LCDC_RASTER_ORDER);
-	else
-		tilcdc_clear(dev, LCDC_RASTER_CTRL_REG, LCDC_RASTER_ORDER);
-
-	drm_framebuffer_reference(crtc->primary->fb);
-
-	set_scanout(crtc, crtc->primary->fb);
-
-	tilcdc_crtc_update_clk(crtc);
-
-	pm_runtime_put_sync(dev->dev);
-
-	return 0;
-}
-
-static int tilcdc_crtc_mode_set_base(struct drm_crtc *crtc, int x, int y,
-		struct drm_framebuffer *old_fb)
-{
-	struct drm_device *dev = crtc->dev;
-	int r;
-
-	r = tilcdc_verify_fb(crtc, crtc->primary->fb);
-	if (r)
-		return r;
-
-	drm_framebuffer_reference(crtc->primary->fb);
-
-	pm_runtime_get_sync(dev->dev);
-
-	set_scanout(crtc, crtc->primary->fb);
-
-	pm_runtime_put_sync(dev->dev);
-
-	return 0;
-}
-
 static const struct drm_crtc_funcs tilcdc_crtc_funcs = {
 	.destroy        = tilcdc_crtc_destroy,
 	.set_config     = drm_atomic_helper_set_config,
@@ -714,12 +511,7 @@ static const struct drm_crtc_funcs tilcdc_crtc_funcs = {
 };
 
 static const struct drm_crtc_helper_funcs tilcdc_crtc_helper_funcs = {
-		.dpms           = tilcdc_crtc_dpms,
 		.mode_fixup     = tilcdc_crtc_mode_fixup,
-		.prepare        = tilcdc_crtc_disable,
-		.commit         = tilcdc_crtc_enable,
-		.mode_set       = tilcdc_crtc_mode_set,
-		.mode_set_base  = tilcdc_crtc_mode_set_base,
 		.enable		= tilcdc_crtc_enable,
 		.disable	= tilcdc_crtc_disable,
 		.atomic_check	= tilcdc_crtc_atomic_check,