Merge tag 'drm-intel-fixes-2013-11-07' of git://people.freedesktop.org/~danvet/drm-intel into drm-next

Bit a bit -fixes pull request in the merge window than usual dua to two
feauture-y things:
- Display CRCs are now enabled on all platforms, including the odd DP case
  on gm45/vlv. Since this is a testing-only feature it should ever hurt,
  but I figured it'll help with regression-testing -fixes. So I left it
  in and didn't postpone it to 3.14.
- Display power well refactoring from Imre. Would have caused major pain
  conflict with the bdw stage 1 patches if I'd postpone this to -next.
  It's only an relatively small interface rework, so shouldn't cause pain.
  It's also been in my tree since almost 3 weeks already.

That accounts for about two thirds of the pull, otherwise just bugfixes:
- vlv backlight fix from Jesse/Jani
- vlv vblank timestamp fix from Jesse
- improved edp detection through vbt from Ville (fixes a vlv issue)
- eDP vdd fix from Paulo
- fixes for dvo lvds on i830M
- a few smaller things all over

Note: This contains a backmerge of v3.12. Since the -internal branch
always applied on top of -nightly I need that unified base to merge bdw
patches. So you'll get a conflict with radeon connector props when pulling
this (and nouveau/master will also conflict a bit when Ben doesn't
rebase). The backmerge itself only had conflicts in drm/i915.

There's also a tiny conflict between Jani's backlight fix and your sysfs
lifetime fix in drm-next.

* tag 'drm-intel-fixes-2013-11-07' of git://people.freedesktop.org/~danvet/drm-intel: (940 commits)
  drm/i915/vlv: use per-pipe backlight controls v2
  drm/i915: make backlight functions take a connector
  drm/i915: move opregion asle request handling to a work queue
  drm/i915/vlv: use PIPE_START_VBLANK interrupts on VLV
  drm/i915: Make intel_dp_is_edp() less specific
  drm/i915: Give names to the VBT child device type bits
  drm/i915/vlv: enable HDA display audio for Valleyview2
  drm/i915/dvo: call ->mode_set callback only when the port is running
  drm/i915: avoid unclaimed registers when capturing the error state
  drm/i915: Enable DP port CRC for the "auto" source on g4x/vlv
  drm/i915: scramble reset support for DP port CRC on vlv
  drm/i915: scramble reset support for DP port CRC on g4x
  drm/i916: add "auto" pipe CRC source
  ...

Conflicts:
	MAINTAINERS
	drivers/gpu/drm/i915/intel_panel.c
	drivers/gpu/drm/nouveau/core/subdev/mc/base.c
	drivers/gpu/drm/radeon/atombios_encoders.c
	drivers/gpu/drm/radeon/radeon_connectors.c

1 files changed, 20 insertions, 0 deletions

diff --git a/drivers/md/raid5.c b/drivers/md/raid5.c
index 7ff4f25..f8b9068 100644
--- a/drivers/md/raid5.c
+++ b/drivers/md/raid5.c
@@ -778,6 +778,12 @@ static void ops_run_io(struct stripe_head *sh, struct stripe_head_state *s)
 			bi->bi_io_vec[0].bv_len = STRIPE_SIZE;
 			bi->bi_io_vec[0].bv_offset = 0;
 			bi->bi_size = STRIPE_SIZE;
+			/*
+			 * If this is discard request, set bi_vcnt 0. We don't
+			 * want to confuse SCSI because SCSI will replace payload
+			 */
+			if (rw & REQ_DISCARD)
+				bi->bi_vcnt = 0;
 			if (rrdev)
 				set_bit(R5_DOUBLE_LOCKED, &sh->dev[i].flags);
 
@@ -816,6 +822,12 @@ static void ops_run_io(struct stripe_head *sh, struct stripe_head_state *s)
 			rbi->bi_io_vec[0].bv_len = STRIPE_SIZE;
 			rbi->bi_io_vec[0].bv_offset = 0;
 			rbi->bi_size = STRIPE_SIZE;
+			/*
+			 * If this is discard request, set bi_vcnt 0. We don't
+			 * want to confuse SCSI because SCSI will replace payload
+			 */
+			if (rw & REQ_DISCARD)
+				rbi->bi_vcnt = 0;
 			if (conf->mddev->gendisk)
 				trace_block_bio_remap(bdev_get_queue(rbi->bi_bdev),
 						      rbi, disk_devt(conf->mddev->gendisk),
@@ -2910,6 +2922,14 @@ static void handle_stripe_clean_event(struct r5conf *conf,
 		}
 		/* now that discard is done we can proceed with any sync */
 		clear_bit(STRIPE_DISCARD, &sh->state);
+		/*
+		 * SCSI discard will change some bio fields and the stripe has
+		 * no updated data, so remove it from hash list and the stripe
+		 * will be reinitialized
+		 */
+		spin_lock_irq(&conf->device_lock);
+		remove_hash(sh);
+		spin_unlock_irq(&conf->device_lock);
 		if (test_bit(STRIPE_SYNC_REQUESTED, &sh->state))
 			set_bit(STRIPE_HANDLE, &sh->state);