net/mlx4_core: Enable device recovery flow with SRIOV

In SRIOV, both the PF and the VF may attempt device recovery whenever they
assume that the device is not functioning.  When the PF driver resets the
device, the VF should detect this and attempt to reinitialize itself.

The VF must be able to reset itself under all circumstances, even
if the PF is not responsive.

The VF shall reset itself in the following cases:

1. Commands are not processed within reasonable time over the communication channel.
This is done considering device state and the correct return code based on
the command as was done in the native mode, done in the next patch.

2. The VF driver receives an internal error event reported by the PF on the
communication channel. This occurs when the PF driver resets the device or
when VF is out of sync with the PF.

Add 'VF reset' capability, which allows the VF to reinitialize itself even when the
PF is not responsive.

As PF and VF may run their reset flow simulantanisly, there are several cases
that are handled:
- Prevent freeing VF resources upon FLR, when PF is in its unloading stage.
- Prevent PF getting VF commands before it has finished initializing its resources.
- Upon VF startup, check that comm-channel is online before sending
  commands to the PF and getting timed-out.

Signed-off-by: Yishai Hadas <yishaih@mellanox.com>
Signed-off-by: Or Gerlitz <ogerlitz@mellanox.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

1 files changed, 103 insertions, 17 deletions

diff --git a/drivers/net/ethernet/mellanox/mlx4/catas.c b/drivers/net/ethernet/mellanox/mlx4/catas.c
index 3fcf3cf..715de8a 100644
--- a/drivers/net/ethernet/mellanox/mlx4/catas.c
+++ b/drivers/net/ethernet/mellanox/mlx4/catas.c
@@ -45,8 +45,7 @@ enum {
 int mlx4_internal_err_reset = 1;
 module_param_named(internal_err_reset, mlx4_internal_err_reset,  int, 0644);
 MODULE_PARM_DESC(internal_err_reset,
-		 "Reset device on internal errors if non-zero"
-		 " (default 1, in SRIOV mode default is 0)");
+		 "Reset device on internal errors if non-zero (default 1)");
 
 static int read_vendor_id(struct mlx4_dev *dev)
 {
@@ -71,6 +70,9 @@ static int mlx4_reset_master(struct mlx4_dev *dev)
 {
 	int err = 0;
 
+	if (mlx4_is_master(dev))
+		mlx4_report_internal_err_comm_event(dev);
+
 	if (!pci_channel_offline(dev->persist->pdev)) {
 		err = read_vendor_id(dev);
 		/* If PCI can't be accessed to read vendor ID we assume that its
@@ -87,6 +89,81 @@ static int mlx4_reset_master(struct mlx4_dev *dev)
 	return err;
 }
 
+static int mlx4_reset_slave(struct mlx4_dev *dev)
+{
+#define COM_CHAN_RST_REQ_OFFSET 0x10
+#define COM_CHAN_RST_ACK_OFFSET 0x08
+
+	u32 comm_flags;
+	u32 rst_req;
+	u32 rst_ack;
+	unsigned long end;
+	struct mlx4_priv *priv = mlx4_priv(dev);
+
+	if (pci_channel_offline(dev->persist->pdev))
+		return 0;
+
+	comm_flags = swab32(readl((__iomem char *)priv->mfunc.comm +
+				  MLX4_COMM_CHAN_FLAGS));
+	if (comm_flags == 0xffffffff) {
+		mlx4_err(dev, "VF reset is not needed\n");
+		return 0;
+	}
+
+	if (!(dev->caps.vf_caps & MLX4_VF_CAP_FLAG_RESET)) {
+		mlx4_err(dev, "VF reset is not supported\n");
+		return -EOPNOTSUPP;
+	}
+
+	rst_req = (comm_flags & (u32)(1 << COM_CHAN_RST_REQ_OFFSET)) >>
+		COM_CHAN_RST_REQ_OFFSET;
+	rst_ack = (comm_flags & (u32)(1 << COM_CHAN_RST_ACK_OFFSET)) >>
+		COM_CHAN_RST_ACK_OFFSET;
+	if (rst_req != rst_ack) {
+		mlx4_err(dev, "Communication channel isn't sync, fail to send reset\n");
+		return -EIO;
+	}
+
+	rst_req ^= 1;
+	mlx4_warn(dev, "VF is sending reset request to Firmware\n");
+	comm_flags = rst_req << COM_CHAN_RST_REQ_OFFSET;
+	__raw_writel((__force u32)cpu_to_be32(comm_flags),
+		     (__iomem char *)priv->mfunc.comm + MLX4_COMM_CHAN_FLAGS);
+	/* Make sure that our comm channel write doesn't
+	 * get mixed in with writes from another CPU.
+	 */
+	mmiowb();
+
+	end = msecs_to_jiffies(MLX4_COMM_TIME) + jiffies;
+	while (time_before(jiffies, end)) {
+		comm_flags = swab32(readl((__iomem char *)priv->mfunc.comm +
+					  MLX4_COMM_CHAN_FLAGS));
+		rst_ack = (comm_flags & (u32)(1 << COM_CHAN_RST_ACK_OFFSET)) >>
+			COM_CHAN_RST_ACK_OFFSET;
+
+		/* Reading rst_req again since the communication channel can
+		 * be reset at any time by the PF and all its bits will be
+		 * set to zero.
+		 */
+		rst_req = (comm_flags & (u32)(1 << COM_CHAN_RST_REQ_OFFSET)) >>
+			COM_CHAN_RST_REQ_OFFSET;
+
+		if (rst_ack == rst_req) {
+			mlx4_warn(dev, "VF Reset succeed\n");
+			return 0;
+		}
+		cond_resched();
+	}
+	mlx4_err(dev, "Fail to send reset over the communication channel\n");
+	return -ETIMEDOUT;
+}
+
+static int mlx4_comm_internal_err(u32 slave_read)
+{
+	return (u32)COMM_CHAN_EVENT_INTERNAL_ERR ==
+		(slave_read & (u32)COMM_CHAN_EVENT_INTERNAL_ERR) ? 1 : 0;
+}
+
 void mlx4_enter_error_state(struct mlx4_dev_persistent *persist)
 {
 	int err;
@@ -101,7 +178,10 @@ void mlx4_enter_error_state(struct mlx4_dev_persistent *persist)
 
 	dev = persist->dev;
 	mlx4_err(dev, "device is going to be reset\n");
-	err = mlx4_reset_master(dev);
+	if (mlx4_is_slave(dev))
+		err = mlx4_reset_slave(dev);
+	else
+		err = mlx4_reset_master(dev);
 	BUG_ON(err != 0);
 
 	dev->persist->state |= MLX4_DEVICE_STATE_INTERNAL_ERROR;
@@ -148,8 +228,15 @@ static void poll_catas(unsigned long dev_ptr)
 {
 	struct mlx4_dev *dev = (struct mlx4_dev *) dev_ptr;
 	struct mlx4_priv *priv = mlx4_priv(dev);
-
-	if (readl(priv->catas_err.map)) {
+	u32 slave_read;
+
+	if (mlx4_is_slave(dev)) {
+		slave_read = swab32(readl(&priv->mfunc.comm->slave_read));
+		if (mlx4_comm_internal_err(slave_read)) {
+			mlx4_warn(dev, "Internal error detected on the communication channel\n");
+			goto internal_err;
+		}
+	} else if (readl(priv->catas_err.map)) {
 		dump_err_buf(dev);
 		goto internal_err;
 	}
@@ -182,22 +269,21 @@ void mlx4_start_catas_poll(struct mlx4_dev *dev)
 	struct mlx4_priv *priv = mlx4_priv(dev);
 	phys_addr_t addr;
 
-	/*If we are in SRIOV the default of the module param must be 0*/
-	if (mlx4_is_mfunc(dev))
-		mlx4_internal_err_reset = 0;
-
 	INIT_LIST_HEAD(&priv->catas_err.list);
 	init_timer(&priv->catas_err.timer);
 	priv->catas_err.map = NULL;
 
-	addr = pci_resource_start(dev->persist->pdev, priv->fw.catas_bar) +
-		priv->fw.catas_offset;
-
-	priv->catas_err.map = ioremap(addr, priv->fw.catas_size * 4);
-	if (!priv->catas_err.map) {
-		mlx4_warn(dev, "Failed to map internal error buffer at 0x%llx\n",
-			  (unsigned long long) addr);
-		return;
+	if (!mlx4_is_slave(dev)) {
+		addr = pci_resource_start(dev->persist->pdev,
+					  priv->fw.catas_bar) +
+					  priv->fw.catas_offset;
+
+		priv->catas_err.map = ioremap(addr, priv->fw.catas_size * 4);
+		if (!priv->catas_err.map) {
+			mlx4_warn(dev, "Failed to map internal error buffer at 0x%llx\n",
+				  (unsigned long long)addr);
+			return;
+		}
 	}
 
 	priv->catas_err.timer.data     = (unsigned long) dev;