pinctrl: mediatek: Add Pinctrl/GPIO/EINT driver for mt2701

Add mt2701 support using mediatek common pinctrl driver.
MT2701 have some special pins need an extra setting register
than other ICs, so adding this support to common code.

Signed-off-by: Biao Huang <biao.huang@mediatek.com>
Acked-by: Yingjoe Chen <yingjoe.chen@mediatek.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

1 files changed, 11 insertions, 1 deletions

diff --git a/drivers/pinctrl/mediatek/pinctrl-mtk-common.h b/drivers/pinctrl/mediatek/pinctrl-mtk-common.h
index 55a5343..8543bc4 100644
--- a/drivers/pinctrl/mediatek/pinctrl-mtk-common.h
+++ b/drivers/pinctrl/mediatek/pinctrl-mtk-common.h
@@ -209,7 +209,14 @@ struct mtk_eint_offsets {
  * means when user set smt, input enable is set at the same time. So they
  * also need special control. If special control is success, this should
  * return 0, otherwise return non-zero value.
- *
+ * @spec_pinmux_set: In some cases, there are two pinmux functions share
+ * the same value in the same segment of pinmux control register. If user
+ * want to use one of the two functions, they need an extra bit setting to
+ * select the right one.
+ * @spec_dir_set: In very few SoCs, direction control registers are not
+ * arranged continuously, they may be cut to parts. So they need special
+ * dir setting.
+
  * @dir_offset: The direction register offset.
  * @pullen_offset: The pull-up/pull-down enable register offset.
  * @pinmux_offset: The pinmux register offset.
@@ -234,6 +241,9 @@ struct mtk_pinctrl_devdata {
 			unsigned char align, bool isup, unsigned int arg);
 	int (*spec_ies_smt_set)(struct regmap *reg, unsigned int pin,
 			unsigned char align, int value, enum pin_config_param arg);
+	void (*spec_pinmux_set)(struct regmap *reg, unsigned int pin,
+			unsigned int mode);
+	void (*spec_dir_set)(unsigned int *reg_addr, unsigned int pin);
 	unsigned int dir_offset;
 	unsigned int ies_offset;
 	unsigned int smt_offset;