diff options
-rw-r--r-- | drivers/net/ethernet/altera/altera_tse_main.c | 37 |
1 files changed, 29 insertions, 8 deletions
diff --git a/drivers/net/ethernet/altera/altera_tse_main.c b/drivers/net/ethernet/altera/altera_tse_main.c index 90a7630..0533c05 100644 --- a/drivers/net/ethernet/altera/altera_tse_main.c +++ b/drivers/net/ethernet/altera/altera_tse_main.c @@ -777,6 +777,8 @@ static int init_phy(struct net_device *dev) struct altera_tse_private *priv = netdev_priv(dev); struct phy_device *phydev; struct device_node *phynode; + bool fixed_link = false; + int rc = 0; /* Avoid init phy in case of no phy present */ if (!priv->phy_iface) @@ -789,13 +791,32 @@ static int init_phy(struct net_device *dev) phynode = of_parse_phandle(priv->device->of_node, "phy-handle", 0); if (!phynode) { - netdev_dbg(dev, "no phy-handle found\n"); - if (!priv->mdio) { - netdev_err(dev, - "No phy-handle nor local mdio specified\n"); - return -ENODEV; + /* check if a fixed-link is defined in device-tree */ + if (of_phy_is_fixed_link(priv->device->of_node)) { + rc = of_phy_register_fixed_link(priv->device->of_node); + if (rc < 0) { + netdev_err(dev, "cannot register fixed PHY\n"); + return rc; + } + + /* In the case of a fixed PHY, the DT node associated + * to the PHY is the Ethernet MAC DT node. + */ + phynode = of_node_get(priv->device->of_node); + fixed_link = true; + + netdev_dbg(dev, "fixed-link detected\n"); + phydev = of_phy_connect(dev, phynode, + &altera_tse_adjust_link, + 0, priv->phy_iface); + } else { + netdev_dbg(dev, "no phy-handle found\n"); + if (!priv->mdio) { + netdev_err(dev, "No phy-handle nor local mdio specified\n"); + return -ENODEV; + } + phydev = connect_local_phy(dev); } - phydev = connect_local_phy(dev); } else { netdev_dbg(dev, "phy-handle found\n"); phydev = of_phy_connect(dev, phynode, @@ -819,10 +840,10 @@ static int init_phy(struct net_device *dev) /* Broken HW is sometimes missing the pull-up resistor on the * MDIO line, which results in reads to non-existent devices returning * 0 rather than 0xffff. Catch this here and treat 0 as a non-existent - * device as well. + * device as well. If a fixed-link is used the phy_id is always 0. * Note: phydev->phy_id is the result of reading the UID PHY registers. */ - if (phydev->phy_id == 0) { + if ((phydev->phy_id == 0) && !fixed_link) { netdev_err(dev, "Bad PHY UID 0x%08x\n", phydev->phy_id); phy_disconnect(phydev); return -ENODEV; |