diff options
-rw-r--r-- | Documentation/devicetree/bindings/spi/qcom,spi-qup.txt | 6 | ||||
-rw-r--r-- | drivers/spi/spi-qup.c | 36 |
2 files changed, 27 insertions, 15 deletions
diff --git a/Documentation/devicetree/bindings/spi/qcom,spi-qup.txt b/Documentation/devicetree/bindings/spi/qcom,spi-qup.txt index b82a268..775a2d8 100644 --- a/Documentation/devicetree/bindings/spi/qcom,spi-qup.txt +++ b/Documentation/devicetree/bindings/spi/qcom,spi-qup.txt @@ -7,7 +7,11 @@ SPI in master mode supports up to 50MHz, up to four chip selects, programmable data path from 4 bits to 32 bits and numerous protocol variants. Required properties: -- compatible: Should contain "qcom,spi-qup-v2.1.1" or "qcom,spi-qup-v2.2.1" +- compatible: Should contain: + "qcom,spi-qup-v1.1.1" for 8660, 8960 and 8064. + "qcom,spi-qup-v2.1.1" for 8974 and later + "qcom,spi-qup-v2.2.1" for 8974 v2 and later. + - reg: Should contain base register location and length - interrupts: Interrupt number used by this controller diff --git a/drivers/spi/spi-qup.c b/drivers/spi/spi-qup.c index fc1de86..f5b646e 100644 --- a/drivers/spi/spi-qup.c +++ b/drivers/spi/spi-qup.c @@ -142,6 +142,7 @@ struct spi_qup { int w_size; /* bytes per SPI word */ int tx_bytes; int rx_bytes; + int qup_v1; }; @@ -420,7 +421,9 @@ static int spi_qup_io_config(struct spi_device *spi, struct spi_transfer *xfer) config |= QUP_CONFIG_SPI_MODE; writel_relaxed(config, controller->base + QUP_CONFIG); - writel_relaxed(0, controller->base + QUP_OPERATIONAL_MASK); + /* only write to OPERATIONAL_MASK when register is present */ + if (!controller->qup_v1) + writel_relaxed(0, controller->base + QUP_OPERATIONAL_MASK); return 0; } @@ -511,7 +514,7 @@ static int spi_qup_probe(struct platform_device *pdev) struct resource *res; struct device *dev; void __iomem *base; - u32 data, max_freq, iomode; + u32 max_freq, iomode; int ret, irq, size; dev = &pdev->dev; @@ -554,15 +557,6 @@ static int spi_qup_probe(struct platform_device *pdev) return ret; } - data = readl_relaxed(base + QUP_HW_VERSION); - - if (data < QUP_HW_VERSION_2_1_1) { - clk_disable_unprepare(cclk); - clk_disable_unprepare(iclk); - dev_err(dev, "v.%08x is not supported\n", data); - return -ENXIO; - } - master = spi_alloc_master(dev, sizeof(struct spi_qup)); if (!master) { clk_disable_unprepare(cclk); @@ -591,6 +585,10 @@ static int spi_qup_probe(struct platform_device *pdev) controller->cclk = cclk; controller->irq = irq; + /* set v1 flag if device is version 1 */ + if (of_device_is_compatible(dev->of_node, "qcom,spi-qup-v1.1.1")) + controller->qup_v1 = 1; + spin_lock_init(&controller->lock); init_completion(&controller->done); @@ -614,8 +612,8 @@ static int spi_qup_probe(struct platform_device *pdev) size = QUP_IO_M_INPUT_FIFO_SIZE(iomode); controller->in_fifo_sz = controller->in_blk_sz * (2 << size); - dev_info(dev, "v.%08x IN:block:%d, fifo:%d, OUT:block:%d, fifo:%d\n", - data, controller->in_blk_sz, controller->in_fifo_sz, + dev_info(dev, "IN:block:%d, fifo:%d, OUT:block:%d, fifo:%d\n", + controller->in_blk_sz, controller->in_fifo_sz, controller->out_blk_sz, controller->out_fifo_sz); writel_relaxed(1, base + QUP_SW_RESET); @@ -628,10 +626,19 @@ static int spi_qup_probe(struct platform_device *pdev) writel_relaxed(0, base + QUP_OPERATIONAL); writel_relaxed(0, base + QUP_IO_M_MODES); - writel_relaxed(0, base + QUP_OPERATIONAL_MASK); + + if (!controller->qup_v1) + writel_relaxed(0, base + QUP_OPERATIONAL_MASK); + writel_relaxed(SPI_ERROR_CLK_UNDER_RUN | SPI_ERROR_CLK_OVER_RUN, base + SPI_ERROR_FLAGS_EN); + /* if earlier version of the QUP, disable INPUT_OVERRUN */ + if (controller->qup_v1) + writel_relaxed(QUP_ERROR_OUTPUT_OVER_RUN | + QUP_ERROR_INPUT_UNDER_RUN | QUP_ERROR_OUTPUT_UNDER_RUN, + base + QUP_ERROR_FLAGS_EN); + writel_relaxed(0, base + SPI_CONFIG); writel_relaxed(SPI_IO_C_NO_TRI_STATE, base + SPI_IO_CONTROL); @@ -750,6 +757,7 @@ static int spi_qup_remove(struct platform_device *pdev) } static const struct of_device_id spi_qup_dt_match[] = { + { .compatible = "qcom,spi-qup-v1.1.1", }, { .compatible = "qcom,spi-qup-v2.1.1", }, { .compatible = "qcom,spi-qup-v2.2.1", }, { } |