diff options
Diffstat (limited to 'arch/arm/mach-omap2/gpmc-smsc911x.c')
| -rw-r--r-- | arch/arm/mach-omap2/gpmc-smsc911x.c | 65 |
1 files changed, 2 insertions, 63 deletions
diff --git a/arch/arm/mach-omap2/gpmc-smsc911x.c b/arch/arm/mach-omap2/gpmc-smsc911x.c index 5e5880d..b6c77be 100644 --- a/arch/arm/mach-omap2/gpmc-smsc911x.c +++ b/arch/arm/mach-omap2/gpmc-smsc911x.c @@ -19,15 +19,11 @@ #include <linux/interrupt.h> #include <linux/io.h> #include <linux/smsc911x.h> -#include <linux/regulator/fixed.h> -#include <linux/regulator/machine.h> #include <plat/board.h> #include <plat/gpmc.h> #include <plat/gpmc-smsc911x.h> -static struct omap_smsc911x_platform_data *gpmc_cfg; - static struct resource gpmc_smsc911x_resources[] = { [0] = { .flags = IORESOURCE_MEM, @@ -41,51 +37,6 @@ static struct smsc911x_platform_config gpmc_smsc911x_config = { .phy_interface = PHY_INTERFACE_MODE_MII, .irq_polarity = SMSC911X_IRQ_POLARITY_ACTIVE_LOW, .irq_type = SMSC911X_IRQ_TYPE_OPEN_DRAIN, - .flags = SMSC911X_USE_16BIT, -}; - -static struct regulator_consumer_supply gpmc_smsc911x_supply[] = { - REGULATOR_SUPPLY("vddvario", "smsc911x.0"), - REGULATOR_SUPPLY("vdd33a", "smsc911x.0"), -}; - -/* Generic regulator definition to satisfy smsc911x */ -static struct regulator_init_data gpmc_smsc911x_reg_init_data = { - .constraints = { - .min_uV = 3300000, - .max_uV = 3300000, - .valid_modes_mask = REGULATOR_MODE_NORMAL - | REGULATOR_MODE_STANDBY, - .valid_ops_mask = REGULATOR_CHANGE_MODE - | REGULATOR_CHANGE_STATUS, - }, - .num_consumer_supplies = ARRAY_SIZE(gpmc_smsc911x_supply), - .consumer_supplies = gpmc_smsc911x_supply, -}; - -static struct fixed_voltage_config gpmc_smsc911x_fixed_reg_data = { - .supply_name = "gpmc_smsc911x", - .microvolts = 3300000, - .gpio = -EINVAL, - .startup_delay = 0, - .enable_high = 0, - .enabled_at_boot = 1, - .init_data = &gpmc_smsc911x_reg_init_data, -}; - -/* - * Platform device id of 42 is a temporary fix to avoid conflicts - * with other reg-fixed-voltage devices. The real fix should - * involve the driver core providing a way of dynamically - * assigning a unique id on registration for platform devices - * in the same name space. - */ -static struct platform_device gpmc_smsc911x_regulator = { - .name = "reg-fixed-voltage", - .id = 42, - .dev = { - .platform_data = &gpmc_smsc911x_fixed_reg_data, - }, }; /* @@ -93,23 +44,12 @@ static struct platform_device gpmc_smsc911x_regulator = { * assume that pin multiplexing is done in the board-*.c file, * or in the bootloader. */ -void __init gpmc_smsc911x_init(struct omap_smsc911x_platform_data *board_data) +void __init gpmc_smsc911x_init(struct omap_smsc911x_platform_data *gpmc_cfg) { struct platform_device *pdev; unsigned long cs_mem_base; int ret; - gpmc_cfg = board_data; - - if (!gpmc_cfg->id) { - ret = platform_device_register(&gpmc_smsc911x_regulator); - if (ret < 0) { - pr_err("Unable to register smsc911x regulators: %d\n", - ret); - return; - } - } - if (gpmc_cs_request(gpmc_cfg->cs, SZ_16M, &cs_mem_base) < 0) { pr_err("Failed to request GPMC mem region\n"); return; @@ -139,8 +79,7 @@ void __init gpmc_smsc911x_init(struct omap_smsc911x_platform_data *board_data) gpio_set_value(gpmc_cfg->gpio_reset, 1); } - if (gpmc_cfg->flags) - gpmc_smsc911x_config.flags = gpmc_cfg->flags; + gpmc_smsc911x_config.flags = gpmc_cfg->flags ? : SMSC911X_USE_16BIT; pdev = platform_device_register_resndata(NULL, "smsc911x", gpmc_cfg->id, gpmc_smsc911x_resources, ARRAY_SIZE(gpmc_smsc911x_resources), |