diff options
Diffstat (limited to 'arch/x86/boot/compressed/head_64.S')
| -rw-r--r-- | arch/x86/boot/compressed/head_64.S | 169 |
1 files changed, 88 insertions, 81 deletions
diff --git a/arch/x86/boot/compressed/head_64.S b/arch/x86/boot/compressed/head_64.S index ed4a829..f62c284 100644 --- a/arch/x86/boot/compressed/head_64.S +++ b/arch/x86/boot/compressed/head_64.S @@ -21,8 +21,8 @@ /* * High loaded stuff by Hans Lermen & Werner Almesberger, Feb. 1996 */ -.code32 -.text + .code32 + .text #include <linux/linkage.h> #include <asm/segment.h> @@ -33,12 +33,14 @@ #include <asm/processor-flags.h> #include <asm/asm-offsets.h> -.section ".text.head" + .section ".text.head" .code32 ENTRY(startup_32) cld - /* test KEEP_SEGMENTS flag to see if the bootloader is asking - * us to not reload segments */ + /* + * Test KEEP_SEGMENTS flag to see if the bootloader is asking + * us to not reload segments + */ testb $(1<<6), BP_loadflags(%esi) jnz 1f @@ -49,14 +51,15 @@ ENTRY(startup_32) movl %eax, %ss 1: -/* Calculate the delta between where we were compiled to run +/* + * Calculate the delta between where we were compiled to run * at and where we were actually loaded at. This can only be done * with a short local call on x86. Nothing else will tell us what * address we are running at. The reserved chunk of the real-mode * data at 0x1e4 (defined as a scratch field) are used as the stack * for this calculation. Only 4 bytes are needed. */ - leal (0x1e4+4)(%esi), %esp + leal (BP_scratch+4)(%esi), %esp call 1f 1: popl %ebp subl $1b, %ebp @@ -70,32 +73,28 @@ ENTRY(startup_32) testl %eax, %eax jnz no_longmode -/* Compute the delta between where we were compiled to run at +/* + * Compute the delta between where we were compiled to run at * and where the code will actually run at. - */ -/* %ebp contains the address we are loaded at by the boot loader and %ebx + * + * %ebp contains the address we are loaded at by the boot loader and %ebx * contains the address where we should move the kernel image temporarily * for safe in-place decompression. */ #ifdef CONFIG_RELOCATABLE movl %ebp, %ebx - addl $(PMD_PAGE_SIZE -1), %ebx - andl $PMD_PAGE_MASK, %ebx + movl BP_kernel_alignment(%esi), %eax + decl %eax + addl %eax, %ebx + notl %eax + andl %eax, %ebx #else - movl $CONFIG_PHYSICAL_START, %ebx + movl $LOAD_PHYSICAL_ADDR, %ebx #endif - /* Replace the compressed data size with the uncompressed size */ - subl input_len(%ebp), %ebx - movl output_len(%ebp), %eax - addl %eax, %ebx - /* Add 8 bytes for every 32K input block */ - shrl $12, %eax - addl %eax, %ebx - /* Add 32K + 18 bytes of extra slack and align on a 4K boundary */ - addl $(32768 + 18 + 4095), %ebx - andl $~4095, %ebx + /* Target address to relocate to for decompression */ + addl $z_extract_offset, %ebx /* * Prepare for entering 64 bit mode @@ -114,7 +113,7 @@ ENTRY(startup_32) /* * Build early 4G boot pagetable */ - /* Initialize Page tables to 0*/ + /* Initialize Page tables to 0 */ leal pgtable(%ebx), %edi xorl %eax, %eax movl $((4096*6)/4), %ecx @@ -155,7 +154,8 @@ ENTRY(startup_32) btsl $_EFER_LME, %eax wrmsr - /* Setup for the jump to 64bit mode + /* + * Setup for the jump to 64bit mode * * When the jump is performend we will be in long mode but * in 32bit compatibility mode with EFER.LME = 1, CS.L = 0, CS.D = 1 @@ -184,7 +184,8 @@ no_longmode: #include "../../kernel/verify_cpu_64.S" - /* Be careful here startup_64 needs to be at a predictable + /* + * Be careful here startup_64 needs to be at a predictable * address so I can export it in an ELF header. Bootloaders * should look at the ELF header to find this address, as * it may change in the future. @@ -192,7 +193,8 @@ no_longmode: .code64 .org 0x200 ENTRY(startup_64) - /* We come here either from startup_32 or directly from a + /* + * We come here either from startup_32 or directly from a * 64bit bootloader. If we come here from a bootloader we depend on * an identity mapped page table being provied that maps our * entire text+data+bss and hopefully all of memory. @@ -209,50 +211,54 @@ ENTRY(startup_64) movl $0x20, %eax ltr %ax - /* Compute the decompressed kernel start address. It is where + /* + * Compute the decompressed kernel start address. It is where * we were loaded at aligned to a 2M boundary. %rbp contains the * decompressed kernel start address. * * If it is a relocatable kernel then decompress and run the kernel * from load address aligned to 2MB addr, otherwise decompress and - * run the kernel from CONFIG_PHYSICAL_START + * run the kernel from LOAD_PHYSICAL_ADDR + * + * We cannot rely on the calculation done in 32-bit mode, since we + * may have been invoked via the 64-bit entry point. */ /* Start with the delta to where the kernel will run at. */ #ifdef CONFIG_RELOCATABLE leaq startup_32(%rip) /* - $startup_32 */, %rbp - addq $(PMD_PAGE_SIZE - 1), %rbp - andq $PMD_PAGE_MASK, %rbp - movq %rbp, %rbx + movl BP_kernel_alignment(%rsi), %eax + decl %eax + addq %rax, %rbp + notq %rax + andq %rax, %rbp #else - movq $CONFIG_PHYSICAL_START, %rbp - movq %rbp, %rbx + movq $LOAD_PHYSICAL_ADDR, %rbp #endif - /* Replace the compressed data size with the uncompressed size */ - movl input_len(%rip), %eax - subq %rax, %rbx - movl output_len(%rip), %eax - addq %rax, %rbx - /* Add 8 bytes for every 32K input block */ - shrq $12, %rax - addq %rax, %rbx - /* Add 32K + 18 bytes of extra slack and align on a 4K boundary */ - addq $(32768 + 18 + 4095), %rbx - andq $~4095, %rbx - -/* Copy the compressed kernel to the end of our buffer + /* Target address to relocate to for decompression */ + leaq z_extract_offset(%rbp), %rbx + + /* Set up the stack */ + leaq boot_stack_end(%rbx), %rsp + + /* Zero EFLAGS */ + pushq $0 + popfq + +/* + * Copy the compressed kernel to the end of our buffer * where decompression in place becomes safe. */ - leaq _end_before_pgt(%rip), %r8 - leaq _end_before_pgt(%rbx), %r9 - movq $_end_before_pgt /* - $startup_32 */, %rcx -1: subq $8, %r8 - subq $8, %r9 - movq 0(%r8), %rax - movq %rax, 0(%r9) - subq $8, %rcx - jnz 1b + pushq %rsi + leaq (_bss-8)(%rip), %rsi + leaq (_bss-8)(%rbx), %rdi + movq $_bss /* - $startup_32 */, %rcx + shrq $3, %rcx + std + rep movsq + cld + popq %rsi /* * Jump to the relocated address. @@ -260,37 +266,28 @@ ENTRY(startup_64) leaq relocated(%rbx), %rax jmp *%rax -.section ".text" + .text relocated: /* - * Clear BSS + * Clear BSS (stack is currently empty) */ - xorq %rax, %rax - leaq _edata(%rbx), %rdi - leaq _end_before_pgt(%rbx), %rcx + xorl %eax, %eax + leaq _bss(%rip), %rdi + leaq _ebss(%rip), %rcx subq %rdi, %rcx - cld - rep - stosb - - /* Setup the stack */ - leaq boot_stack_end(%rip), %rsp - - /* zero EFLAGS after setting rsp */ - pushq $0 - popfq + shrq $3, %rcx + rep stosq /* * Do the decompression, and jump to the new kernel.. */ - pushq %rsi # Save the real mode argument - movq %rsi, %rdi # real mode address - leaq boot_heap(%rip), %rsi # malloc area for uncompression - leaq input_data(%rip), %rdx # input_data - movl input_len(%rip), %eax - movq %rax, %rcx # input_len - movq %rbp, %r8 # output + pushq %rsi /* Save the real mode argument */ + movq %rsi, %rdi /* real mode address */ + leaq boot_heap(%rip), %rsi /* malloc area for uncompression */ + leaq input_data(%rip), %rdx /* input_data */ + movl $z_input_len, %ecx /* input_len */ + movq %rbp, %r8 /* output target address */ call decompress_kernel popq %rsi @@ -311,11 +308,21 @@ gdt: .quad 0x0000000000000000 /* TS continued */ gdt_end: -.bss -/* Stack and heap for uncompression */ -.balign 4 +/* + * Stack and heap for uncompression + */ + .bss + .balign 4 boot_heap: .fill BOOT_HEAP_SIZE, 1, 0 boot_stack: .fill BOOT_STACK_SIZE, 1, 0 boot_stack_end: + +/* + * Space for page tables (not in .bss so not zeroed) + */ + .section ".pgtable","a",@nobits + .balign 4096 +pgtable: + .fill 6*4096, 1, 0 |