diff options
Diffstat (limited to 'drivers/net/sky2.c')
-rw-r--r-- | drivers/net/sky2.c | 50 |
1 files changed, 41 insertions, 9 deletions
diff --git a/drivers/net/sky2.c b/drivers/net/sky2.c index bfeba5b..ce135b8 100644 --- a/drivers/net/sky2.c +++ b/drivers/net/sky2.c @@ -232,7 +232,17 @@ static int sky2_set_power_state(struct sky2_hw *hw, pci_power_t state) if (hw->ports > 1) reg1 |= PCI_Y2_PHY2_COMA; } + + if (hw->chip_id == CHIP_ID_YUKON_EC_U) { + pci_write_config_dword(hw->pdev, PCI_DEV_REG3, 0); + pci_read_config_dword(hw->pdev, PCI_DEV_REG4, ®1); + reg1 &= P_ASPM_CONTROL_MSK; + pci_write_config_dword(hw->pdev, PCI_DEV_REG4, reg1); + pci_write_config_dword(hw->pdev, PCI_DEV_REG5, 0); + } + pci_write_config_dword(hw->pdev, PCI_DEV_REG1, reg1); + break; case PCI_D3hot: @@ -463,16 +473,31 @@ static void sky2_phy_init(struct sky2_hw *hw, unsigned port) ledover |= PHY_M_LED_MO_RX(MO_LED_OFF); } - gm_phy_write(hw, port, PHY_MARV_LED_CTRL, ledctrl); + if (hw->chip_id == CHIP_ID_YUKON_EC_U && hw->chip_rev >= 2) { + /* apply fixes in PHY AFE */ + gm_phy_write(hw, port, 22, 255); + /* increase differential signal amplitude in 10BASE-T */ + gm_phy_write(hw, port, 24, 0xaa99); + gm_phy_write(hw, port, 23, 0x2011); - if (sky2->autoneg == AUTONEG_DISABLE || sky2->speed == SPEED_100) { - /* turn on 100 Mbps LED (LED_LINK100) */ - ledover |= PHY_M_LED_MO_100(MO_LED_ON); - } + /* fix for IEEE A/B Symmetry failure in 1000BASE-T */ + gm_phy_write(hw, port, 24, 0xa204); + gm_phy_write(hw, port, 23, 0x2002); - if (ledover) - gm_phy_write(hw, port, PHY_MARV_LED_OVER, ledover); + /* set page register to 0 */ + gm_phy_write(hw, port, 22, 0); + } else { + gm_phy_write(hw, port, PHY_MARV_LED_CTRL, ledctrl); + if (sky2->autoneg == AUTONEG_DISABLE || sky2->speed == SPEED_100) { + /* turn on 100 Mbps LED (LED_LINK100) */ + ledover |= PHY_M_LED_MO_100(MO_LED_ON); + } + + if (ledover) + gm_phy_write(hw, port, PHY_MARV_LED_OVER, ledover); + + } /* Enable phy interrupt on auto-negotiation complete (or link up) */ if (sky2->autoneg == AUTONEG_ENABLE) gm_phy_write(hw, port, PHY_MARV_INT_MASK, PHY_M_IS_AN_COMPL); @@ -953,6 +978,12 @@ static int sky2_rx_start(struct sky2_port *sky2) sky2->rx_put = sky2->rx_next = 0; sky2_qset(hw, rxq); + + if (hw->chip_id == CHIP_ID_YUKON_EC_U && hw->chip_rev >= 2) { + /* MAC Rx RAM Read is controlled by hardware */ + sky2_write32(hw, Q_ADDR(rxq, Q_F), F_M_RX_RAM_DIS); + } + sky2_prefetch_init(hw, rxq, sky2->rx_le_map, RX_LE_SIZE - 1); rx_set_checksum(sky2); @@ -1035,9 +1066,10 @@ static int sky2_up(struct net_device *dev) RB_RST_SET); sky2_qset(hw, txqaddr[port]); - if (hw->chip_id == CHIP_ID_YUKON_EC_U) - sky2_write16(hw, Q_ADDR(txqaddr[port], Q_AL), 0x1a0); + /* Set almost empty threshold */ + if (hw->chip_id == CHIP_ID_YUKON_EC_U && hw->chip_rev == 1) + sky2_write16(hw, Q_ADDR(txqaddr[port], Q_AL), 0x1a0); sky2_prefetch_init(hw, txqaddr[port], sky2->tx_le_map, TX_RING_SIZE - 1); |