1 files changed, 24 insertions, 140 deletions

diff --git a/drivers/net/wireless/rt2x00/rt2x00config.c b/drivers/net/wireless/rt2x00/rt2x00config.c
index 7910147..3e4eee3 100644
--- a/drivers/net/wireless/rt2x00/rt2x00config.c
+++ b/drivers/net/wireless/rt2x00/rt2x00config.c
@@ -86,13 +86,14 @@ void rt2x00lib_config_erp(struct rt2x00_dev *rt2x00dev,
 	erp.short_preamble = bss_conf->use_short_preamble;
 	erp.cts_protection = bss_conf->use_cts_prot;
 
-	erp.ack_timeout = PLCP + get_duration(ACK_SIZE, 10);
-	erp.ack_consume_time = SIFS + PLCP + get_duration(ACK_SIZE, 10);
+	erp.slot_time = bss_conf->use_short_slot ? SHORT_SLOT_TIME : SLOT_TIME;
+	erp.sifs = SIFS;
+	erp.pifs = bss_conf->use_short_slot ? SHORT_PIFS : PIFS;
+	erp.difs = bss_conf->use_short_slot ? SHORT_DIFS : DIFS;
+	erp.eifs = bss_conf->use_short_slot ? SHORT_EIFS : EIFS;
 
-	if (rt2x00dev->hw->conf.flags & IEEE80211_CONF_SHORT_SLOT_TIME)
-		erp.ack_timeout += SHORT_DIFS;
-	else
-		erp.ack_timeout += DIFS;
+	erp.ack_timeout = PLCP + erp.difs + get_duration(ACK_SIZE, 10);
+	erp.ack_consume_time = SIFS + PLCP + get_duration(ACK_SIZE, 10);
 
 	if (bss_conf->use_short_preamble) {
 		erp.ack_timeout += SHORT_PREAMBLE;
@@ -102,16 +103,18 @@ void rt2x00lib_config_erp(struct rt2x00_dev *rt2x00dev,
 		erp.ack_consume_time += PREAMBLE;
 	}
 
+	erp.basic_rates = bss_conf->basic_rates;
+
 	rt2x00dev->ops->lib->config_erp(rt2x00dev, &erp);
 }
 
 void rt2x00lib_config_antenna(struct rt2x00_dev *rt2x00dev,
 			      enum antenna rx, enum antenna tx)
 {
-	struct rt2x00lib_conf libconf;
+	struct antenna_setup ant;
 
-	libconf.ant.rx = rx;
-	libconf.ant.tx = tx;
+	ant.rx = rx;
+	ant.tx = tx;
 
 	if (rx == rt2x00dev->link.ant.active.rx &&
 	    tx == rt2x00dev->link.ant.active.tx)
@@ -129,111 +132,28 @@ void rt2x00lib_config_antenna(struct rt2x00_dev *rt2x00dev,
 	 * The latter is required since we need to recalibrate the
 	 * noise-sensitivity ratio for the new setup.
 	 */
-	rt2x00dev->ops->lib->config(rt2x00dev, &libconf, CONFIG_UPDATE_ANTENNA);
+	rt2x00dev->ops->lib->config_ant(rt2x00dev, &ant);
+
 	rt2x00lib_reset_link_tuner(rt2x00dev);
 	rt2x00_reset_link_ant_rssi(&rt2x00dev->link);
 
-	rt2x00dev->link.ant.active.rx = libconf.ant.rx;
-	rt2x00dev->link.ant.active.tx = libconf.ant.tx;
+	memcpy(&rt2x00dev->link.ant.active, &ant, sizeof(ant));
 
 	if (test_bit(DEVICE_STATE_ENABLED_RADIO, &rt2x00dev->flags))
 		rt2x00lib_toggle_rx(rt2x00dev, STATE_RADIO_RX_ON_LINK);
 }
 
-static u32 rt2x00lib_get_basic_rates(struct ieee80211_supported_band *band)
-{
-	const struct rt2x00_rate *rate;
-	unsigned int i;
-	u32 mask = 0;
-
-	for (i = 0; i < band->n_bitrates; i++) {
-		rate = rt2x00_get_rate(band->bitrates[i].hw_value);
-		if (rate->flags & DEV_RATE_BASIC)
-			mask |= rate->ratemask;
-	}
-
-	return mask;
-}
-
 void rt2x00lib_config(struct rt2x00_dev *rt2x00dev,
-		      struct ieee80211_conf *conf, const int force_config)
+		      struct ieee80211_conf *conf,
+		      unsigned int ieee80211_flags)
 {
 	struct rt2x00lib_conf libconf;
-	struct ieee80211_supported_band *band;
-	struct antenna_setup *default_ant = &rt2x00dev->default_ant;
-	struct antenna_setup *active_ant = &rt2x00dev->link.ant.active;
-	int flags = 0;
-	int short_slot_time;
-
-	/*
-	 * In some situations we want to force all configurations
-	 * to be reloaded (When resuming for instance).
-	 */
-	if (force_config) {
-		flags = CONFIG_UPDATE_ALL;
-		goto config;
-	}
-
-	/*
-	 * Check which configuration options have been
-	 * updated and should be send to the device.
-	 */
-	if (rt2x00dev->rx_status.band != conf->channel->band)
-		flags |= CONFIG_UPDATE_PHYMODE;
-	if (rt2x00dev->rx_status.freq != conf->channel->center_freq)
-		flags |= CONFIG_UPDATE_CHANNEL;
-	if (rt2x00dev->tx_power != conf->power_level)
-		flags |= CONFIG_UPDATE_TXPOWER;
-
-	/*
-	 * Determining changes in the antenna setups request several checks:
-	 * antenna_sel_{r,t}x = 0
-	 *    -> Does active_{r,t}x match default_{r,t}x
-	 *    -> Is default_{r,t}x SW_DIVERSITY
-	 * antenna_sel_{r,t}x = 1/2
-	 *    -> Does active_{r,t}x match antenna_sel_{r,t}x
-	 * The reason for not updating the antenna while SW diversity
-	 * should be used is simple: Software diversity means that
-	 * we should switch between the antenna's based on the
-	 * quality. This means that the current antenna is good enough
-	 * to work with untill the link tuner decides that an antenna
-	 * switch should be performed.
-	 */
-	if (default_ant->rx != ANTENNA_SW_DIVERSITY &&
-	    default_ant->rx != active_ant->rx)
-		flags |= CONFIG_UPDATE_ANTENNA;
-	else if (active_ant->rx == ANTENNA_SW_DIVERSITY)
-		flags |= CONFIG_UPDATE_ANTENNA;
-
-	if (default_ant->tx != ANTENNA_SW_DIVERSITY &&
-	    default_ant->tx != active_ant->tx)
-		flags |= CONFIG_UPDATE_ANTENNA;
-	else if (active_ant->tx == ANTENNA_SW_DIVERSITY)
-		flags |= CONFIG_UPDATE_ANTENNA;
 
-	/*
-	 * The following configuration options are never
-	 * stored anywhere and will always be updated.
-	 */
-	flags |= CONFIG_UPDATE_SLOT_TIME;
-	flags |= CONFIG_UPDATE_BEACON_INT;
-
-	/*
-	 * We have determined what options should be updated,
-	 * now precalculate device configuration values depending
-	 * on what configuration options need to be updated.
-	 */
-config:
 	memset(&libconf, 0, sizeof(libconf));
 
-	if (flags & CONFIG_UPDATE_PHYMODE) {
-		band = &rt2x00dev->bands[conf->channel->band];
-
-		libconf.band = conf->channel->band;
-		libconf.basic_rates = rt2x00lib_get_basic_rates(band);
-	}
+	libconf.conf = conf;
 
-	if (flags & CONFIG_UPDATE_CHANNEL) {
+	if (ieee80211_flags & IEEE80211_CONF_CHANGE_CHANNEL) {
 		memcpy(&libconf.rf,
 		       &rt2x00dev->spec.channels[conf->channel->hw_value],
 		       sizeof(libconf.rf));
@@ -243,57 +163,21 @@ config:
 		       sizeof(libconf.channel));
 	}
 
-	if (flags & CONFIG_UPDATE_ANTENNA) {
-		if (default_ant->rx != ANTENNA_SW_DIVERSITY)
-			libconf.ant.rx = default_ant->rx;
-		else if (active_ant->rx == ANTENNA_SW_DIVERSITY)
-			libconf.ant.rx = ANTENNA_B;
-		else
-			libconf.ant.rx = active_ant->rx;
-
-		if (default_ant->tx != ANTENNA_SW_DIVERSITY)
-			libconf.ant.tx = default_ant->tx;
-		else if (active_ant->tx == ANTENNA_SW_DIVERSITY)
-			libconf.ant.tx = ANTENNA_B;
-		else
-			libconf.ant.tx = active_ant->tx;
-	}
-
-	if (flags & CONFIG_UPDATE_SLOT_TIME) {
-		short_slot_time = conf->flags & IEEE80211_CONF_SHORT_SLOT_TIME;
-
-		libconf.slot_time =
-		    short_slot_time ? SHORT_SLOT_TIME : SLOT_TIME;
-		libconf.sifs = SIFS;
-		libconf.pifs = short_slot_time ? SHORT_PIFS : PIFS;
-		libconf.difs = short_slot_time ? SHORT_DIFS : DIFS;
-		libconf.eifs = short_slot_time ? SHORT_EIFS : EIFS;
-	}
-
-	libconf.conf = conf;
-
 	/*
 	 * Start configuration.
 	 */
-	rt2x00dev->ops->lib->config(rt2x00dev, &libconf, flags);
+	rt2x00dev->ops->lib->config(rt2x00dev, &libconf, ieee80211_flags);
 
 	/*
 	 * Some configuration changes affect the link quality
 	 * which means we need to reset the link tuner.
 	 */
-	if (flags & (CONFIG_UPDATE_CHANNEL | CONFIG_UPDATE_ANTENNA))
+	if (ieee80211_flags & IEEE80211_CONF_CHANGE_CHANNEL)
 		rt2x00lib_reset_link_tuner(rt2x00dev);
 
-	if (flags & CONFIG_UPDATE_PHYMODE) {
-		rt2x00dev->curr_band = conf->channel->band;
-		rt2x00dev->rx_status.band = conf->channel->band;
-	}
-
-	rt2x00dev->rx_status.freq = conf->channel->center_freq;
+	rt2x00dev->curr_band = conf->channel->band;
 	rt2x00dev->tx_power = conf->power_level;
 
-	if (flags & CONFIG_UPDATE_ANTENNA) {
-		rt2x00dev->link.ant.active.rx = libconf.ant.rx;
-		rt2x00dev->link.ant.active.tx = libconf.ant.tx;
-	}
+	rt2x00dev->rx_status.band = conf->channel->band;
+	rt2x00dev->rx_status.freq = conf->channel->center_freq;
 }