diff options
Diffstat (limited to 'drivers/pci/quirks.c')
-rw-r--r-- | drivers/pci/quirks.c | 147 |
1 files changed, 131 insertions, 16 deletions
diff --git a/drivers/pci/quirks.c b/drivers/pci/quirks.c index e85d230..f6c31fa 100644 --- a/drivers/pci/quirks.c +++ b/drivers/pci/quirks.c @@ -3126,9 +3126,6 @@ static int reset_intel_generic_dev(struct pci_dev *dev, int probe) static int reset_intel_82599_sfp_virtfn(struct pci_dev *dev, int probe) { - int i; - u16 status; - /* * http://www.intel.com/content/dam/doc/datasheet/82599-10-gbe-controller-datasheet.pdf * @@ -3140,20 +3137,9 @@ static int reset_intel_82599_sfp_virtfn(struct pci_dev *dev, int probe) if (probe) return 0; - /* Wait for Transaction Pending bit clean */ - for (i = 0; i < 4; i++) { - if (i) - msleep((1 << (i - 1)) * 100); - - pcie_capability_read_word(dev, PCI_EXP_DEVSTA, &status); - if (!(status & PCI_EXP_DEVSTA_TRPND)) - goto clear; - } - - dev_err(&dev->dev, "transaction is not cleared; " - "proceeding with reset anyway\n"); + if (!pci_wait_for_pending_transaction(dev)) + dev_err(&dev->dev, "transaction is not cleared; proceeding with reset anyway\n"); -clear: pcie_capability_set_word(dev, PCI_EXP_DEVCTL, PCI_EXP_DEVCTL_BCR_FLR); msleep(100); @@ -3208,6 +3194,83 @@ reset_complete: return 0; } +/* + * Device-specific reset method for Chelsio T4-based adapters. + */ +static int reset_chelsio_generic_dev(struct pci_dev *dev, int probe) +{ + u16 old_command; + u16 msix_flags; + + /* + * If this isn't a Chelsio T4-based device, return -ENOTTY indicating + * that we have no device-specific reset method. + */ + if ((dev->device & 0xf000) != 0x4000) + return -ENOTTY; + + /* + * If this is the "probe" phase, return 0 indicating that we can + * reset this device. + */ + if (probe) + return 0; + + /* + * T4 can wedge if there are DMAs in flight within the chip and Bus + * Master has been disabled. We need to have it on till the Function + * Level Reset completes. (BUS_MASTER is disabled in + * pci_reset_function()). + */ + pci_read_config_word(dev, PCI_COMMAND, &old_command); + pci_write_config_word(dev, PCI_COMMAND, + old_command | PCI_COMMAND_MASTER); + + /* + * Perform the actual device function reset, saving and restoring + * configuration information around the reset. + */ + pci_save_state(dev); + + /* + * T4 also suffers a Head-Of-Line blocking problem if MSI-X interrupts + * are disabled when an MSI-X interrupt message needs to be delivered. + * So we briefly re-enable MSI-X interrupts for the duration of the + * FLR. The pci_restore_state() below will restore the original + * MSI-X state. + */ + pci_read_config_word(dev, dev->msix_cap+PCI_MSIX_FLAGS, &msix_flags); + if ((msix_flags & PCI_MSIX_FLAGS_ENABLE) == 0) + pci_write_config_word(dev, dev->msix_cap+PCI_MSIX_FLAGS, + msix_flags | + PCI_MSIX_FLAGS_ENABLE | + PCI_MSIX_FLAGS_MASKALL); + + /* + * Start of pcie_flr() code sequence. This reset code is a copy of + * the guts of pcie_flr() because that's not an exported function. + */ + + if (!pci_wait_for_pending_transaction(dev)) + dev_err(&dev->dev, "transaction is not cleared; proceeding with reset anyway\n"); + + pcie_capability_set_word(dev, PCI_EXP_DEVCTL, PCI_EXP_DEVCTL_BCR_FLR); + msleep(100); + + /* + * End of pcie_flr() code sequence. + */ + + /* + * Restore the configuration information (BAR values, etc.) including + * the original PCI Configuration Space Command word, and return + * success. + */ + pci_restore_state(dev); + pci_write_config_word(dev, PCI_COMMAND, old_command); + return 0; +} + #define PCI_DEVICE_ID_INTEL_82599_SFP_VF 0x10ed #define PCI_DEVICE_ID_INTEL_IVB_M_VGA 0x0156 #define PCI_DEVICE_ID_INTEL_IVB_M2_VGA 0x0166 @@ -3221,6 +3284,8 @@ static const struct pci_dev_reset_methods pci_dev_reset_methods[] = { reset_ivb_igd }, { PCI_VENDOR_ID_INTEL, PCI_ANY_ID, reset_intel_generic_dev }, + { PCI_VENDOR_ID_CHELSIO, PCI_ANY_ID, + reset_chelsio_generic_dev }, { 0 } }; @@ -3295,11 +3360,61 @@ struct pci_dev *pci_get_dma_source(struct pci_dev *dev) return pci_dev_get(dev); } +/* + * AMD has indicated that the devices below do not support peer-to-peer + * in any system where they are found in the southbridge with an AMD + * IOMMU in the system. Multifunction devices that do not support + * peer-to-peer between functions can claim to support a subset of ACS. + * Such devices effectively enable request redirect (RR) and completion + * redirect (CR) since all transactions are redirected to the upstream + * root complex. + * + * http://permalink.gmane.org/gmane.comp.emulators.kvm.devel/94086 + * http://permalink.gmane.org/gmane.comp.emulators.kvm.devel/94102 + * http://permalink.gmane.org/gmane.comp.emulators.kvm.devel/99402 + * + * 1002:4385 SBx00 SMBus Controller + * 1002:439c SB7x0/SB8x0/SB9x0 IDE Controller + * 1002:4383 SBx00 Azalia (Intel HDA) + * 1002:439d SB7x0/SB8x0/SB9x0 LPC host controller + * 1002:4384 SBx00 PCI to PCI Bridge + * 1002:4399 SB7x0/SB8x0/SB9x0 USB OHCI2 Controller + */ +static int pci_quirk_amd_sb_acs(struct pci_dev *dev, u16 acs_flags) +{ +#ifdef CONFIG_ACPI + struct acpi_table_header *header = NULL; + acpi_status status; + + /* Targeting multifunction devices on the SB (appears on root bus) */ + if (!dev->multifunction || !pci_is_root_bus(dev->bus)) + return -ENODEV; + + /* The IVRS table describes the AMD IOMMU */ + status = acpi_get_table("IVRS", 0, &header); + if (ACPI_FAILURE(status)) + return -ENODEV; + + /* Filter out flags not applicable to multifunction */ + acs_flags &= (PCI_ACS_RR | PCI_ACS_CR | PCI_ACS_EC | PCI_ACS_DT); + + return acs_flags & ~(PCI_ACS_RR | PCI_ACS_CR) ? 0 : 1; +#else + return -ENODEV; +#endif +} + static const struct pci_dev_acs_enabled { u16 vendor; u16 device; int (*acs_enabled)(struct pci_dev *dev, u16 acs_flags); } pci_dev_acs_enabled[] = { + { PCI_VENDOR_ID_ATI, 0x4385, pci_quirk_amd_sb_acs }, + { PCI_VENDOR_ID_ATI, 0x439c, pci_quirk_amd_sb_acs }, + { PCI_VENDOR_ID_ATI, 0x4383, pci_quirk_amd_sb_acs }, + { PCI_VENDOR_ID_ATI, 0x439d, pci_quirk_amd_sb_acs }, + { PCI_VENDOR_ID_ATI, 0x4384, pci_quirk_amd_sb_acs }, + { PCI_VENDOR_ID_ATI, 0x4399, pci_quirk_amd_sb_acs }, { 0 } }; |