diff options
Diffstat (limited to 'drivers/pci')
| -rw-r--r-- | drivers/pci/host/pci-imx6.c | 13 | ||||
| -rw-r--r-- | drivers/pci/hotplug/pciehp_core.c | 7 | ||||
| -rw-r--r-- | drivers/pci/pci-sysfs.c | 8 | ||||
| -rw-r--r-- | drivers/pci/pcie/pme.c | 6 |
4 files changed, 18 insertions, 16 deletions
diff --git a/drivers/pci/host/pci-imx6.c b/drivers/pci/host/pci-imx6.c index 233fe8a..69202d1 100644 --- a/drivers/pci/host/pci-imx6.c +++ b/drivers/pci/host/pci-imx6.c @@ -275,15 +275,22 @@ static int imx6_pcie_deassert_core_reset(struct pcie_port *pp) goto err_pcie; } - /* allow the clocks to stabilize */ - usleep_range(200, 500); - /* power up core phy and enable ref clock */ regmap_update_bits(imx6_pcie->iomuxc_gpr, IOMUXC_GPR1, IMX6Q_GPR1_PCIE_TEST_PD, 0 << 18); + /* + * the async reset input need ref clock to sync internally, + * when the ref clock comes after reset, internal synced + * reset time is too short, cannot meet the requirement. + * add one ~10us delay here. + */ + udelay(10); regmap_update_bits(imx6_pcie->iomuxc_gpr, IOMUXC_GPR1, IMX6Q_GPR1_PCIE_REF_CLK_EN, 1 << 16); + /* allow the clocks to stabilize */ + usleep_range(200, 500); + /* Some boards don't have PCIe reset GPIO. */ if (gpio_is_valid(imx6_pcie->reset_gpio)) { gpio_set_value(imx6_pcie->reset_gpio, 0); diff --git a/drivers/pci/hotplug/pciehp_core.c b/drivers/pci/hotplug/pciehp_core.c index 3a5e7e2..07aa722 100644 --- a/drivers/pci/hotplug/pciehp_core.c +++ b/drivers/pci/hotplug/pciehp_core.c @@ -262,13 +262,6 @@ static int pciehp_probe(struct pcie_device *dev) goto err_out_none; } - if (!dev->port->subordinate) { - /* Can happen if we run out of bus numbers during probe */ - dev_err(&dev->device, - "Hotplug bridge without secondary bus, ignoring\n"); - goto err_out_none; - } - ctrl = pcie_init(dev); if (!ctrl) { dev_err(&dev->device, "Controller initialization failed\n"); diff --git a/drivers/pci/pci-sysfs.c b/drivers/pci/pci-sysfs.c index 92b6d9a..2c6643f 100644 --- a/drivers/pci/pci-sysfs.c +++ b/drivers/pci/pci-sysfs.c @@ -185,7 +185,7 @@ static ssize_t modalias_show(struct device *dev, struct device_attribute *attr, } static DEVICE_ATTR_RO(modalias); -static ssize_t enabled_store(struct device *dev, struct device_attribute *attr, +static ssize_t enable_store(struct device *dev, struct device_attribute *attr, const char *buf, size_t count) { struct pci_dev *pdev = to_pci_dev(dev); @@ -210,7 +210,7 @@ static ssize_t enabled_store(struct device *dev, struct device_attribute *attr, return result < 0 ? result : count; } -static ssize_t enabled_show(struct device *dev, struct device_attribute *attr, +static ssize_t enable_show(struct device *dev, struct device_attribute *attr, char *buf) { struct pci_dev *pdev; @@ -218,7 +218,7 @@ static ssize_t enabled_show(struct device *dev, struct device_attribute *attr, pdev = to_pci_dev(dev); return sprintf(buf, "%u\n", atomic_read(&pdev->enable_cnt)); } -static DEVICE_ATTR_RW(enabled); +static DEVICE_ATTR_RW(enable); #ifdef CONFIG_NUMA static ssize_t numa_node_show(struct device *dev, struct device_attribute *attr, @@ -563,7 +563,7 @@ static struct attribute *pci_dev_attrs[] = { #endif &dev_attr_dma_mask_bits.attr, &dev_attr_consistent_dma_mask_bits.attr, - &dev_attr_enabled.attr, + &dev_attr_enable.attr, &dev_attr_broken_parity_status.attr, &dev_attr_msi_bus.attr, #if defined(CONFIG_PM_RUNTIME) && defined(CONFIG_ACPI) diff --git a/drivers/pci/pcie/pme.c b/drivers/pci/pcie/pme.c index a9f9c46..63fc639 100644 --- a/drivers/pci/pcie/pme.c +++ b/drivers/pci/pcie/pme.c @@ -397,6 +397,7 @@ static int pcie_pme_suspend(struct pcie_device *srv) struct pcie_pme_service_data *data = get_service_data(srv); struct pci_dev *port = srv->port; bool wakeup; + int ret; if (device_may_wakeup(&port->dev)) { wakeup = true; @@ -407,9 +408,10 @@ static int pcie_pme_suspend(struct pcie_device *srv) } spin_lock_irq(&data->lock); if (wakeup) { - enable_irq_wake(srv->irq); + ret = enable_irq_wake(srv->irq); data->suspend_level = PME_SUSPEND_WAKEUP; - } else { + } + if (!wakeup || ret) { struct pci_dev *port = srv->port; pcie_pme_interrupt_enable(port, false); |