diff options
Diffstat (limited to 'drivers')
| -rw-r--r-- | drivers/scsi/hpsa.c | 27 | ||||
| -rw-r--r-- | drivers/scsi/hpsa.h | 2 |
2 files changed, 15 insertions, 14 deletions
diff --git a/drivers/scsi/hpsa.c b/drivers/scsi/hpsa.c index 68df3da..d048b69 100644 --- a/drivers/scsi/hpsa.c +++ b/drivers/scsi/hpsa.c @@ -56,6 +56,7 @@ /* HPSA_DRIVER_VERSION must be 3 byte values (0-255) separated by '.' */ #define HPSA_DRIVER_VERSION "2.0.2-1" #define DRIVER_NAME "HP HPSA Driver (v " HPSA_DRIVER_VERSION ")" +#define HPSA "hpsa" /* How long to wait (in milliseconds) for board to go into simple mode */ #define MAX_CONFIG_WAIT 30000 @@ -202,30 +203,30 @@ static int check_for_unit_attention(struct ctlr_info *h, switch (c->err_info->SenseInfo[12]) { case STATE_CHANGED: - dev_warn(&h->pdev->dev, "hpsa%d: a state change " + dev_warn(&h->pdev->dev, HPSA "%d: a state change " "detected, command retried\n", h->ctlr); break; case LUN_FAILED: - dev_warn(&h->pdev->dev, "hpsa%d: LUN failure " + dev_warn(&h->pdev->dev, HPSA "%d: LUN failure " "detected, action required\n", h->ctlr); break; case REPORT_LUNS_CHANGED: - dev_warn(&h->pdev->dev, "hpsa%d: report LUN data " + dev_warn(&h->pdev->dev, HPSA "%d: report LUN data " "changed, action required\n", h->ctlr); /* * Note: this REPORT_LUNS_CHANGED condition only occurs on the MSA2012. */ break; case POWER_OR_RESET: - dev_warn(&h->pdev->dev, "hpsa%d: a power on " + dev_warn(&h->pdev->dev, HPSA "%d: a power on " "or device reset detected\n", h->ctlr); break; case UNIT_ATTENTION_CLEARED: - dev_warn(&h->pdev->dev, "hpsa%d: unit attention " + dev_warn(&h->pdev->dev, HPSA "%d: unit attention " "cleared by another initiator\n", h->ctlr); break; default: - dev_warn(&h->pdev->dev, "hpsa%d: unknown " + dev_warn(&h->pdev->dev, HPSA "%d: unknown " "unit attention detected\n", h->ctlr); break; } @@ -475,8 +476,8 @@ static struct device_attribute *hpsa_shost_attrs[] = { static struct scsi_host_template hpsa_driver_template = { .module = THIS_MODULE, - .name = "hpsa", - .proc_name = "hpsa", + .name = HPSA, + .proc_name = HPSA, .queuecommand = hpsa_scsi_queue_command, .scan_start = hpsa_scan_start, .scan_finished = hpsa_scan_finished, @@ -3343,7 +3344,7 @@ static int hpsa_controller_hard_reset(struct pci_dev *pdev, static __devinit void init_driver_version(char *driver_version, int len) { memset(driver_version, 0, len); - strncpy(driver_version, "hpsa " HPSA_DRIVER_VERSION, len - 1); + strncpy(driver_version, HPSA " " HPSA_DRIVER_VERSION, len - 1); } static __devinit int write_driver_ver_to_cfgtable( @@ -3924,7 +3925,7 @@ static int __devinit hpsa_pci_init(struct ctlr_info *h) return err; } - err = pci_request_regions(h->pdev, "hpsa"); + err = pci_request_regions(h->pdev, HPSA); if (err) { dev_err(&h->pdev->dev, "cannot obtain PCI resources, aborting\n"); @@ -4242,7 +4243,7 @@ static void start_controller_lockup_detector(struct ctlr_info *h) spin_lock_init(&lockup_detector_lock); hpsa_lockup_detector = kthread_run(detect_controller_lockup_thread, - NULL, "hpsa"); + NULL, HPSA); } if (!hpsa_lockup_detector) { dev_warn(&h->pdev->dev, @@ -4314,7 +4315,7 @@ reinit_after_soft_reset: if (rc != 0) goto clean1; - sprintf(h->devname, "hpsa%d", number_of_controllers); + sprintf(h->devname, HPSA "%d", number_of_controllers); h->ctlr = number_of_controllers; number_of_controllers++; @@ -4528,7 +4529,7 @@ static int hpsa_resume(__attribute__((unused)) struct pci_dev *pdev) } static struct pci_driver hpsa_pci_driver = { - .name = "hpsa", + .name = HPSA, .probe = hpsa_init_one, .remove = __devexit_p(hpsa_remove_one), .id_table = hpsa_pci_device_id, /* id_table */ diff --git a/drivers/scsi/hpsa.h b/drivers/scsi/hpsa.h index b4b97eb..7b28d54 100644 --- a/drivers/scsi/hpsa.h +++ b/drivers/scsi/hpsa.h @@ -316,7 +316,7 @@ static unsigned long SA5_completed(struct ctlr_info *h) dev_dbg(&h->pdev->dev, "Read %lx back from board\n", register_value); else - dev_dbg(&h->pdev->dev, "hpsa: FIFO Empty read\n"); + dev_dbg(&h->pdev->dev, "FIFO Empty read\n"); #endif return register_value; |