diff options
Diffstat (limited to 'drivers')
-rw-r--r-- | drivers/scsi/NCR5380.c | 131 | ||||
-rw-r--r-- | drivers/scsi/sun3_scsi.c | 8 |
2 files changed, 124 insertions, 15 deletions
diff --git a/drivers/scsi/NCR5380.c b/drivers/scsi/NCR5380.c index 859b32f..a59b71f 100644 --- a/drivers/scsi/NCR5380.c +++ b/drivers/scsi/NCR5380.c @@ -31,6 +31,8 @@ /* Ported to Atari by Roman Hodek and others. */ +/* Adapted for the Sun 3 by Sam Creasey. */ + /* * Further development / testing that should be done : * @@ -858,6 +860,23 @@ static void NCR5380_dma_complete(struct Scsi_Host *instance) } } +#ifdef CONFIG_SUN3 + if ((sun3scsi_dma_finish(rq_data_dir(hostdata->connected->request)))) { + pr_err("scsi%d: overrun in UDC counter -- not prepared to deal with this!\n", + instance->host_no); + BUG(); + } + + if ((NCR5380_read(BUS_AND_STATUS_REG) & (BASR_PHASE_MATCH | BASR_ACK)) == + (BASR_PHASE_MATCH | BASR_ACK)) { + pr_err("scsi%d: BASR %02x\n", instance->host_no, + NCR5380_read(BUS_AND_STATUS_REG)); + pr_err("scsi%d: bus stuck in data phase -- probably a single byte overrun!\n", + instance->host_no); + BUG(); + } +#endif + NCR5380_write(MODE_REG, MR_BASE); NCR5380_write(INITIATOR_COMMAND_REG, ICR_BASE); NCR5380_read(RESET_PARITY_INTERRUPT_REG); @@ -981,10 +1000,16 @@ static irqreturn_t NCR5380_intr(int irq, void *dev_id) NCR5380_read(RESET_PARITY_INTERRUPT_REG); dsprintk(NDEBUG_INTR, instance, "unknown interrupt\n"); +#ifdef SUN3_SCSI_VME + dregs->csr |= CSR_DMA_ENABLE; +#endif } handled = 1; } else { shost_printk(KERN_NOTICE, instance, "interrupt without IRQ bit\n"); +#ifdef SUN3_SCSI_VME + dregs->csr |= CSR_DMA_ENABLE; +#endif } spin_unlock_irqrestore(&hostdata->lock, flags); @@ -1274,6 +1299,10 @@ static struct scsi_cmnd *NCR5380_select(struct Scsi_Host *instance, hostdata->connected = cmd; hostdata->busy[cmd->device->id] |= 1 << cmd->device->lun; +#ifdef SUN3_SCSI_VME + dregs->csr |= CSR_INTR; +#endif + initialize_SCp(cmd); cmd = NULL; @@ -1557,6 +1586,11 @@ static int NCR5380_transfer_dma(struct Scsi_Host *instance, dsprintk(NDEBUG_DMA, instance, "initializing DMA %s: length %d, address %p\n", (p & SR_IO) ? "receive" : "send", c, d); +#ifdef CONFIG_SUN3 + /* send start chain */ + sun3scsi_dma_start(c, *data); +#endif + NCR5380_write(TARGET_COMMAND_REG, PHASE_SR_TO_TCR(p)); NCR5380_write(MODE_REG, MR_BASE | MR_DMA_MODE | MR_MONITOR_BSY | MR_ENABLE_EOP_INTR); @@ -1577,6 +1611,7 @@ static int NCR5380_transfer_dma(struct Scsi_Host *instance, */ if (p & SR_IO) { + NCR5380_write(INITIATOR_COMMAND_REG, ICR_BASE); NCR5380_io_delay(1); NCR5380_write(START_DMA_INITIATOR_RECEIVE_REG, 0); } else { @@ -1587,6 +1622,13 @@ static int NCR5380_transfer_dma(struct Scsi_Host *instance, NCR5380_io_delay(1); } +#ifdef CONFIG_SUN3 +#ifdef SUN3_SCSI_VME + dregs->csr |= CSR_DMA_ENABLE; +#endif + sun3_dma_active = 1; +#endif + if (hostdata->flags & FLAG_LATE_DMA_SETUP) { /* On the Falcon, the DMA setup must be done after the last * NCR access, else the DMA setup gets trashed! @@ -1718,6 +1760,10 @@ static void NCR5380_information_transfer(struct Scsi_Host *instance) unsigned char phase, tmp, extended_msg[10], old_phase = 0xff; struct scsi_cmnd *cmd; +#ifdef SUN3_SCSI_VME + dregs->csr |= CSR_INTR; +#endif + while ((cmd = hostdata->connected)) { struct NCR5380_cmd *ncmd = scsi_cmd_priv(cmd); @@ -1729,6 +1775,31 @@ static void NCR5380_information_transfer(struct Scsi_Host *instance) old_phase = phase; NCR5380_dprint_phase(NDEBUG_INFORMATION, instance); } +#ifdef CONFIG_SUN3 + if (phase == PHASE_CMDOUT) { + void *d; + unsigned long count; + + if (!cmd->SCp.this_residual && cmd->SCp.buffers_residual) { + count = cmd->SCp.buffer->length; + d = sg_virt(cmd->SCp.buffer); + } else { + count = cmd->SCp.this_residual; + d = cmd->SCp.ptr; + } + + if (sun3_dma_setup_done != cmd && + sun3scsi_dma_xfer_len(count, cmd) > 0) { + sun3scsi_dma_setup(instance, d, count, + rq_data_dir(cmd->request)); + sun3_dma_setup_done = cmd; + } +#ifdef SUN3_SCSI_VME + dregs->csr |= CSR_INTR; +#endif + } +#endif /* CONFIG_SUN3 */ + if (sink && (phase != PHASE_MSGOUT)) { NCR5380_write(TARGET_COMMAND_REG, PHASE_SR_TO_TCR(tmp)); @@ -1811,6 +1882,10 @@ static void NCR5380_information_transfer(struct Scsi_Host *instance) (unsigned char **)&cmd->SCp.ptr); cmd->SCp.this_residual -= transfersize - len; } +#ifdef CONFIG_SUN3 + if (sun3_dma_setup_done == cmd) + sun3_dma_setup_done = NULL; +#endif return; case PHASE_MSGIN: len = 1; @@ -1889,6 +1964,9 @@ static void NCR5380_information_transfer(struct Scsi_Host *instance) /* Enable reselect interrupts */ NCR5380_write(SELECT_ENABLE_REG, hostdata->id_mask); +#ifdef SUN3_SCSI_VME + dregs->csr |= CSR_DMA_ENABLE; +#endif return; /* * The SCSI data pointer is *IMPLICITLY* saved on a disconnect @@ -2040,10 +2118,8 @@ static void NCR5380_reselect(struct Scsi_Host *instance) { struct NCR5380_hostdata *hostdata = shost_priv(instance); unsigned char target_mask; - unsigned char lun, phase; - int len; + unsigned char lun; unsigned char msg[3]; - unsigned char *data; struct NCR5380_cmd *ncmd; struct scsi_cmnd *tmp; @@ -2085,15 +2161,26 @@ static void NCR5380_reselect(struct Scsi_Host *instance) return; } - len = 1; - data = msg; - phase = PHASE_MSGIN; - NCR5380_transfer_pio(instance, &phase, &len, &data); +#ifdef CONFIG_SUN3 + /* acknowledge toggle to MSGIN */ + NCR5380_write(TARGET_COMMAND_REG, PHASE_SR_TO_TCR(PHASE_MSGIN)); - if (len) { - do_abort(instance); - return; + /* peek at the byte without really hitting the bus */ + msg[0] = NCR5380_read(CURRENT_SCSI_DATA_REG); +#else + { + int len = 1; + unsigned char *data = msg; + unsigned char phase = PHASE_MSGIN; + + NCR5380_transfer_pio(instance, &phase, &len, &data); + + if (len) { + do_abort(instance); + return; + } } +#endif /* CONFIG_SUN3 */ if (!(msg[0] & 0x80)) { shost_printk(KERN_ERR, instance, "expecting IDENTIFY message, got "); @@ -2141,6 +2228,30 @@ static void NCR5380_reselect(struct Scsi_Host *instance) return; } +#ifdef CONFIG_SUN3 + { + void *d; + unsigned long count; + + if (!tmp->SCp.this_residual && tmp->SCp.buffers_residual) { + count = tmp->SCp.buffer->length; + d = sg_virt(tmp->SCp.buffer); + } else { + count = tmp->SCp.this_residual; + d = tmp->SCp.ptr; + } + + if (sun3_dma_setup_done != tmp && + sun3scsi_dma_xfer_len(count, tmp) > 0) { + sun3scsi_dma_setup(instance, d, count, + rq_data_dir(tmp->request)); + sun3_dma_setup_done = tmp; + } + } + + NCR5380_write(INITIATOR_COMMAND_REG, ICR_BASE | ICR_ASSERT_ACK); +#endif /* CONFIG_SUN3 */ + /* Accept message by clearing ACK */ NCR5380_write(INITIATOR_COMMAND_REG, ICR_BASE); diff --git a/drivers/scsi/sun3_scsi.c b/drivers/scsi/sun3_scsi.c index fd4fad8..f2fc788 100644 --- a/drivers/scsi/sun3_scsi.c +++ b/drivers/scsi/sun3_scsi.c @@ -54,10 +54,8 @@ #define NCR5380_abort sun3scsi_abort #define NCR5380_info sun3scsi_info -#define NCR5380_dma_read_setup(instance, data, count) \ - sun3scsi_dma_setup(instance, data, count, 0) -#define NCR5380_dma_write_setup(instance, data, count) \ - sun3scsi_dma_setup(instance, data, count, 1) +#define NCR5380_dma_recv_setup(instance, data, count) (count) +#define NCR5380_dma_send_setup(instance, data, count) (count) #define NCR5380_dma_residual(instance) \ sun3scsi_dma_residual(instance) #define NCR5380_dma_xfer_len(instance, cmd, phase) \ @@ -406,7 +404,7 @@ static int sun3scsi_dma_finish(int write_flag) } -#include "atari_NCR5380.c" +#include "NCR5380.c" #ifdef SUN3_SCSI_VME #define SUN3_SCSI_NAME "Sun3 NCR5380 VME SCSI" |