summaryrefslogtreecommitdiff
AgeCommit message (Expand)Author
2008-01-28[ARM] 4762/1: Basic support for Toradex Colibri moduleDaniel Mack
2008-01-28[ARM] pxa: fix mci_init functions returning -1Russell King
2008-01-28[ARM] 4737/1: Refactor corgi_lcd to improve readability + bugfixRichard Purdie
2008-01-28[ARM] 4747/1: pcm027: support for pcm990 baseboard for phyCORE-PXA270Robert Schwebel
2008-01-28[ARM] 4746/1: pcm027: network support for phyCORE-PXA270Robert Schwebel
2008-01-28[ARM] 4745/1: pcm027: default configurationRobert Schwebel
2008-01-28[ARM] 4744/1: pcm027: add support for phyCORE-PXA270 CPU moduleRobert Schwebel
2008-01-28[NET] smc91x: Make smc91x use IRQ resource trigger flagsRussell King
2008-01-28[ARM] pxa: add default config for littletoneric miao
2008-01-28[ARM] pxa: add basic support for Littleton (PXA3xx Form Factor Platform)eric miao
2008-01-28[ARM] 4664/1: Add basic support for HTC Magician PDA phonesPhilipp Zabel
2008-01-28[ARM] 4649/1: Base support for pxa-based Toshiba e-series PDAs.Ian Molton
2008-01-26[ARM] pxa: skip registers saving/restoring if entering standby modeeric miao
2008-01-26[ARM] pxa: fix PXA27x resumeRussell King
2008-01-26[ARM] pxa: Avoid fiddling with CKEN register on suspendRussell King
2008-01-26[ARM] pxa: Add PXA3 standby code hooked into the IRQ wake schemeRussell King
2008-01-26[ARM] pxa: Add zylonite MFP wakeup configurationsRussell King
2008-01-26[ARM] pxa: program MFPs for low power mode when suspendingRussell King
2008-01-26[ARM] pxa: make MFP configuration processor independenteric miao
2008-01-26[ARM] pxa: remove un-used pxa3xx_mfp_set_xxx() functionseric miao
2008-01-26[ARM] pxa: introduce a new file mfp-pxa3xx.h for common pin configurationseric miao
2008-01-26[ARM] pxa: omit PXA25x or PXA27x standby/sleep code as appropriateRussell King
2008-01-26[ARM] pxa: clean up pxa{27x,25x}_init_pm() to empty if CONFIG_PM not definederic miao
2008-01-26[ARM] pxa: move memory controller registers into pxa2xx-regs.hRussell King
2008-01-26[ARM] pxa: increase size of memory mappingRussell King
2008-01-26[ARM] pxa: move pxa27x_device_ohci out of pxa27x.c for use with pxa3xxeric miao
2008-01-26[ARM] USB: update to allow pxa27x ohci driver to support pxa3xxeric miao
2008-01-26[ARM] USB: update pxa27x ohci driver to use clk supporteric miao
2008-01-26[ARM] pxa: make OHCI register definitions available to both pxa27x and pxa3xxeric miao
2008-01-26[ARM] pxa: add clk of CKEN_USBHOST for pxa3xxeric miao
2008-01-26[ARM] pxa: ensure SSP TX FIFO is empty instead of not full for pxa3xxeric miao
2008-01-26[ARM] pxa: mmc: add 3rd host controller support for pxa310Bridge Wu
2008-01-26[ARM] pxa: mmc: add 2nd host controller support for pxa3xxBridge Wu
2008-01-26[ARM] pxa: mmc: add 1st host controller support for pxa3xxBridge Wu
2008-01-26[ARM] pxa: create arch/arm/mach-pxa/device.c for all on-chip deviceseric miao
2008-01-26[ARM] 4718/1: Fix redefinition warnings in PXA uncompressor codePhilipp Zabel
2008-01-26[ARM] 4711/1: pxa: mmc: move DMA specific code to platform layerBridge Wu
2008-01-26[ARM] 4709/1: pxa: mmc: add 26MHz support for pxa3[0|1]0 mmc controllerBridge Wu
2008-01-26[ARM] pxa: add cpufreq supportRussell King
2008-01-26[ARM] pxa: initialise SSP earlierRussell King
2008-01-26[ARM] pxa: only register "cpld_irq" for the correct platformRussell King
2008-01-26[ARM] pxa: make pxa2xx_spi driver use ssp_request()/ssp_free()eric miao
2008-01-26[ARM] pxa: use __raw_writel()/__raw_readl() for ssp_xxxx()eric miao
2008-01-26[ARM] pxa: move SSP register definitions from pxa-regs.h to regs-ssp.heric miao
2008-01-26[ARM] pxa: define "struct ssp_device" and add ssp_request()/ssp_free()eric miao
2008-01-26[ARM] pxa: add ssp devices and clk support for pxa25x/pxa27x/pxa3xxeric miao
2008-01-26[ARM] pxa: define SSP platform devices for pxa2xx/pxa3xxeric miao
2008-01-26[ARM] 4663/1: Only putc uncompressor output into FFUART if it was enabled by ...Philipp Zabel
2008-01-26[ARM] pxa/sa1100: replace wakeup supportRussell King
2008-01-26[ARM] pxa: Don't wind OSCR backwards over suspend/resumeRussell King