arm: ls1043ardb: Add SD secure boot target

- Add SD secure boot target for ls1043ardb.
- Implement FSL_LSCH2 specific spl_board_init() to setup CAAM stream
  ID and corresponding stream ID in SMMU.
- Change the u-boot size defined by a macro for copying the main
  U-Boot by SPL to also include the u-boot Secure Boot header size as
  header is appended to u-boot image. So header will also be copied
  from SD to DDR.
- CONFIG_MAX_SPL_SIZE is limited to 90KB. SPL is copied to OCRAM
  (128K) where 32K are reserved for use by boot ROM and 6K for secure
  boto header.
- Error messages during SPL boot are limited to error code numbers
  instead of strings to reduce the size of SPL image.

Signed-off-by: Vinitha Pillai-B57223 <vinitha.pillai@nxp.com>
Signed-off-by: Sumit Garg <sumit.garg@nxp.com>
Signed-off-by: Ruchika Gupta <ruchika.gupta@nxp.com>
Reviewed-by: York Sun <york.sun@nxp.com>

1 files changed, 18 insertions, 0 deletions

diff --git a/arch/arm/cpu/armv8/fsl-layerscape/spl.c b/arch/arm/cpu/armv8/fsl-layerscape/spl.c
index 73a8680..dfacf98 100644
--- a/arch/arm/cpu/armv8/fsl-layerscape/spl.c
+++ b/arch/arm/cpu/armv8/fsl-layerscape/spl.c
@@ -41,6 +41,24 @@ u32 spl_boot_mode(const u32 boot_device)
 }
 
 #ifdef CONFIG_SPL_BUILD
+
+void spl_board_init(void)
+{
+#if defined(CONFIG_SECURE_BOOT) && defined(CONFIG_FSL_LSCH2)
+	/*
+	 * In case of Secure Boot, the IBR configures the SMMU
+	 * to allow only Secure transactions.
+	 * SMMU must be reset in bypass mode.
+	 * Set the ClientPD bit and Clear the USFCFG Bit
+	*/
+	u32 val;
+	val = (in_le32(SMMU_SCR0) | SCR0_CLIENTPD_MASK) & ~(SCR0_USFCFG_MASK);
+	out_le32(SMMU_SCR0, val);
+	val = (in_le32(SMMU_NSCR0) | SCR0_CLIENTPD_MASK) & ~(SCR0_USFCFG_MASK);
+	out_le32(SMMU_NSCR0, val);
+#endif
+}
+
 void board_init_f(ulong dummy)
 {
 	/* Clear global data */