[PPC440SPe] Improve PCIe configuration space access

- correct configuration space mapping
- correct bus numbering
- better access to config space

Prior to this patch, the 440SPe host/PCIe bridge was able to configure only the
first device on the first bus. We now allow to configure up to 16 buses;
also, scanning for devices behind the PCIe-PCIe bridge is supported, so
peripheral devices farther in hierarchy can be identified.

Signed-off-by: Grzegorz Bernacki <gjb@semihalf.com>

1 files changed, 5 insertions, 4 deletions

diff --git a/board/amcc/katmai/katmai.c b/board/amcc/katmai/katmai.c
index b804d55..a9ae4a3 100644
--- a/board/amcc/katmai/katmai.c
+++ b/board/amcc/katmai/katmai.c
@@ -392,7 +392,7 @@ int katmai_pcie_card_present(int port)
 
 static struct pci_controller pcie_hose[3] = {{0},{0},{0}};
 
-void pcie_setup_hoses(void)
+void pcie_setup_hoses(int busno)
 {
 	struct pci_controller *hose;
 	int i, bus;
@@ -401,7 +401,7 @@ void pcie_setup_hoses(void)
 	 * assume we're called after the PCIX hose is initialized, which takes
 	 * bus ID 0 and therefore start numbering PCIe's from 1.
 	 */
-	bus = 1;
+	bus = busno;
 	for (i = 0; i <= 2; i++) {
 		/* Check for katmai card presence */
 		if (!katmai_pcie_card_present(i))
@@ -418,8 +418,8 @@ void pcie_setup_hoses(void)
 
 		hose = &pcie_hose[i];
 		hose->first_busno = bus;
-		hose->last_busno  = bus;
-		bus++;
+		hose->last_busno = bus;
+		hose->current_busno = bus;
 
 		/* setup mem resource */
 		pci_set_region(hose->regions + 0,
@@ -443,6 +443,7 @@ void pcie_setup_hoses(void)
 		 * Config access can only go down stream
 		 */
 		hose->last_busno = pci_hose_scan(hose);
+		bus = hose->last_busno + 1;
 #endif
 	}
 }