summaryrefslogtreecommitdiff
path: root/doc
diff options
context:
space:
mode:
authorTom Rini <trini@konsulko.com>2016-01-03 15:32:24 (GMT)
committerTom Rini <trini@konsulko.com>2016-01-03 15:32:24 (GMT)
commitf1993ca066100fcaba7d49fecae0ef604e5807e2 (patch)
tree5439c5cdd14b34ff2085b4876472a44349c15843 /doc
parentd83c25c318564080ce647795e5ee49133b97e87d (diff)
parentccf4326bac0371774265be0a8b13c150b445e703 (diff)
downloadu-boot-f1993ca066100fcaba7d49fecae0ef604e5807e2.tar.xz
Merge branch 'master' of git://www.denx.de/git/u-boot-imx
Diffstat (limited to 'doc')
-rw-r--r--doc/README.imx651
1 files changed, 51 insertions, 0 deletions
diff --git a/doc/README.imx6 b/doc/README.imx6
index 437af2f..e26ab71 100644
--- a/doc/README.imx6
+++ b/doc/README.imx6
@@ -84,3 +84,54 @@ Address:
Reading bank 4:
Word 0x00000002: 9f027772 00000004
+
+2. Using imx_usb_loader for first install with SPL
+--------------------------------------------------
+
+imx_usb_loader is a very nice tool by BoundaryDevice that
+allow to install U-Boot without a JTAG debugger, using
+the USB boot mode as described in the manual. It is
+a replacement for Freescale's MFGTOOLS.
+
+The sources can be found here:
+
+ https://github.com/boundarydevices/imx_usb_loader.git
+
+Booting in USB mode, the i.MX6 announces itself to the Linux Host as:
+
+Bus 001 Device 111: ID 15a2:0061 Freescale Semiconductor, Inc.
+
+imx_usb_loader is able to download a single file (u-boot.imx)
+to the board. For boards without SPL support, it is enough to
+issue the command:
+
+ sudo ../imx_usb_loader/imx_usb -v u-boot.imx
+
+Getting U-Boot when SPL support is active, it requires
+two downloads. imx_usb_loader downloads the SPL into
+OCRAM and starts it. SPL will check for a valid u-boot.img, and
+because it is not found, it will wait for it using the y-modem
+protocol via the console.
+
+A first install is then possible by combining imx_usb_loader with
+another tool such as kermit.
+
+sudo ../imx_usb_loader/imx_usb -v SPL
+kermit kermit_uboot
+
+and kermit_uboot contains something like this (set line should be adjusted):
+
+set line /dev/ttyUSB1
+set speed 115200
+SET CARRIER-WATCH OFF
+set flow-control none
+set handshake none
+set prefixing all
+set file type bin
+set protocol ymodem
+send u-boot.img
+c
+
+The last "c" command tells kermit (from ckermit package in most distros)
+to switch from command line mode to communication mode, and when the
+script is finished, the U-Boot prompt is shown in the same shell.