summaryrefslogtreecommitdiff
diff options
context:
space:
mode:
-rw-r--r--boards.cfg5
-rw-r--r--doc/README.SPL12
-rwxr-xr-xmkconfig15
3 files changed, 31 insertions, 1 deletions
diff --git a/boards.cfg b/boards.cfg
index 0598763..becf258 100644
--- a/boards.cfg
+++ b/boards.cfg
@@ -11,6 +11,11 @@
# Lines starting with '#' are comments.
# Blank lines are ignored.
#
+# The CPU field takes the form:
+# cpu[:spl_cpu]
+# If spl_cpu is specified the make variable CPU will be set to this
+# during the SPL build.
+#
# The options field takes the form:
# <board config name>[:comma separated config options]
# Each config option has the form (value defaults to "1"):
diff --git a/doc/README.SPL b/doc/README.SPL
index 0276953..e4a5ac3 100644
--- a/doc/README.SPL
+++ b/doc/README.SPL
@@ -66,3 +66,15 @@ CONFIG_SPL_DMA_SUPPORT (drivers/dma/libdma.o)
CONFIG_SPL_POST_MEM_SUPPORT (post/drivers/memory.o)
CONFIG_SPL_NAND_LOAD (drivers/mtd/nand/nand_spl_load.o)
CONFIG_SPL_SPI_LOAD (drivers/mtd/spi/spi_spl_load.o)
+
+
+Normally CPU is assumed to be the same between the SPL and normal
+u-boot build. However it is possible to specify a different CPU for
+the SPL build for cases where the SPL is expected to run on a
+different CPU model from the main u-boot. This is done by specifying
+an SPL CPU in boards.cfg as follows:
+
+ normal_cpu:spl_cpu
+
+This this case CPU will be set to "normal_cpu" during the main u-boot
+build and "spl_cpu" during the SPL build.
diff --git a/mkconfig b/mkconfig
index 801f921..9e1a7e6 100755
--- a/mkconfig
+++ b/mkconfig
@@ -60,6 +60,11 @@ CONFIG_NAME="${1%_config}"
arch="$2"
cpu="$3"
+tmp="${cpu#*:}"
+if [ "$tmp" != "$cpu" ] ; then
+ spl_cpu=$tmp
+ cpu="${cpu%:*}"
+fi
if [ "$4" = "-" ] ; then
board=${BOARD_NAME}
else
@@ -131,7 +136,15 @@ fi
# Create include file for Make
#
echo "ARCH = ${arch}" > config.mk
-echo "CPU = ${cpu}" >> config.mk
+if [ ! -z "$spl_cpu" ] ; then
+ echo 'ifeq ($(CONFIG_SPL_BUILD),y)' >> config.mk
+ echo "CPU = ${spl_cpu}" >> config.mk
+ echo "else" >> config.mk
+ echo "CPU = ${cpu}" >> config.mk
+ echo "endif" >> config.mk
+else
+ echo "CPU = ${cpu}" >> config.mk
+fi
echo "BOARD = ${board}" >> config.mk
[ "${vendor}" ] && echo "VENDOR = ${vendor}" >> config.mk