summaryrefslogtreecommitdiff
diff options
context:
space:
mode:
-rw-r--r--doc/SPI/README.sh_qspi_test38
-rw-r--r--drivers/spi/Makefile1
-rw-r--r--drivers/spi/sh_qspi.c277
3 files changed, 316 insertions, 0 deletions
diff --git a/doc/SPI/README.sh_qspi_test b/doc/SPI/README.sh_qspi_test
new file mode 100644
index 0000000..8a33fec
--- /dev/null
+++ b/doc/SPI/README.sh_qspi_test
@@ -0,0 +1,38 @@
+-------------------------------------------------
+ Simple steps used to test the SH-QSPI at U-Boot
+-------------------------------------------------
+
+#0, Currently, SH-QSPI is used by lager board (Renesas ARM SoC R8A7790)
+ and koelsch board (Renesas ARM SoC R8A7791). These boot from SPI ROM
+ basically. Thus, U-Boot start, SH-QSPI will is operating normally.
+
+#1, build U-Boot and load u-boot.bin
+
+ => tftpboot 40000000 u-boot.bin
+ sh_eth Waiting for PHY auto negotiation to complete.. done
+ sh_eth: 100Base/Half
+ Using sh_eth device
+ TFTP from server 192.168.169.1; our IP address is 192.168.169.79
+ Filename 'u-boot.bin'.
+ Load address: 0x40000000
+ Loading: ############
+ 2.5 MiB/s
+ done
+ Bytes transferred = 175364 (2ad04 hex)
+
+#2, Commands to erase/write u-boot to flash device
+
+ Note: This method is description of the lager board. If you want to use the
+ other boards, please change the value according to each environment.
+
+ => sf probe 0
+ SF: Detected S25FL512S_256K with page size 512 Bytes, erase size 64 KiB, total 64 MiB
+ => sf erase 80000 40000
+ SF: 262144 bytes @ 0x80000 Erased: OK
+ => sf write 40000000 80000 175364
+ SF: 1528676 bytes @ 0x80000 Written: OK
+ =>
+
+#3, Push reset button.
+
+ If you're written correctly and driver works properly, U-Boot starts.
diff --git a/drivers/spi/Makefile b/drivers/spi/Makefile
index ed4ecd7..d5a7143 100644
--- a/drivers/spi/Makefile
+++ b/drivers/spi/Makefile
@@ -30,6 +30,7 @@ obj-$(CONFIG_OMAP3_SPI) += omap3_spi.o
obj-$(CONFIG_SANDBOX_SPI) += sandbox_spi.o
obj-$(CONFIG_SOFT_SPI) += soft_spi.o
obj-$(CONFIG_SH_SPI) += sh_spi.o
+obj-$(CONFIG_SH_QSPI) += sh_qspi.o
obj-$(CONFIG_FSL_ESPI) += fsl_espi.o
obj-$(CONFIG_FDT_SPI) += fdt_spi.o
obj-$(CONFIG_TEGRA20_SFLASH) += tegra20_sflash.o
diff --git a/drivers/spi/sh_qspi.c b/drivers/spi/sh_qspi.c
new file mode 100644
index 0000000..edeb42d
--- /dev/null
+++ b/drivers/spi/sh_qspi.c
@@ -0,0 +1,277 @@
+/*
+ * SH QSPI (Quad SPI) driver
+ *
+ * Copyright (C) 2013 Renesas Electronics Corporation
+ * Copyright (C) 2013 Nobuhiro Iwamatsu <nobuhiro.iwamatsu.yj@renesas.com>
+ *
+ * SPDX-License-Identifier: GPL-2.0
+ */
+
+#include <common.h>
+#include <malloc.h>
+#include <spi.h>
+#include <asm/io.h>
+
+/* SH QSPI register bit masks <REG>_<BIT> */
+#define SPCR_MSTR 0x08
+#define SPCR_SPE 0x40
+#define SPSR_SPRFF 0x80
+#define SPSR_SPTEF 0x20
+#define SPPCR_IO3FV 0x04
+#define SPPCR_IO2FV 0x02
+#define SPPCR_IO1FV 0x01
+#define SPBDCR_RXBC0 (1 << 0)
+#define SPCMD_SCKDEN (1 << 15)
+#define SPCMD_SLNDEN (1 << 14)
+#define SPCMD_SPNDEN (1 << 13)
+#define SPCMD_SSLKP (1 << 7)
+#define SPCMD_BRDV0 (1 << 2)
+#define SPCMD_INIT1 SPCMD_SCKDEN | SPCMD_SLNDEN | \
+ SPCMD_SPNDEN | SPCMD_SSLKP | \
+ SPCMD_BRDV0
+#define SPCMD_INIT2 SPCMD_SPNDEN | SPCMD_SSLKP | \
+ SPCMD_BRDV0
+#define SPBFCR_TXRST (1 << 7)
+#define SPBFCR_RXRST (1 << 6)
+
+/* SH QSPI register set */
+struct sh_qspi_regs {
+ unsigned char spcr;
+ unsigned char sslp;
+ unsigned char sppcr;
+ unsigned char spsr;
+ unsigned long spdr;
+ unsigned char spscr;
+ unsigned char spssr;
+ unsigned char spbr;
+ unsigned char spdcr;
+ unsigned char spckd;
+ unsigned char sslnd;
+ unsigned char spnd;
+ unsigned char dummy0;
+ unsigned short spcmd0;
+ unsigned short spcmd1;
+ unsigned short spcmd2;
+ unsigned short spcmd3;
+ unsigned char spbfcr;
+ unsigned char dummy1;
+ unsigned short spbdcr;
+ unsigned long spbmul0;
+ unsigned long spbmul1;
+ unsigned long spbmul2;
+ unsigned long spbmul3;
+};
+
+struct sh_qspi_slave {
+ struct spi_slave slave;
+ struct sh_qspi_regs *regs;
+};
+
+static inline struct sh_qspi_slave *to_sh_qspi(struct spi_slave *slave)
+{
+ return container_of(slave, struct sh_qspi_slave, slave);
+}
+
+static void sh_qspi_init(struct sh_qspi_slave *ss)
+{
+ /* QSPI initialize */
+ /* Set master mode only */
+ writeb(SPCR_MSTR, &ss->regs->spcr);
+
+ /* Set SSL signal level */
+ writeb(0x00, &ss->regs->sslp);
+
+ /* Set MOSI signal value when transfer is in idle state */
+ writeb(SPPCR_IO3FV|SPPCR_IO2FV, &ss->regs->sppcr);
+
+ /* Set bit rate. See 58.3.8 Quad Serial Peripheral Interface */
+ writeb(0x01, &ss->regs->spbr);
+
+ /* Disable Dummy Data Transmission */
+ writeb(0x00, &ss->regs->spdcr);
+
+ /* Set clock delay value */
+ writeb(0x00, &ss->regs->spckd);
+
+ /* Set SSL negation delay value */
+ writeb(0x00, &ss->regs->sslnd);
+
+ /* Set next-access delay value */
+ writeb(0x00, &ss->regs->spnd);
+
+ /* Set equence command */
+ writew(SPCMD_INIT2, &ss->regs->spcmd0);
+
+ /* Reset transfer and receive Buffer */
+ setbits_8(&ss->regs->spbfcr, SPBFCR_TXRST|SPBFCR_RXRST);
+
+ /* Clear transfer and receive Buffer control bit */
+ clrbits_8(&ss->regs->spbfcr, SPBFCR_TXRST|SPBFCR_RXRST);
+
+ /* Set equence control method. Use equence0 only */
+ writeb(0x00, &ss->regs->spscr);
+
+ /* Enable SPI function */
+ setbits_8(&ss->regs->spcr, SPCR_SPE);
+}
+
+int spi_cs_is_valid(unsigned int bus, unsigned int cs)
+{
+ return 1;
+}
+
+void spi_cs_activate(struct spi_slave *slave)
+{
+ struct sh_qspi_slave *ss = to_sh_qspi(slave);
+
+ /* Set master mode only */
+ writeb(SPCR_MSTR, &ss->regs->spcr);
+
+ /* Set command */
+ writew(SPCMD_INIT1, &ss->regs->spcmd0);
+
+ /* Reset transfer and receive Buffer */
+ setbits_8(&ss->regs->spbfcr, SPBFCR_TXRST|SPBFCR_RXRST);
+
+ /* Clear transfer and receive Buffer control bit */
+ clrbits_8(&ss->regs->spbfcr, SPBFCR_TXRST|SPBFCR_RXRST);
+
+ /* Set equence control method. Use equence0 only */
+ writeb(0x00, &ss->regs->spscr);
+
+ /* Enable SPI function */
+ setbits_8(&ss->regs->spcr, SPCR_SPE);
+}
+
+void spi_cs_deactivate(struct spi_slave *slave)
+{
+ struct sh_qspi_slave *ss = to_sh_qspi(slave);
+
+ /* Disable SPI Function */
+ clrbits_8(&ss->regs->spcr, SPCR_SPE);
+}
+
+void spi_init(void)
+{
+ /* nothing to do */
+}
+
+struct spi_slave *spi_setup_slave(unsigned int bus, unsigned int cs,
+ unsigned int max_hz, unsigned int mode)
+{
+ struct sh_qspi_slave *ss;
+
+ if (!spi_cs_is_valid(bus, cs))
+ return NULL;
+
+ ss = spi_alloc_slave(struct sh_qspi_slave, bus, cs);
+ if (!ss) {
+ printf("SPI_error: Fail to allocate sh_qspi_slave\n");
+ return NULL;
+ }
+
+ ss->regs = (struct sh_qspi_regs *)CONFIG_SH_QSPI_BASE;
+
+ /* Init SH QSPI */
+ sh_qspi_init(ss);
+
+ return &ss->slave;
+}
+
+void spi_free_slave(struct spi_slave *slave)
+{
+ struct sh_qspi_slave *spi = to_sh_qspi(slave);
+
+ free(spi);
+}
+
+int spi_claim_bus(struct spi_slave *slave)
+{
+ return 0;
+}
+
+void spi_release_bus(struct spi_slave *slave)
+{
+}
+
+int spi_xfer(struct spi_slave *slave, unsigned int bitlen, const void *dout,
+ void *din, unsigned long flags)
+{
+ struct sh_qspi_slave *ss = to_sh_qspi(slave);
+ unsigned long nbyte;
+ int ret = 0;
+ unsigned char dtdata = 0, drdata;
+ unsigned char *tdata = &dtdata, *rdata = &drdata;
+ unsigned long *spbmul0 = &ss->regs->spbmul0;
+
+ if (dout == NULL && din == NULL) {
+ if (flags & SPI_XFER_END)
+ spi_cs_deactivate(slave);
+ return 0;
+ }
+
+ if (bitlen % 8) {
+ printf("%s: bitlen is not 8bit alined %d", __func__, bitlen);
+ return 1;
+ }
+
+ nbyte = bitlen / 8;
+
+ if (flags & SPI_XFER_BEGIN) {
+ spi_cs_activate(slave);
+
+ /* Set 1048576 byte */
+ writel(0x100000, spbmul0);
+ }
+
+ if (flags & SPI_XFER_END)
+ writel(nbyte, spbmul0);
+
+ if (dout != NULL)
+ tdata = (unsigned char *)dout;
+
+ if (din != NULL)
+ rdata = din;
+
+ while (nbyte > 0) {
+ while (!(readb(&ss->regs->spsr) & SPSR_SPTEF)) {
+ if (ctrlc()) {
+ puts("abort\n");
+ return 1;
+ }
+ udelay(10);
+ }
+
+ writeb(*tdata, (unsigned char *)(&ss->regs->spdr));
+
+ while ((readw(&ss->regs->spbdcr) != SPBDCR_RXBC0)) {
+ if (ctrlc()) {
+ puts("abort\n");
+ return 1;
+ }
+ udelay(1);
+ }
+
+ while (!(readb(&ss->regs->spsr) & SPSR_SPRFF)) {
+ if (ctrlc()) {
+ puts("abort\n");
+ return 1;
+ }
+ udelay(10);
+ }
+
+ *rdata = readb((unsigned char *)(&ss->regs->spdr));
+
+ if (dout != NULL)
+ tdata++;
+ if (din != NULL)
+ rdata++;
+
+ nbyte--;
+ }
+
+ if (flags & SPI_XFER_END)
+ spi_cs_deactivate(slave);
+
+ return ret;
+}