summaryrefslogtreecommitdiff
path: root/board
diff options
context:
space:
mode:
Diffstat (limited to 'board')
-rw-r--r--board/esd/cpci750/cpci750.c12
-rw-r--r--board/esd/cpci750/sdram_init.c151
2 files changed, 156 insertions, 7 deletions
diff --git a/board/esd/cpci750/cpci750.c b/board/esd/cpci750/cpci750.c
index 2ae4cbd..a199d46 100644
--- a/board/esd/cpci750/cpci750.c
+++ b/board/esd/cpci750/cpci750.c
@@ -1090,3 +1090,15 @@ U_BOOT_CMD(
"Show Marvell strapping register",
"Show Marvell strapping register (ResetSampleLow ResetSampleHigh)"
);
+
+int do_pldver(cmd_tbl_t *cmdtp, int flag, int argc, char *argv[])
+{
+ printf("PLD version:0x%02x\n", in_8((void *)CONFIG_SYS_PLD_VER));
+
+ return 0;
+}
+
+U_BOOT_CMD(
+ pldver, 1, 1, do_pldver,
+ "Show PLD version",
+ "Show PLD version)");
diff --git a/board/esd/cpci750/sdram_init.c b/board/esd/cpci750/sdram_init.c
index 4c03630..5347958 100644
--- a/board/esd/cpci750/sdram_init.c
+++ b/board/esd/cpci750/sdram_init.c
@@ -538,14 +538,14 @@ static int check_dimm (uchar slot, AUX_MEM_DIMM_INFO * dimmInfo)
break;
/*------------------------------------------------------------------------------------------------------------------------------*/
-#ifdef CONFIG_ECC
+#ifdef CONFIG_MV64360_ECC
case 11: /* Error Check Type */
dimmInfo->errorCheckType = data[i];
DP (printf
("Error Check Type (0=NONE): %d\n",
dimmInfo->errorCheckType));
break;
-#endif
+#endif /* of ifdef CONFIG_MV64360_ECC */
/*------------------------------------------------------------------------------------------------------------------------------*/
case 12: /* Refresh Interval */
@@ -1254,6 +1254,7 @@ int setup_sdram (AUX_MEM_DIMM_INFO * info)
ulong tmp;
ulong tmp_sdram_mode = 0; /* 0x141c */
ulong tmp_dunit_control_low = 0; /* 0x1404 */
+ uint sdram_config_reg = CONFIG_SYS_SDRAM_CONFIG;
int i;
/* sanity checking */
@@ -1269,7 +1270,6 @@ int setup_sdram (AUX_MEM_DIMM_INFO * info)
DP (printf
("Module is registered, but we do not support registered Modules !!!\n"));
-
/* delay line */
set_dfcdlInit (); /* may be its not needed */
DP (printf ("Delay line set done\n"));
@@ -1281,8 +1281,16 @@ int setup_sdram (AUX_MEM_DIMM_INFO * info)
("\n*** SDRAM_OPERATION 1418: Module still busy ... please wait... ***\n"));
}
+#ifdef CONFIG_MV64360_ECC
+ if ((info->errorCheckType == 0x2) && (CPCI750_ECC_TEST)) {
+ /* DRAM has ECC, so turn it on */
+ sdram_config_reg |= BIT18;
+ DP(printf("Enabling ECC\n"));
+ }
+#endif /* of ifdef CONFIG_MV64360_ECC */
+
/* SDRAM configuration */
- GT_REG_WRITE (SDRAM_CONFIG, 0x58200400);
+ GT_REG_WRITE(SDRAM_CONFIG, sdram_config_reg);
DP (printf ("sdram_conf 0x1400: %08x\n", GTREGREAD (SDRAM_CONFIG)));
/* SDRAM open pages controll keep open as much as I can */
@@ -1598,7 +1606,84 @@ dram_size(long int *base, long int maxsize)
return maxsize;
}
-/* ------------------------------------------------------------------------- */
+#ifdef CONFIG_MV64360_ECC
+/*
+ * mv_dma_is_channel_active:
+ * Checks if a engine is busy.
+ */
+int mv_dma_is_channel_active(int engine)
+{
+ ulong data;
+
+ data = GTREGREAD(MV64360_DMA_CHANNEL0_CONTROL + 4 * engine);
+ if (data & BIT14) /* activity status */
+ return 1;
+
+ return 0;
+}
+
+/*
+ * mv_dma_set_memory_space:
+ * Set a DMA memory window for the DMA's address decoding map.
+ */
+int mv_dma_set_memory_space(ulong mem_space, ulong mem_space_target,
+ ulong mem_space_attr, ulong base_address,
+ ulong size)
+{
+ ulong temp;
+
+ /* The base address must be aligned to the size. */
+ if (base_address % size != 0)
+ return 0;
+
+ if (size >= 0x10000) {
+ size &= 0xffff0000;
+ base_address = (base_address & 0xffff0000);
+ /* Set the new attributes */
+ GT_REG_WRITE(MV64360_DMA_BASE_ADDR_REG0 + mem_space * 8,
+ (base_address | mem_space_target |
+ mem_space_attr));
+ GT_REG_WRITE((MV64360_DMA_SIZE_REG0 + mem_space * 8),
+ (size - 1) & 0xffff0000);
+ temp = GTREGREAD(MV64360_DMA_BASE_ADDR_ENABLE_REG);
+ GT_REG_WRITE(DMA_BASE_ADDR_ENABLE_REG,
+ (temp & ~(BIT0 << mem_space)));
+ return 1;
+ }
+
+ return 0;
+}
+
+
+/*
+ * mv_dma_transfer:
+ * Transfer data from source_addr to dest_addr on one of the 4 DMA channels.
+ */
+int mv_dma_transfer(int engine, ulong source_addr,
+ ulong dest_addr, ulong bytes, ulong command)
+{
+ ulong eng_off_reg; /* Engine Offset Register */
+
+ if (bytes > 0xffff)
+ command = command | BIT31; /* DMA_16M_DESCRIPTOR_MODE */
+
+ command = command | ((command >> 6) & 0x7);
+ eng_off_reg = engine * 4;
+ GT_REG_WRITE(MV64360_DMA_CHANNEL0_BYTE_COUNT + eng_off_reg,
+ bytes);
+ GT_REG_WRITE(MV64360_DMA_CHANNEL0_SOURCE_ADDR + eng_off_reg,
+ source_addr);
+ GT_REG_WRITE(MV64360_DMA_CHANNEL0_DESTINATION_ADDR + eng_off_reg,
+ dest_addr);
+ command |= BIT12 /* DMA_CHANNEL_ENABLE */
+ | BIT9; /* DMA_NON_CHAIN_MODE */
+
+ /* Activate DMA engine By writting to mv_dma_control_register */
+ GT_REG_WRITE(MV64360_DMA_CHANNEL0_CONTROL + eng_off_reg, command);
+
+ return 1;
+}
+#endif /* of ifdef CONFIG_MV64360_ECC */
/* ppcboot interface function to SDRAM init - this is where all the
* controlling logic happens */
@@ -1607,10 +1692,13 @@ initdram(int board_type)
{
int s0 = 0, s1 = 0;
int checkbank[4] = { [0 ... 3] = 0 };
- ulong bank_no, realsize, total, check;
+ ulong realsize, total, check;
AUX_MEM_DIMM_INFO dimmInfo1;
AUX_MEM_DIMM_INFO dimmInfo2;
- int nhr;
+ int bank_no, nhr;
+#ifdef CONFIG_MV64360_ECC
+ ulong dest, mem_space_attr;
+#endif /* of ifdef CONFIG_MV64360_ECC */
/* first, use the SPD to get info about the SDRAM/ DDRRAM */
@@ -1668,6 +1756,28 @@ initdram(int board_type)
realsize = dram_size((long int *)total, check);
memory_map_bank(bank_no, total, realsize);
+#ifdef CONFIG_MV64360_ECC
+ if (((dimmInfo1.errorCheckType != 0) &&
+ ((dimmInfo2.errorCheckType != 0) ||
+ (dimmInfo2.numOfModuleBanks == 0))) &&
+ (CPCI750_ECC_TEST)) {
+ printf("ECC Initialization of Bank %d:", bank_no);
+ mem_space_attr = ((~(BIT0 << bank_no)) & 0xf) << 8;
+ mv_dma_set_memory_space(0, 0, mem_space_attr, total,
+ realsize);
+ for (dest = total; dest < total + realsize;
+ dest += _8M) {
+ mv_dma_transfer(0, total, dest, _8M,
+ BIT8 | /* DMA_DTL_128BYTES */
+ BIT3 | /* DMA_HOLD_SOURCE_ADDR */
+ BIT11); /* DMA_BLOCK_TRANSFER_MODE */
+ while (mv_dma_is_channel_active(0))
+ ;
+ }
+ printf(" PASS\n");
+ }
+#endif /* of ifdef CONFIG_MV64360_ECC */
+
total += realsize;
}
@@ -1700,3 +1810,30 @@ int set_dfcdlInit (void)
return (0);
}
+
+int do_show_ecc(cmd_tbl_t *cmdtp, int flag, int argc, char *argv[])
+{
+ unsigned int ecc_counter;
+ unsigned int ecc_addr;
+
+ GT_REG_READ(0x1458, &ecc_counter);
+ GT_REG_READ(0x1450, &ecc_addr);
+ GT_REG_WRITE(0x1450, 0);
+
+ printf("Error Counter since Reset: %8d\n", ecc_counter);
+ printf("Last error address :0x%08x (" , ecc_addr & 0xfffffff8);
+ if (ecc_addr & 0x01)
+ printf("double");
+ else
+ printf("single");
+ printf(" bit) at DDR-RAM CS#%d\n", ((ecc_addr & 0x6) >> 1));
+
+ return 0;
+}
+
+
+U_BOOT_CMD(
+ show_ecc, 1, 1, do_show_ecc,
+ "Show Marvell MV64360 ECC Info",
+ "Show Marvell MV64360 ECC Counter and last error."
+);